MITSUBISHI ENDEAVOR 2004 Service Repair Manual

Page 3091 of 3870

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA
.
2. Temporarily tighten the bolts in mounting locations shown in the illustration
with no weight on the front seat cushion.
3. Tighten the nuts and bolts in all mounting locations to the specified torque.
INSPECTION HEATED SEAT SWITCH CHECK CONTINUITY TEST OF HEATED SEAT SWITCH 1. Check for continuity between terminals.
Fig. 3: Identifying Heated Seat Switch Terminals

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Front & Rear Seat Assembly - Endeavor

Page 3092 of 3870

Fig. 4: Checking Continuity Between Terminals

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
2. Check that the indicator is lighted at HI or LO when battery voltage is supplied
to terminal 5 and terminal 8 is grounded.
3. Check that indicator is lighted when battery voltage is supplied to terminals 2
and terminal 6.
SEAT CUSHION HEATER CHECK Measure the resistance between terminals.
Standard value: At room tem
perature 20 °C (68 °F)

2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Front & Rear Seat Assembly - Endeavor

Page 3093 of 3870

Between terminals 2 and terminal 3: Approximately 4.0 ohms +/- 9%
Between terminals 1 and terminal 3: 4.1 ohms +/- 9%
Fig. 5: Measuring Resistance Between Terminals (Seat Cushion Heater)

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
SEATBACK HEATER CHECK Measure the resistance between terminals.
Standard value: At room temperature 20 °C (68 °F) Approximately 3.6
2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Front & Rear Seat Assembly - Endeavor

Page 3094 of 3870

ohms +/- 9%
Fig. 6: Measuring Resistance Between Terminals (Seatback Heater)

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
HEATED SEAT RELAY CONTINUITY CHECK
2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Front & Rear Seat Assembly - Endeavor

Page 3095 of 3870

Fig. 7: Locating & Checking Heated seat Relay Continuity

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Front & Rear Seat Assembly - Endeavor

Page 3096 of 3870

Fig. 8: Heated Seat Relay Continuity Specifications

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
POWER SEAT MANUAL SWITCH CONTINUITY CHECK Fig. 9: Identifying Power Seat Manual Switch Connector

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Front & Rear Seat Assembly - Endeavor

Page 3097 of 3870

Fig. 10: Power Seat Manual Switch Connector Specification Chart

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
OPERATION CHECK OF POWER SEAT MOTOR 1. Disconnect the connector of each motor.
2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Front & Rear Seat Assembly - Endeavor

Page 3098 of 3870


2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Front & Rear Seat Assembly - Endeavor

Page 3099 of 3870

Fig. 11: Checking Operation Of Power Seat Motor

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
2. Check that when the battery is directly connected to the motor terminal, the
motor turns smoothly and each adjusting mechanism operates as stated below
for each motor:
1. Connect the battery power supply to the terminal 1 and ground the
terminal 2 for the rear reclining side, front slide side.
2. Connect the battery power supply to the terminal 2 and ground the
terminal 1 for the front reclining side, rear slide side.
3. Connect the battery power supply to the terminal 2 and ground the
terminal 3 for the front height down side and connect the battery power
supply to the terminal 3 and ground the terminal 2 for the front height up
side.
4. Connect the battery power supply to the terminal 3 and ground the
terminal 4 for the rear height up side and connect the battery power supply
to the terminal 4 and ground the terminal 3 for the rear height down side.
3. If abnormality was found, check the power seat adjuster assembly.
DISASSEMBLY AND ASSEMBLY < LH SIDE>
WARNING:Never attempt to disassemble or repair the seat slide
sensor. If faulty, replace it. < Vehicles with advanced
air bag>

2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Front & Rear Seat Assembly - Endeavor

Page 3100 of 3870

Fig. 12: Disassembling And Assembling Front Seat (LH Side)

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
< RH
SIDE >

2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Front & Rear Seat Assembly - Endeavor

Page:   < prev 1-10 ... 3051-3060 3061-3070 3071-3080 3081-3090 3091-3100 3101-3110 3111-3120 3121-3130 3131-3140 ... 3870 next >