TOYOTA SEQUOIA 2001 Service Repair Manual

H16754
Rear No. 3 Air Duct
w/o Rear A/C:
Rear No. 2 Side Rail Spacer
No. 1 Roof Headlining Trim Side Retainer w/ Rear A/C:
Front Side Rail Spacer
w/o Curtain shield
airbag assembly:
Front Pillar Spacer
Quarter Trim Panel
Front Door
Scuff PlateLower Center
Pillar GarnishQuarter Trim Panel w/ Rear No. 2 seat:
Quarter Trim Upper
Belt Hole Cover
Rear Door
Scuff Plate Center
Pillar
Garnish Assist Grip
Assist Grip
Front Door Opening
Trim Weatherstrip
Cowl Side Trim Board Front Pillar
GarnishFront Roof Headlining
Trim Retainer
Rear Roof
Headlining
Trim Retainer w/o Rear A/C:
Rear No. 2 Side
Rail Spacer
Rear Window
Side GarnishNo. 2 Rear
Window
Side Garnish
Rear Door
Opening Trim
Weatherstrip
w/o Rear No. 2 seat:
Quarter Trim Hole Cover
Rear Floor Mat
Support Plate
42 (430, 31)
42 (430, 31)
42 (430, 31)
42 (430, 31)
N´m (kgf´cm, ft´lbf)
: Specified torque
42 (430, 31)
42 (430, 31)
42 (430, 31)
42 (430, 31)42 (430, 31)
Assist Grip
BO±100
± BODYROOF HEADLINING
3653 Author: Date:
2005 SEQUOIA (RM1146U)

BO4HN±04
H24383Claw
H16716
2 Clips
H16717
Clip
± BODYROOF HEADLINING
BO±101
3654 Author: Date:
2005 SEQUOIA (RM1146U)
REMOVAL
1. w/ Rear No 2 seat:
REMOVE REAR NO. 2 SEAT
2. REMOVE FRONT DOOR SCUFF PLATE
(a) Remove the 4 screws and front door scuff plate.
(b) Use the same manner described above to the other side.
3. REMOVE COWL SIDE TRIM BOARD
(a) Remove the nut and cowl side trim board.
(b) Use the same manner described above to the other side.
4. REMOVE FRONT DOOR OPENING TRIM WEATH-
ERSTRIP
5. REMOVE FRONT PILLAR GARNISH
(a) Remove the assist grip.
(1) Using a screwdriver, remove the 2 assist grip plugs.
HINT:
Tape the screwdriver tip before use.
(2) Remove the 2 screws and assist grip.
(b) Remove the front pillar garnish.
(c) Use the same manner described above to the other side.

H16718
Clip
H16719
4 Clips
H10441
H17900
4 Claws BO±102
± BODYROOF HEADLINING
3655 Author: Date:
2005 SEQUOIA (RM1146U)
6. REMOVE REAR DOOR SCUFF PLATE
(a) Remove the 3 screws.
(b) Using a screwdriver, remove the rear door scuff plate.
HINT:
Tape the screwdriver tip before use.
(c) Use the same manner described above to the other side.
7. REMOVE REAR DOOR OPENING TRIM WEATH-
ERSTRIPS
8. REMOVE LOWER CENTER PILLAR GARNISH
(a) Remove the front seat outer belt floor anchor.
Torque: 42 N´m (430 kgf´cm, 31 ft´lbf)
(b) Using a screwdriver, remove the lower center pillar gar-
nish.
HINT:
Tape the screwdriver tip before use.
(c) Use the same manner described above to the other side.
9. REMOVE FRONT SEAT OUTER BELT SHOULDER AN-
CHOR
(a) Using a screwdriver, remove the anchor cap.
HINT:
Tape the screwdriver tip before use.
(b) Remove the front seat outer belt shoulder anchor.
Torque: 42 N´m (430 kgf´cm, 31 ft´lbf)
10. w/ Curtain shield airbag assembly:
REMOVE ASSIST GRIP
(a) Using a screwdriver, remove the cap.
HINT:
Tape the screwdriver tip before use.
(b) Remove the screw.
(c) Using a screwdriver, remove the No. 2 assist grip plug.
HINT:
Tape the screwdriver tip before use.
(d) Remove the 2 screws and assist grip.
(e) Use the same manner described above to the other side.

H16720
4 Claws
H16721
Clip
H11151
H17633
w/o Rear No. 2 seat:
w/ Rear No. 2 seat:
± BODYROOF HEADLINING
BO±103
3656 Author: Date:
2005 SEQUOIA (RM1146U)
11. w/o Curtain shield airbag asseindly:
REMOVE ASSIST GRIP
(a) Using a screwdriver, remove the No. 2 assist grip piug.
HINT:
Tape the screwdriver tip before use.
(b) Remove the 2 screws and assist grip.
(c) Use the same manner described above to the other side.
12. REMOVE CENTER PILLAR GARNISH
(a) Remove the clip.
(b) Remove the center pillar garnish.
(c) Use the same manner described above to the other side.
13. REMOVE DOME LIGHT
(a) Using a screwdriver, remove the lens.
HINT:
Tape the screwdriver tip before use.
(b) Remove the 2 screws and dome light, then disconnect the
connector.
14. REMOVE REAR TRIM COVER
Using a screwdriver, remove the rear trim cover.
HINT:
Tape the screwdriver tip before use.

H167249 Clips
H16725
H16726
H16727
BO±104
± BODYROOF HEADLINING
3657 Author: Date:
2005 SEQUOIA (RM1146U)
15. REMOVE REAR TRIM
Using a screwdriver, remove the rear trim.
HINT:
Tape the screwdriver tip before use.
16. REMOVE REAR FLOOR MAT SUPPORT PLATE
17. w/o Rear No. 2 seat:
REMOVE QUARTER TRIM HOLE COVER
(a) Using a screwdriver, remove the quarter trim hole cover.
HINT:
Tape the screwdriver tip before use.
(b) Use the same manner described above to the other side.
18. w/ Rear No. 2 seat:
REMOVE QUARTER TRIM UPPER BELT HOLE COV-
ER
(a) Using a screwdriver, remove the quarter trim upper belt
hole cover.
HINT:
Tape the screwdriver tip before use.
(b) Use the same manner described above to the other side.
19. REMOVE QUARTER TRIM PANEL LH
(a) w/o Rear A/C:
Using a screwdriver, remove the deck side trim cover.
HINT:
Tape the screwdriver tip before use.
(b) w/o Tonneau cover:
Using a screwdriver, remove the 2 No. 1 tonneau cover
holder caps.
HINT:
Tape the screwdriver tip before use.
(c) Remove the 2 package holder net hooks.
(d) Remove the rear No. 1 seat outer belt floor anchor.
Torque: 42 N´m (430 kgf´cm, 31 ft´lbf)

H16728
6 Clips
4 Clips
H16729
H16730
6 Clips
4 Clips
H16731
2 Clips
Clip
± BODYROOF HEADLINING
BO±105
3658 Author: Date:
2005 SEQUOIA (RM1146U)
(e) Remove the 3 bolts, clip and quarter trim panel LH, then
disconnect the connector.
20. REMOVE QUARTER TRIM PANEL RH
(a) w/o Tonneau cover:
Using a screwdriver, remove the 2 No. 1 tonneau cover
holder caps.
HINT:
Tape the screwdriver tip before use.
(b) Remove the 2 package holder net hooks.
(c) Remove the rear No. 1 seat outer belt floor anchor.
Torque: 42 N´m (430 kgf´cm, 31 ft´lbf)
(d) Remove the 3 bolts, clip and quarter trim panel RH.
21. w/ Rear No. 2 seat:
REMOVE REAR NO. 2 SEAT OUTER BELT SHOUL-
DER ANCHORS
Torque: 42 N´m (430 kgf´cm, 31 ft´lbf)
22. REMOVE NO. 2 REAR WINDOW SIDE GARNISH
(a) Remove the 3 clips and No. 2 rear window side garnish.
(b) Use the same manner described above to the other side.
23. REMOVE REAR NO. 1 SEAT OUTER BELT SHOUL-
DER ANCHOR
(a) Using a screwdriver, remove the anchor cap.
HINT:
Tape the screwdriver tip before use.
(b) Remove the rear No. 1 seat outer belt shoulder anchor.
Torque: 42 N´m (430 kgf´cm, 31 ft´lbf)
(c) Use the same manner described above to the other side.

H16732
7 Clips
2 Clips
H16733
H188952 Clips
H167342 Clips
H167354 Clips BO±106
± BODYROOF HEADLINING
3659 Author: Date:
2005 SEQUOIA (RM1146U)
24. REMOVE REAR WINDOW SIDE GARNISH
(a) Remove the rear window side garnish.
(b) Use the same manner described above to the other side.
25. w/ Sliding roof:
REMOVE MAP LIGHT
(a) Using a screwdriver, remove the lens.
HINT:
Tape the screwdriver tip before use.
(b) Remove the 2 screws and map light, then disconnect the
connector.
26. w/ Rear seat entertainment:
REMOVE INFORATION DISPLAY
(a) Remove the 2 lenses.
(b) Remove the 2 screws and display panel, then disconnect
the connector.
(c) Remove the 4 dolts and multi information display, then
disconnect the connector.
27. w/ Electro chrmic inner rear view mirror:
REMOVE MIRROR COVER
28. w/ Sliding roof:
REMOVE ROOF CONSOLE BOX
(a) Remove the 2 screws.
(b) Using a screwdriver, remove the roof console box.
HINT:
Tape the screwdriver tip before use.
(c) Disconnect the connector.
29. w/o Sliding roof:
REMOVE ROOF CONSOLE BOX
(a) Remove the 4 screws.
(b) Using a screwdriver, remove the roof console box.
HINT:
Tape the screwdriver tip before use.
(c) Disconnect the connectors.
30. REMOVE ASSIST GRIPS
31. w/ Sliding roof:
REMOVE SLIDING ROOF OPENING TRIM

H16736
± BODYROOF HEADLINING
BO±107
3660 Author: Date:
2005 SEQUOIA (RM1146U)
32. REMOVE SUN VISORS AND HOLDERS
33. REMOVE ROOF HEADLINING
(a) Using a clip remover, remove the 2 clips.
(b) Remove the roof headlining.
34. w/ Rear A/C:
REMOVE REAR AIR DUCTS
35. w/ Rear A/C:
REMOVE FRONT SIDE RAIL SPACERS
36. w/o Rear A/C:
REMOVE REAR NO. 2 SIDE RAIL SPACERS
37. w/o Curtain shield airbag assembly:
REMOVE FRONT PILLAR SPACERS
38. REMOVE FRONT ROOF HEADLINING TRIM RETAIN-
ERS
39. REMOVE REAR ROOF HEADLINING TRIM RETAIN-
ERS
40. REMOVE NO. 1 ROOF HEADLINING TRIM SIDE RE-
TAINERS

BO46X±01
BO±108
± BODYROOF HEADLINING
3661 Author: Date:
2005 SEQUOIA (RM1146U)
INSTALLATION
Installation is in the reverse order of removal (See page BO±101).

BO46Y±01
H16753
Side Door Step
Plate Cover
Step Cover
Protector
Step Plate
Side Step Bracket
No. 3 Side Step Bracket
No. 2 Side Step Bracket
No. 1 Side Step Bracket Step Cover
Protector
N´m (kgf´cm, ft´lbf) : Specified torque
19 (195, 14)
19 (195, 14)
19 (195, 14)
19 (195, 14)
4.9 (50, 43 in.´lbf)
4.9 (50, 43 in.´lbf)
4.9 (50, 43 in.´lbf)
4.9 (50, 43 in.´lbf)
± BODYSIDE STEP
BO±109
3662 Author: Date:
2005 SEQUOIA (RM1146U)
SIDE STEP
COMPONENTS