NISSAN X-TRAIL 2001 Service Repair Manual

REAR DOOR LOCK
BL-69
C
D
E
F
G
H
J
K
L
MA
B
BL
6. Remove inside handle mount screws.
7. Disconnect inside handle rod (on the door lock assembly).
8. Disconnect lock knob rod (on the door lock assembly).
9. Pry rod holder off with a slotted screwdriver to remove rod.
10. Slide inside handle rearward and remove it through the hole in
the door panel.
11. Remove rod from the inside handle.
12. Disconnect door lock actuator connector.
13. Remove mount screw (TORX T30) and remove door lock
assembly through the access hole.
14. Remove outside handle mount bolts. Slide outside handle rear-
ward to pull front end of the outside handle escutcheon from the
outer panel. Remove outside handle.
INSTALLATION
Install in the reverse order of removal.
NOTE:
●Install the outside handle by pressing it forward and downward while tightening the bolts.
●Install each rod by rotating the rod holder until it engages with a tactile feel.
SIIA0164E
PIIA0559E
SIIA0143E
SIIA0142E

BL-70
REAR DOOR LOCK
Disassembly and Assembly
EIS000L2
DISASSEMBLY
NOTE:
The door lock actuator must be removed and installed with the door lock assembly off the vehicle.
1. Remove mount screws and door lock actuator from door lock
assembly.
2. Pull the door lock actuator straight down to separate it from door
lock assembly.
ASSEMBLY
1. Align door lock actuator pivot with the door lock assembly knob lever cutout.
2. Move the knob lever and door lock actuator pivot toward the LOCK position to ensure that they are
securely engaged.
PIIA0560E

BACK DOOR
BL-71
C
D
E
F
G
H
J
K
L
MA
B
BL
BACK DOORPFP:90100
Fitting AdjustmentEIS000LF
VERTICAL/LATERAL CLEARANCE ADJUSTMENT
1. With striker removed, loosen hinge mount nuts on the back door and close it.
2. Make lateral clearance and clearance to rear window glass equal. Open back door to tighten mounting
bolts to specified torque.
3. If taking the steps above does not result in fine adjustment,
remove headliner and loosen the hinge mount nuts on the vehi-
cle for further adjustment.
PIIA3653E
SIIA0081E

BL-72
BACK DOOR
Back Door Assembly
EIS000LG
REMOVAL AND INSTALLATION
1. Disconnect connectors in the back door and encamp the harness. Pull the harness out of the back door.
2. Support the back door lock with a proper material to prevent it from falling and remove back door stay (gas
stay).
3. Remove hinge mount nuts on the back door and remove back door assembly.
INSPECTION
1. Check hinges for the following items
●Abnormal noise or door closing and opening effort
●Component wear or damage
2. Apply Body Grease to the rotating part of the hinge.
Removal and Installation of Back Door HandleEIS0015D
1. Remove back door trim. Refer to EI-25, "BACK DOOR TRIM" .
SIIA0085E
PIIA3747E

BACK DOOR
BL-73
C
D
E
F
G
H
J
K
L
MA
B
BL
2. Remove license lamp finisher. Refer to EI-22, "LICENSE LAMP
FINISHER" .
3. Remove cable clamp and remove cable from the back door han-
dle.
4. Remove mount nuts and back door handle.
Install in the reverse order of removal.
Removal and Installation of Back Door Lock and ActuatorEIS000LI
1. Remove back door trim. Refer to EI-25, "BACK DOOR TRIM" .
2. Disconnect back door lock & actuator connector.
3. Remove bolts from the back door lock and actuator and remove
back door lock & actuator.
Install in the reverse order of removal.
Removal and Installation of Back Door WeatherstripEIS000LJ
1. Working from the upper section, align weatherstrip mark with vehicle center position mark and install
weatherstrip onto the back door.
2. For the lower section, align the weatherstrip seam with center of the striker.
3. After installation, pull the weatherstrip gently to ensure that there is no loose section.
SIIA0232E
SIIA0234E
SIIA0194E

BL-74
BACK DOOR
NOTE:
Make sure the weatherstrip is fit tightly at each corner and back door rear plate.

FUEL FILLER LID OPENER
BL-75
C
D
E
F
G
H
J
K
L
MA
B
BL
FUEL FILLER LID OPENERPFP:78820
Component Parts LocationEIS000LK
SIIA0166E

BL-76
THEFT WARNING SYSTEM
THEFT WARNING SYSTEM
PFP:25362
Wiring Diagram — THEFT —/PRI-WIREEIS001RM
LHD MODELS
TIWA0021E
SMA for models with roof 
mounted driving lamp

THEFT WARNING SYSTEM
BL-77
C
D
E
F
G
H
J
K
L
MA
B
BL
TIWA0022E

BL-78
THEFT WARNING SYSTEM
RHD MODELS
TIWA0023E