wiring diagram NISSAN ALMERA TINO 2001 Service Owner's Guide

Page 155 of 3051

MODELS WITH ECM IN CABINNLAT0270S02
YAT218
LINE PRESSURE SENSOREXCEPT FOR EURO-OBD
Wiring Diagram Ð AT Ð LPS (Cont'd)
AT-154

Page 160 of 3051

Wiring Diagram Ð AT Ð LPSVNLAT0274
YAT180
LINE PRESSURE
SOLENOID VALVE
EXCEPT FOR EURO-OBD
Wiring Diagram Ð AT Ð LPSV
AT-159

Page 167 of 3051

Wiring Diagram Ð AT Ð TCVNLAT0278
YAT179
TORQUE CONVERTER CLUTCH
SOLENOID VALVE
EXCEPT FOR EURO-OBD
Wiring Diagram Ð AT Ð TCV
AT-166

Page 173 of 3051

Wiring Diagram Ð AT Ð FTSNLAT0282MODELS WITH ECM IN ENGINE COMPARTMENTNLAT0282S01
YAT175
CVT FLUID TEMPERATURE
SENSOR CIRCUIT
EXCEPT FOR EURO-OBD
Wiring Diagram Ð AT Ð FTS
AT-172

Page 174 of 3051

MODELS WITH ECM IN CABINNLAT0282S02
YAT214
CVT FLUID TEMPERATURE
SENSOR CIRCUIT
EXCEPT FOR EURO-OBD
Wiring Diagram Ð AT Ð FTS (Cont'd)
AT-173

Page 178 of 3051

Wiring Diagram Ð AT Ð ENGSSNLAT0286
YAT178
ENGINE SPEED SIGNALEXCEPT FOR EURO-OBD
Wiring Diagram Ð AT Ð ENGSS
AT-177

Page 187 of 3051

4 CHECK STOP LAMP SWITCH CIRCUIT (Without CONSULT-II)
1. Turn ignition switch to ªONº position.
(Do not start engine.)
2. Check voltage between stop lamp switch harness terminal 1 and ground. Refer to ªWiring Diagram Ð CVT Ð MAINº,
AT-62.
SAT733JA
Does battery voltage exist?
OK©GO TO 5.
NG©Check the following items:
+Harness for short or open between battery and stop lamp switch harness terminal 1
+Fuse
+Ignition switch (Refer to EL section.)
5 CHECK THROTTLE POSITION SWITCH CIRCUIT (With CONSULT-II)
With CONSULT-II
1. Refer to steps 1 to 7 of ªPreparationº, ªTCM Self-diagnostic Procedure (No Tools)º, AT-28.
2. Turn ignition switch to ªOFFº position.
3. Turn ignition switch to ªONº position.
(Do not start engine.)
4. Select ªTCM INPUT SIGNALSº in ªDATA MONITORº mode for ªCVTº with CONSULT-II.
5. Read out ªCLOSED THL/SWº and ªW/O THRL/P-SWº depressing and releasing accelerator pedal.
Check the signal of throttle position switch is indicated properly.
MTBL0011
OK or NG
OK©GO TO 7.
NG©Check the following items:
+Throttle position switch Ð Refer to ªComponents Inspectionº, AT-111.
+Harness for short or open between ignition switch and throttle position switch (Main
harness)
+Harness for short or open between throttle position switch and TCM (Main harness)
TROUBLE DIAGNOSES FOR NON-DETECTABLE ITEMS
Diagnostic Procedure (Cont'd)
AT-186

Page 189 of 3051

Wiring Diagram Ð AT Ð NONDTCNLAT0292MODELS WITH ECM IN ENGINE COMPARTMENTNLAT0292S01
YAT184
TROUBLE DIAGNOSES FOR NON-DETECTABLE ITEMS
Wiring Diagram Ð AT Ð NONDTC
AT-188

Page 190 of 3051

YAT185
TROUBLE DIAGNOSES FOR NON-DETECTABLE ITEMS
Wiring Diagram Ð AT Ð NONDTC (Cont'd)
AT-189

Page 191 of 3051

MODELS WITH ECM IN CABINNLAT0292S02
YAT219
TROUBLE DIAGNOSES FOR NON-DETECTABLE ITEMS
Wiring Diagram Ð AT Ð NONDTC (Cont'd)
AT-190

Page:   < prev 1-10 11-20 21-30 31-40 41-50 51-60 61-70 71-80 ... 720 next >