SSANGYONG KORANDO 2013 Service Manual

Cluster fascia panel
RH cluster fascia panel and molding have been newly applied.
Instrument panel
- The design and material of IP have been
changed.
- An invisible type passenger air bag
module has been applied.LH side fascia panel & molding
The design of LH side fascia panel & molding has
been changed.
1. MAJOR CHANGES
Instrument Panel
Cluster fascia molding
RH cluster
fascia panel

5110-01
Center fascia lower panel
The design of center fascia lower panel has been
changed (lower tray, heater and A/C control
assembly).
Center fascia panel & molding, RH side fascia panel & molding
- The design of center fascia panel & molding has been changed.
- The design of RH side fascia panel & molding has been changed.
- RH center fascia panel has been newly applied.
RH glove box housing
extension
RH glove box housing extension panel
has been newly added on the right side
of glove box housing.
Center fascia panel
RH side fascia panel
Center fascia molding
RH side fascia
molding
LH and RH center fascia panels
RH side fascia panel
Center fascia moldingRH side fascia molding
Crash pad upper cover
The name of crash pad upper tray has been
changed to "crash pad upper cover" and its
design also has been changed.

Front console
The appearance of the front console cup holder housing has been changed.
Front Console
Front door trim
The design of front door trim has been changed.
Door Trim
Rear door trim
- The design of rear door trim has been changed.

Radiator grille
- The appearance of the radiator grille has been changed.
- The emblem on the radiator grille has been changed.
1. MAJOR CHANGES
Hood panel
The appearance of the hood panel has been changed.
Hood latch
The appearance of the hood latch safety hook has been
changed.

5110-00
Front impact
sensor mounting
Front end upper panel
Headlamp
aiming holeFront bumper bracket
Front bumper
bracket
Headlamp
bracket
Front bumper
- The appearance of the front bumper has been changed.
- The front end upper panel has been newly applied.
Front end upper member
The front bumper bracket has been newly applied.
Headlamp member
- Aiming hole has been added because of the changed
headlamp
- The install location of front impact sensor has been
changed.
- The appearances of the front bumper bracket and
headlamp bracket have been changed.

Rear quarter panel
The outline of the rear combination lamp mounting has been changed.

5110-01
Top view
Side view
Front side Rear view
1. MAJOR DIMENSION

2. JACK POINTS
1) 2WD

5110-01
2) 4WD

3. SEALING APPLICATION POINTS
1) Dash Panel, Engine Tunnel, Floor, Etc.