JAGUAR XFR 2010 1.G Workshop Manual

10.
11.
12. Discard the gaskets.


























NOTE: Do not disassemble further if the component is
removed for access only. www.JagDocs.com

Installation 13.

















14.


1. CAUTION: If a new cylinder head has been installed, then new
taptite bolts must be used to install the supercharger.


NOTE: New taptite bolts when used cut their own threads on the
first application.
To install, reverse the removal procedure.

2. Torque: 25 Nm

3. Torque: 25 Nm 4. Torque: 10 Nm 5.
6.
CAUTIONS:


If a new cylinder head has been installed then
the special tool 303-1449-02 without the thread
must be used to install the supercharger.


If a new cylinder head has been installed, then
new taptite bolts must be used to install the
supercharger.


NOTE: New taptite bolts when used cut their
own threads on the first application.

Special Tool(s): 303-1449-01, 303-1449-02

7. CAUTION: Make sure that the mating faces are clean
and free of foreign material.
Install new gaskets.





















8. CAUTION: Make sure that the mating faces are clean
and free of foreign material.

9.























10.
11. NOTE: Left-hand shown, right-hand similar.

Special Tool(s): 303-1449-01, 303-1449-02 Torque: 25 Nm





















NOTE: Left-hand shown, right-hand similar.

Torque: 25 Nm

Engine Controls - V8 S/C 5.0L Petrol, Removal and Installation).

14. Refer to: Supercharger Belt (303-05 Accessory Drive - 5.0L, Removal and
Installation).

15. Refer to: Throttle Body (303-04E Fuel Charging and Controls - V8 S/C 5.0L Petrol, Removal and Installation).

16. Refer to: Charge Air Cooler (303-12D Intake Air Distribution and Filtering - V8 S/C 5.0L Petrol, Removal and Installation).

17. Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures). www.JagDocs.com

Published: 20-Jun-2014
Intake Air Distribution and Filtering - V8 S/C 5.0L Petrol - Supercharger
Spring Isolator
Removal and Installation

Removal


CAUTION: Make sure that all open ports are covered to prevent any foreign material ingress.


NOTE: Some variation in the illustrations may occur, but the essential information is always correct.


1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.

2. Refer to: Supercharger (303-12D Intake Air Distribution and Filtering - V8 S/C 5.0L Petrol, Removal and Installation).

3.

4. NOTES:


Note the orientation prior to removal.


Hoses must be cut off to prevent damage to the
actuator.

















5.

8. CAUTION: Make sure the actuator arm is rotated to
allow the front cover to be removed. Failure to follow this
instruction may result in damage to the component.





















9. CAUTION: Make sure that all open ports are covered to
prevent any foreign material ingress.