JAGUAR XFR 2010 1.G Workshop Manual

TEST CONDITIONS DETAILS/RESULTS/ACTIONS D1: DELAMINATION TEST 1

1 Visually assess the windshield for delamination. Have the glass laminates separated?
Yes
Install a new windshield.
No
No further action. DTC Index

For a complete list of all Diagnostic Trouble Codes (DTCs) that could be logged on this vehicle, please refer to Section 100-00. Install a new windshield.

Published: 15-Jan-2013
Glass, Frames and Mechanisms - Door Window Motor Initialization
General Procedures
NOTES:

Make sure that the vehicle battery is fully charged before carrying out this procedure.


After the battery has been disconnected or a new window regulator and motor or door module has been installed, it is
necessary to initialize each door window motor separately to operate the one-touch and anti-trap function.


In addition to this manual procedure, the approved diagnostic tool can also be used to initialize the door window motor.

1. Start the engine.

2. Operate the window control switch until the door window glass is in the
fully closed position, continue to operate the window control switch for a
further two seconds.

3. Release the window control switch.

4. Operate the window control switch in the closed position and continue to
operate the window control switch for a further two seconds.

5. Operate the window control switch until the door window glass is in the
fully open position (one-touch down).

6. NOTES:


If the door window motor initialization has been completed
correctly, when the window control switch is operated, the door window
glass should move to the fully closed position (one-touch up)
automatically.


If the door window glass does not fully close automatically
(one-touch up), repeat the complete procedure.
Operate the window control switch once to the close position.
If multiple attempts have failed to initialize the door window
motor, refer the diagnosis and testing procedure.
For additional information, refer to: Glass, Frames and Mechanisms (501-11 Glass, Frames and Mechanisms, Diagnosis and Testing).

7. Repeat the door window motor initialization for each door window motor.

Interior Trim and Ornamentation, Removal and Installation).

2.
3.














Installation

1. To install, reverse the removal procedure.

www.JagDocs.com

Published: 11-May-2011
Glass, Frames and Mechanisms - Front Door Window Regulator and Motor
Removal and Installation



Removal


1. NOTE: Left-hand shown, right-hand similar.


































2. NOTE: Left-hand shown, right-hand similar. Door glass release lever
501-114 Special Tool(s)

3. WARNING: Do not allow the glass to drop.


NOTE: Left-hand shown, right-hand similar.
















4. For additional information, refer to: Front Door Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).


5. NOTE: Right-hand shown, left-hand similar.













6. TORQUE: 7 Nm

Removal and Installation).

3. www.JagDocs.com