TOYOTA SEQUOIA 2001 Service Repair Manual
Page 4141 of 4323
05_SEQUOIA_U (L/O 0408)
282
2005 SEQUOIA from Aug. '04 Prod. (OM34424U)
You can enjoy the rear seat entertain-
ment system with commercial head-
phones.
To use the headphones, connect them to
the jack.
The key must be in the ªACCº or ªONº
position.To adjust the volume of the headphones,
turn the knob. Turn right to increase the
volume. Turn left to decrease the volume.
The maximum volume depends on the
type of headphones.
With some headphones generally available
in the marker, it may be difficult to catch
sound properly. Toyota recommends the
use of Toyota genuine headphone.
Please contact your Toyota dealer for fur-
ther details.
CAUTION
Adjust the volume when you connect
the headphones to the jack. Loud
sounds may have a significant impact
on the human body.
ÐHeadphone input jacks
Page 4142 of 4323
05_SEQUOIA_U (L/O 0408)
283
2005 SEQUOIA from Aug. '04 Prod. (OM34424U)
NOTICE
To ensure correct audio/video system
operation:
Be careful not to spill beverages
over the system.
Do not put anything other than a
cassette tape or Compact Disc into
the slot.
Do not put anything other than a
DVD video, DVD audio, video CD,
dts±CD and audio CD into the DVD
player.
The use of a cellular phone inside
or near the vehicle may cause a
noise from the speakers of the sys-
tem which you are listening to.
However, this does not indicate a
malfunction.
RADIO RECEPTION
Usually, a problem with radio reception
does not mean there is a problem with
your radioÐit is just the normal result of
conditions outside the vehicle.For example, nearby buildings and terrain
can interfere with FM reception. Power
lines or telephone wires can interfere with
AM signals. And of course, radio signals
have a limited range. The farther you are
from a station, the weaker its signal will
be. In addition, reception conditions
change constantly as your vehicle moves.
Here are some common reception prob-
lems that probably do not indicate a prob-
lem with your radio:
FM
Fading and drifting stationsÐGenerally, the
effective range of FM is about 40 km (25
miles). Once outside this range, you may
notice fading and drifting, which increase
with the distance from the radio transmit-
ter. They are often accompanied by distor-
tion.
Multi±pathÐFM signals are reflective,
making it possible for two signals to reach
your antenna at the same time. If this
happens, the signals will cancel each oth-
er out, causing a momentary flutter or
loss of reception.Static and flutteringÐThese occur when
signals are blocked by buildings, trees, or
other large objects. Increasing the bass
level may reduce static and fluttering.
Station swappingÐIf the FM signal you
are listening to is interrupted or weak-
ened, and there is another strong station
nearby on the FM band, your radio may
tune in the second station until the origi-
nal signal can be picked up again.
AM
FadingÐAM broadcasts are reflected by
the upper atmosphereÐespecially at night.
These reflected signals can interfere with
those received directly from the radio sta-
tion, causing the radio station to sound
alternately strong and weak.
Station interferenceÐWhen a reflected sig-
nal and a signal received directly from a
radio station are very nearly the same
frequency, they can interfere with each
other, making it difficult to hear the broad-
cast.
StaticÐAM is easily affected by external
sources of electrical noise, such as high
tension power lines, lightening, or electri-
cal motors. This results in static.
Audio/video system operating
hints
Page 4143 of 4323
05_SEQUOIA_U (L/O 0408)
284
2005 SEQUOIA from Aug. '04 Prod. (OM34424U)
CARING FOR YOUR CASSETTE PLAYER
AND TAPES
For the best performance for your cas-
sette player and tapes:
Clean the tape head and other parts regu-
larly.
A dirty tape head or tape path can
decrease sound quality and tangle your
cassette tapes. The easiest way to
clean them is by using a cleaning tape.
(A wet type is recommended.)
Use high±quality cassettes.
Low±quality cassette tapes can cause
many problems, including poor sound,
inconsistent playing speed, and
constant auto±reversing. They can also
get stuck or tangled in the cassette
player.
Do not use a cassette if it has been
damaged or tangled or if its label is
peeling off.
Do not leave a cassette in the player
if you are not listening to it, especially
if it is hot outside.
Store cassettes in their cases and out
of direct sunlight.
Avoid using cassettes with a total play-
ing time longer than 100 minutes (50
minutes per side). The tape used in
these cassettes is thin and could get
stuck or tangled in the cassette player.
CARING FOR YOUR COMPACT DISC
PLAYER, DVD PLAYER AND DISCS
Your compact disc player and DVD
player are intended for use with 12 cm
(4.7 in.) discs only.
Extremely high temperatures can keep
your compact disc player and DVD
player from working. On hot days, use
the air conditioning to cool the vehicle
interior before you use the players.
Bumpy roads or other vibrations may
make your compact disc player and
DVD player skip.
If moisture gets into your compact disc
player and DVD player, the players
may not play even though they appear
to be working. Remove the disc from
the player and wait until it dries.
CAUTION
Compact disc players and DVD play-
ers use an invisible laser beam which
could cause hazardous radiation ex-
posure if directed outside the unit. Be
sure to operate the players correctly.
Page 4144 of 4323
05_SEQUOIA_U (L/O 0408)
285
2005 SEQUOIA from Aug. '04 Prod. (OM34424U)
Compact disc player
Use only compact discs marked as
shown above. The following products
may not be playable on your compact
disc player.
SACD
dts±CD
Copy±protected CD
CD±R (CD±Recordable)
CD±RW (CD±Re±writable)
CD±ROM
Audio CDs
DVD video
discs
DVD audio
discs
Video CDs
DVD player
Use only discs marked as shown
above. The following products may not
be playable on your DVD player.
SACD
Copy±protected CD
CD±R (CD±Recordable)
CD±RW (CD±Re±writable)
CD±ROM
DVD±R
DVD+R
DVD+RW
DVD±RW
DVD±ROM
DVD±RAM
Page 4145 of 4323
05_SEQUOIA_U (L/O 0408)
286
2005 SEQUOIA from Aug. '04 Prod. (OM34424U)
Special shaped discs
Transparent/translucent discs
Low quality discs
Labeled discs
NOTICE
Do not use special shaped, transpar-
ent/translucent, low quality or labeled
discs such as those shown in the il-
lustrations. The use of such discs
may damage the player or changer, or
it may be impossible to eject the
disc.
Page 4146 of 4323
05_SEQUOIA_U (L/O 0408)
287
2005 SEQUOIA from Aug. '04 Prod. (OM34424U)
Correct Wrong
Handle compact discs carefully, espe-
cially when you are inserting them.
Hold them on the edge and do not
bend them. Avoid getting fingerprints
on them, particularly on the shiny side.
Dirt, scratches, warping, pin holes, or
other disc damage could cause the
player to skip or to repeat a section of
a track. (To see a pin hole, hold the
disc up to the light.)
Remove discs from the compact disc
player when you are not listening to
them. Store them in their plastic cases
away from moisture, heat, and direct
sunlight.
To clean a compact disc: Wipe it with a
soft, lint±free cloth that has been damp-
ened with water. Wipe in a straight line
from the center to the edge of the disc
(not in circles). Dry it with another soft,
lint±free cloth. Do not use a conventional
record cleaner or anti±static device.
Page 4147 of 4323
05_SEQUOIA_U (L/O 0408)
288
2005 SEQUOIA from Aug. '04 Prod. (OM34424U)
Page 4148 of 4323
05_SEQUOIA_U (L/O 0408)
289
2005 SEQUOIA from Aug. '04 Prod. (OM34424U)
OPERATION OF INSTRUMENTS AND
CONTROLS
Air conditioning system
Front air conditioning system
Controls290 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Air flow selector settings294 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Operating tips294 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Instrument panel vents297 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Rear air conditioning system
Controls298 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Air flow selector settings300 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
SECTION 1± 9
Page 4149 of 4323
05_SEQUOIA_U (L/O 0408)
290
2005 SEQUOIA from Aug. '04 Prod. (OM34424U)
1. Temperature selector
2. ªAUTOº button
3. ªMODEº button (air flow selector)
4. Fan speed selector
5. ªA/Cº button
6. Air intake selector button
7. Windshield air flow button
8. ªOFFº button
Front air conditioning systemÐ
ÐControls
Page 4150 of 4323
05_SEQUOIA_U (L/O 0408)
291
2005 SEQUOIA from Aug. '04 Prod. (OM34424U)
ªAUTOº button
For automatic operation of the air condi-
tioning, press the ªAUTOº button. An indi-
cator light will illuminate to show that the
automatic operation mode has been se-
lected.
In the automatic operation mode, the air
conditioning selects the most suitable fan
speed and air flow, on±off of the air condi-
tioning and air intake according to the
temperature.
When you press the ªAUTOº button with
the air intake mode at FRESH, internal
circulation may be applied for maximum
cooling.
When you adjust the temperature selector
to maximum cooling, a ªMAX COLDº mes-
sage will appear on the display and the
air intake mode will be automatically
changed to RECIRCULATE.
You may use manual controls if you want
to select your own settings.Fan speed selector
Turn the knob to adjust the fan speedÐto
the right to increase, to the left to de-
crease.
In automatic operation, the fan speed is
adjusted automatically unless you desire
another fan speed mode.
Temperature selector
Turn the knob to adjust the temperatu-
reÐto the right to warm, to the left to
cool.
The temperature display changes between
ªCº and ªFº when the unit of the outside
temperature display is changed. (For de-
tails, see ªMulti±information displayº on
page 302 in Section 1±10.)
ªOFFº button
Push the button to turn off the air condi-
tioning system.
ªMODEº button (air flow selector)
Press the button to select the vents used
for air flow.
In automatic operation, the air flow mode
is selected automatically among Panel, Bi±
level and Floor unless you desire another
air flow mode.
1. PanelÐAir flows mainly from the
instrument panel vents.