lock TOYOTA iQ EV 2013 Owners Manual (in English)

192. Operation of each component
2
Operation of each component
Smar t key system
Grip the driver’s door handle to
unlock the door. Grip the passen-
ger’s door handle to unlock all the
doors.
Make sure to touch the sensor on
the back of the handle.
The doors cannot be unlocked for
3 seconds after the doors are
locked.
Touch the lock sensor (the inden-
tation on the upper part of the
door handle) to lock all the doors.
Unlocking and locking the doors

202. Operation of each component
Press the unlock button to unlock
all the doors.
Press and hold the button for 1
second to open the back door.
The door cannot be unlocked for 3
seconds after the door is locked.
Lock the back door again when
you leave the vehicle. The back
door will not lock automatically
after it has been opened and then
closed.
Press the lock button to lock all
the doors.
Unlocking and locking the back door

324. What to do if...
Quick charging stops
before it is completed.
The timer of the quick
charger is active.If the battery level is
insufficient, charge the
battery again.
The power of a quick
charger has been turned
off due to unknown rea-
sons.
Turn on the power of the
charger.
If you do not know how
to turn the power on,
contact the administra-
tor of the charger.
The traction battery tem-
perature is extremely
high or low.
Wait for a while and then
attempt charging again.
In extremely high or low
temperature, charging
may not be possible.
An error has occurred
due to the self-check
function of a quick
charger.
The vehicle or the quick
charger may be mal-
functioning. Perform the
operation instructed by
the quick charger’s
manual.
After quick charge is fin-
ished, the EV system
cannot start.
The voltage of the
charging inlet does not
decrease due to the fol-
lowing reasons:
• The EV system is mal-
functioning.
• The battery charger is
malfunctioning.
There may be malfunc-
tions on the vehicle.
Immediately stop charg-
ing and contact your
Scion dealer.
The charging connector
cannot be disconnected
after quick charge fin-
ished.The charging connector
has been locked due to
unknown reasons.Contact the administra-
tor of the charger.
The charging indicator
flashes while charging in
normal charging.
An error has occurred in
the charging system.
If malfunctions occur,
the indicator will flash
for approximately 10
seconds and then turn
off.Turn the power switch to
ON mode and comply
with the warning mes-
sage shown on the
multi-information dis-
play.
SituationReasonCorrection procedure

344. What to do if...
If the electronic key does not operate
properly
To take out the mechanical key,
push the release button and
take the key out.
Use the mechanical key in
order to perform the following
operations:
Locks all the doors
Unlocks all the doors
Turning the key rearward
unlocks the driver’s door. Turn-
ing the key once again within 3
seconds unlocks the other
doors.
Locking and unlocking the doors
1
2
1
2