engine Citroen DS3 2014 1.G Manual PDF

DS3_en_Chap11_verifications_ed01-2014
Checks
This section describes access to the engine compartment, the procedure for   bleeding   the   fuel   system   on   Diesel   engines   after   running   out   of   fuel,  
t

he   location   of   various   engine   components   needed   to   check   the   levels  
a

nd   the   main   wearing   parts.

DS3_en_Chap11_verifications_ed01-2014
ToTaL & CITRoËN
Partners in performance and
protecting the environment
Innovation in the search for
performance
For over 40 year, the ToTaL R esearch and
Development   departments   have   developed   for  
C

ITROËN,   lubricants   to   match   the   latest   technical  
i

nnovations on CITR
oË
N vehicles, both for
competition
  and   for   everyday   motoring.
For you, this is an assurance that you will obtain of
the
  best   per formance   for   your   engine.
Optimum protection for
your engine
By having your CITROËN vehicle serviced with ToTaL l ubricants, you
are
  contributing   towards   improving   the  
l

ife   and   per formances   of   your   engine,  
w

hile   also   protecting   the   environment.
prefers

247
DS3_en_Chap11_verifications_ed01-2014
bonnetProtects the components of the engine and provides access for checking levels.
Opening
F Open  the   front   left   door.
F P ull the interior release lever A , located at
the
  bottom   of   the   door   aperture.F
 P ush   the   exterior   safety   catch   B to the left
and
  raise   the   bonnet.
Before
 
doing
 
anything
 
under
 
the
 
b

onnet, switch off the Stop & Start
system
 
to
 
avoid
 
any
 
risk
 
of
 
injury
 
r

esulting
 
from
 
an
 
automatic
 
change
 
to
 
S

TART
 
mode.
The location of the interior release lever
prevents  opening   of   the   bonnet   while  
t

he   front   left   door   is   closed.
checks

DS3_en_Chap11_verifications_ed01-2014
closing
F Take  the   stay   out   of   the   support   notch.
F  C lip   the   stay   in   its   housing.
F

L
ower the bonnet and release it at the end
of
  its   travel.
F
 
P
ull   on   the   bonnet   to   check   that   it   is   fully  
l

atched.
F

U

nclip the bonnet stay
c 
from
 
its
 
housing,
 
h

olding
 
it
 
by
 
its
 
foam
 
protection.
F
 
F

ix
 
the
 
stay
 
in
 
the
 
notch
 
to
 
hold
 
the
 
bonnet
 
ope

n. When
 
the
 
engine
 
is
 
hot,
 
handle
 
the
 
e

xterior
 
safety
 
catch
 
and
 
the
 
stay
 
with
 
c

are.
To
 
avoid
 
damaging
 
the
 
electric
 
units,
 
t

he
 
use
 
of
 
a
 
high
 
pressure
 
jet
 
wash
 
u

nder
 
the
 
bonnet
 
is
 
strictly
 
prohibited.

249
DS3_en_Chap11_verifications_ed01-2014
Petrol engines
1. Screenwash  fluid   reservoir.
2. C oolant   header   tank.
3.
 A

ir   filter.
4.
 B

rake   fluid   reservoir.
5.
 B

attery.
6.
 F

usebox.
7.
 E

ngine   oil   dipstick.
8.
 E

ngine   oil   filler   cap.
checks

DS3_en_Chap11_verifications_ed01-2014
Diesel engines
1. Screenwash  fluid   reservoir.
2. C oolant   header   tank.
3.
 A

ir   filter.
4.
 B

rake   fluid   reservoir.
5.
 B

attery.
6.
 F

usebox.
7.
 E

ngine   oil   dipstick.
8.
 E

ngine   oil   filler   cap.
9.
 P

riming   pump   (on   fuel   filter).

251
DS3_en_Chap11_verifications_ed01-2014
Checking levels
Check all of these levels regularly, in line with the maintenance and warranty guide. Top them up if necessary, unless other wise indicated.
I f   a   level   drops   significantly,   have   the   corresponding   system   checked   by   a   CITROËN   dealer   or   a   qualified   workshop.
Engine oil level
It is normal to top up the oil level between two   services   (or   oil   changes).   CITROËN  
r

ecommends   that   you   check   the   level,   and   top  
u

p   if   necessary,   every   3   000   miles   (5   000   kms).
The
  check   is   carried   out   either   when  
t

he   ignition   is   switched   on   using   the  
o

il   level   indicator   in   the   instrument  
p

anel for vehicles with an electric oil
level   gauge,   or   using   the   dipstick.
To   ensure   that   the   reading   is   correct,  
y

our   vehicle   must   be   parked   on   a   level  
s

ur face   with   the   engine   having   been   off  
f

or   more   than   30   minutes.
Take   care   when   working   under   the  
b

onnet,   as   certain   areas   of   the   engine  
m

ay   be   extremely   hot   (risk   of   burns)  
a

nd   the   cooling   fan   could   start   at   any  
t

ime   (even   with   the   ignition   off).
checking using the dipstick
A = MA X
B   =   MIN If you find that the level is above the A
  mark   or  
belo

w the B   mark,   do not star t the engine
.
-
I
f the level is above the MAX
 
mark   (risk  
o

f   damage   to   the   engine),   contact   a  
C

ITROËN   dealer   or   a   qualified   workshop.
-
I
f the level is below the MIN
 
mark,   you  
m

ust   top   up   the   engine   oil.
Refer
 
to
 
the
 
"Petrol   engine"   or   "Diesel   engine"  
s

ection
 
for
 
the   location   of   the   dipstick   in   the  
e

ngine
 
compartment   of   your   vehicle.
F
 
T

ake
 
the
  dipstick   by   its   coloured   grip   and  
r

emove
 
it   completely.
F
 
W

ipe
 
the
  end   of   the   dipstick   using   a   clean  
n

on-fluffy   cloth.
F
 
R

efit
 
the
  dipstick   and   push   fully   down,   then  
p

ull
 
it
 
out   again   to   make   the   visual   check:  
t

he
 
correct   level   is   between   the   marks   A
and B .
Oil grade
Before topping-up the oil or changing the oil, c
heck   that   the   oil   is   the   correct   grade   for   your  
e

ngine   and   conforms   to   the   manufacturer's  
r

ecommendations.
checks

DS3_en_Chap11_verifications_ed01-2014
Brake fluid level
Changing the fluid
Refer to the maintenance and warranty guide for   details   of   the   interval   for   this   operation.
Fluid specification
The brake fluid must conform to the manufacturer's r ecommendations.
The
  brake   fluid   level   should   be   close  
t

o   the   "MA X"   mark.   If   it   is   not,   check  
t

he   brake   pad   wear.
After
 
topping
 
up
 
the
 
oil,
 
the
 
check
 
when
 
s

witching
 
on
 
the
 
ignition
 
with
 
the
 
oil
 
level
 
i

ndicator
 
in
 
the
 
instrument
 
panel
 
is
 
not
 
valid
 
d

uring
 
the
 
30
 
minutes
 
after
 
topping
 
up.
Topping up the engine oil level
Refer to the "Petrol engine" or "Diesel engine" s ection for the location of the oil filler cap in the
engine
  compartment   of   your   vehicle.
F

U
nscrew the oil filler cap to reveal the filler
aperture.
F
 
A
dd   oil   in   small   quantities,   avoiding   any  
s

pills   on   engine   components   (risk   of   fire).
F
 
W
ait   a   few   minutes   before   checking   the  
l

evel   again   using   the   dipstick.
F
 
A
dd   more   oil   if   necessary.
F
 
A
fter   checking   the   level,   carefully   refit   the  
o

il   filler   cap   and   the   dipstick   in   its   tube.
Engine oil change
Refer to the maintenance and warranty guide for   details   of   the   interval   for   this   operation.
In
  order   to   maintain   the   reliability   of   the   engine  
a

nd   emission   control   system,   never   use  
a

dditives   in   the   engine   oil.

253
DS3_en_Chap11_verifications_ed01-2014
Fluid specification
The coolant must conform to the manufacturer's r ecommendations.
coolant level
The coolant level should be close
to  the   "MA X"   mark   but   should   never  
e

xceed   it.
In
 
addition,   as   the   cooling   system   is  
p

ressurised, wait at least one hour after
switching
 
off   the   engine   before   carrying   out   any  
wo

rk.
To
 
avoid
 
any   risk   of   scalding,   unscrew   the   cap  
b

y
 
two
 
turns   to   allow   the   pressure   to   drop.  
W

hen
 
the
  pressure   has   dropped,   remove   the  
c

ap
 
and
 
top   up   the   level.
When
 
the
  engine   is   warm,   the   temperature   of  
t

he
 
coolant   is   regulated   by   the   fan.
The cooling fan may star t after
switching off the engine: take care
with articles and clothing that might
be caught by the fan blades.
Screenwash fluid level
Fluid specification
For optimum cleaning and to avoid freezing, t his   fluid   must   not   be   topped   up   or   replaced  
w

ith   plain   water.
In
 
w
intry  
c
onditions,  
i
t  
i
s  
r
ecommended  
t
hat  
y
ou  
u

se   an   ethyl   alcohol   or   methanol   based   fluid.
Top
  up   the   level   when   necessary.
checks

DS3_en_Chap11_verifications_ed01-2014
diesel additive level
(
di
esel engine with particle
emission filter)
To p p i n g u p
This additive must be topped up by a CITROËN d
ealer   or   a   qualified   workshop   without   delay.
Used products
Avoid prolonged contact of used oil or fluids   with   the   skin.
Most
  of   these   fluids   are   harmful   to  
h

ealth   or   indeed   very   corrosive.
Do not discard used oil or fluids into
sewers
  or   onto   the   ground.
Take
  used   oil   to   a   CITROËN   dealer   or  
a

  qualified   workshop   (France)   or   to   an  
a

uthorised   waste   disposal   site.
The additive reservoir low level is
indicated
 
by
 
fixed
 
illumination
 
of
 
t

his
 
warning
 
lamp,
 
accompanied
 
by
 
an
 
audible
 
w

arning
 
and
 
a
 
message
 
in
 
the
 
multifunction
 
sc

reen.