versions FIAT PANDA 2009 169 / 2.G Owner's Guide

61
F0Z0686m
fig. 67
To unlock
Turn the key to position 2 with the door shut properly.
With central door locking (for versions/markets where
provided) all doors must be shut properly.
By remote control (for versions/markets where provided)
press the button
Á
to close the doors.
If one of the doors is not shut properly, simultaneous
locking is disabled.
IMPORTANT If one of the front doors is not fully closed
or in case of system failure, central door locking will not
operate and, after 6 attempts in rapid sequence, the sys-
tem will be excluded for about 60 seconds.
DOORSLOCKING/UNLOCKING FROM THE OUTSIDE
fig. 67
To unlock
Turn the key to position 1 and pull the handle upwards.
With central door locking (for versions/markets where
provided), the doors are unlocked simultaneously when
the key is turned.
By remote control (for versions/markets where provided)
press the button
Ëto open the doors.
Before opening a door, make sure this can
be done in safety.
WARNING
Open the doors only when the car is sta-
tionary.
WARNING
KNOW YOUR
VEHICLESAFETY
CORRECT USE
OF THE CAR
WARNING LIGHTS
AND MESSAGES
IN
AN EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
031-064 PANDA EN 7-10-2009 13:43 Pagina 61

F0Z0025m
fig. 70
POWER WINDOW FRONT WINDOW WINDERS fig. 70
(for versions/markets where provided)
They operate with ignition key on MAR and for about two
minutes after positioning the key on STOP or removing it.
The two buttons are located besides the gearshift lever
(one for each side); they control:
A Opening/closing of left-hand door window.
B Opening/closing of right-hand door window.
Keep the driver’s door button pressed for a few seconds
to open or close the window automatically (only with key
at MAR).
Incorrect use of the power windows may
be dangerous. Before and during their op-
eration ensure that any passengers are not at risk
from the moving glass either by personal objects
getting caught in the mechanism or by being hit
by it directly.
WARNING
When leaving the car, always remove the
ignition key to avoid the risk of injury of
people still on board due to accidental operation
of the power windows.
WARNING
63KNOW YOUR
VEHICLESAFETY
CORRECT USE
OF THE CAR
WARNING LIGHTS
AND MESSAGES
IN
AN EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
031-064 PANDA EN 7-10-2009 13:43 Pagina 63

64
KNOW YOUR
VEHICLE
SAFETY
CORRECT USE
OF THE CAR
WARNING LIGHTS
AND MESSAGES
IN
AN EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
F0Z0064m
fig. 71
WINDOW WINDERS fig. 71
Window winders are fitted on the rear doors of all versions;
on some versions window winders are fitted also on front
doors. To open/close use the handle A.
031-064 PANDA EN 7-10-2009 13:43 Pagina 64

F0Z0687m
fig. 72
F0Z0688m
fig. 73
BOOTOPENING THE TAILGATE
By means of the key without remote control
fig. 72
To release the lock, use the metal insert of the ignition
key A.
Tailgate opening is eased by the action of the side gas
struts.
Some versions, opening the tailgate will switch the boot
light on: the light will go off automatically when closing
the tailgate.
The light will stay on for about 15 minutes after turning the
key to STOP: if during this time, one door or the tailgate
is opened, the light will switch on again for 15 minutes.By means of the key with remote control
(for versions/markets, where provided)
Press the button
R
. The direction indicators will
blink twice when the tailgate is opened.
Soft touch power handle fig. 73
(for versions/markets, where provided)
On some versions, the tailgate (when released) can
be opened only from outside the car operating on
the powered handle C located under the tailgate edge.
The tailgate can be opened at any time, if the doors
are unlocked. To open it, enable the handle, opening
one of the front doors or unlocking the doors by
the remote control or using the key without remote
control. If the boot is not shut properly the instru-
ment panel warning light ´(if any) will come on.
65KNOW YOUR
VEHICLESAFETY
CORRECT USE
OF THE CAR
WARNING LIGHTS
AND MESSAGES
IN
AN EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
065-090 PANDA EN 7-10-2009 13:45 Pagina 65

Open the tailgate with care when carrying
objects on the roof rack to prevent injuries.
WARNING
A heavy load that has not been secured
may cause serious injuries in case of
accident.
WARNING
EXTENDING THE BOOT
(versions with fixed rear seat) fig. 76
To extend the boot, proceed as follows:
1) The parcel shelf removed can be placed transversally
behind the backrests. To remove, release the two catch-
es A (one each side) from their locations and pull the par-
cel shelf outwards.
2) Operate the levers on the backrests outer side and tilt
the backrest forwards shifting aside the seat belt.
For three-point central seat belts see paragraph “Use of
the central seat belt” in chapter “Safety devices”.
To bring back the seat in its standard position: lift the back-
rest and push it backwards until you hear the locking click
and make sure the seat belts are at the front of the back-
rest.
Upon demand the car can be fitted with split rear seat.The boot extension possibilities offered by the split seat
are many and can be chosen according to the number of
passengers and the amount of luggage to be carried:
❒
total extension with right and left side of the seat tilt-
ed as described above;
❒
partial extension with left or right side of the seat tilt-
ed and place only for one person on the rear seat.
IMPORTANT If in a rather heavy load is being carried in
the boot and you are travelling at night, check and adjust
the main beam headlights aiming (see “Headlights” in this
section).fig. 76
F0Z0131m
67KNOW YOUR
VEHICLESAFETY
CORRECT USE
OF THE CAR
WARNING LIGHTS
AND MESSAGES
IN
AN EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
065-090 PANDA EN 7-10-2009 13:45 Pagina 67

Once you have released the adjustment
lever, always check that the seat is locked
on the guides by trying to move it back and forth.
Failure to lock the seat in place could result in the
seat moving suddenly and the driver losing control
of the car.
WARNING
Restoring the seat position
To bring back the seat to its standard position: lift the seat
back and push it backwards until it locks and make sure
the seat belts are at the front of the seat back. EXTENDING THE BOOT
(versions with sliding rear seat) fig. 77 and 78
Partial extension
Use the lever A (in the passenger’s compartment) or
the central tab D in the boot to move the seat forward.
Total extension
Remove the parcel shelf as previously described (see ver-
sions with fixed rear seat).
Use the lever A or the central tab D in the boot to move
the seat to the required position (e.g. fully forward for to-
tal boot extension).
Lift lever B or C or pull side tabs E or F in the boot to
release the seat backrest section to tilt; act on both if you
want to tilt the whole backrest.
fig. 78
F0Z0258m
fig. 77
F0Z0257m
68
KNOW YOUR
VEHICLE
SAFETY
CORRECT USE
OF THE CAR
WARNING LIGHTS
AND MESSAGES
IN
AN EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
065-090 PANDA EN 7-10-2009 13:45 Pagina 68

71
F0Z00203m
fig. 82
ROOF RACK/SKI RACKSETTING THE FASTENERS fig. 82
The roof rack fasteners A are shown in the figure.
To secure the roof rack, remove the plugs B (two each
side).
An especially designed roof rack/ski rack is available from
Lineaccessori Fiat.
On some versions, roof rack bars can be provided as
an optional.
KNOW YOUR
VEHICLESAFETY
CORRECT USE
OF THE CAR
WARNING LIGHTS
AND MESSAGES
IN
AN EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
After travelling a few kilometres, check that
the attachment fastening screws are tight.
WARNING
Never exceed the max. allowed load ca-
pacity (see chapter “Technical specifica-
tions”).
065-090 PANDA EN 7-10-2009 13:45 Pagina 71

FRONT FOG LIGHT AIMING fig. 84
(for versions/markets where provided)
Contact a Fiat Dealership to have the fog lights properly
adjusted.ADJUSTING THE HEADLIGHTS WHEN
ABROAD fig. 85
Dipped headlights are adjusted to drive in the country
where the vehicle was originally purchased. When trav-
elling in countries with opposite driving direction, to avoid
blinding the drivers on the other side of the road, you need
to cover the headlight areas depending on the Highway
code of the country you are travelling in.
This is done using non-transparent sticker tape on
the headlights as shown in the figure. The figure show how
to change from left-hand drive to right-hand drive.
fig. 85
F0Z0691m
73KNOW YOUR
VEHICLESAFETY
CORRECT USE
OF THE CAR
WARNING LIGHTS
AND MESSAGES
IN
AN EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
065-090 PANDA EN 7-10-2009 13:45 Pagina 73

When the ABS cuts in and you feel the
brake pedal pulsating, do not raise foot,
but keep it pressed; in doing so you will stop in the
shortest amount of space possible depending on
the current road conditions.
WARNING
If the ABS system cuts in, it means that the
grip between the tyre and the road surface
is close to its limit: you must slow down to match
the speed to the road grip available.
WARNING
The ABS make the best use of the avail-
able grip but cannot increase it. You
should always drive carefully on slippery surfaces
and avoid any unnecessary risks.
WARNING
ABS SYSTEM (for versions/markets, where provided)
This system, which is an integral part of the braking sys-
tem, prevents one or more wheels from locking and slip-
ping in all road surface conditions, irrespective of the
intensity of the braking action, ensuring that the vehicle can
be controlled even during emergency braking.
The EBD system (Electronic Braking Force Distribution)
completes the system allowing the brake force to be dis-
tributed between the front and rear wheels.
IMPORTANT To get the maximum efficiency of the brak-
ing system, a bedding-in period of about 500 km is need-
ed: during this period it is better to avoid sharp, repeat-
ed and prolonged braking.
SYSTEM INTERVENTION
The driver can feel the ABS system has come into action
because the brake pedal pulsates slightly and the system gets
noisier: it means that the car speed should be altered to suit
the type of road surface.
74
KNOW YOUR
VEHICLE
SAFETY
CORRECT USE
OF THE CAR
WARNING LIGHTS
AND MESSAGES
IN
AN EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
065-090 PANDA EN 7-10-2009 13:45 Pagina 74

If only the
x
warning light on the instru-
ment panel lights up – together with
a message in the reconfigurable multifunction dis-
play (for versions/markets, where provided) – stop
the car immediately and contact the nearest
Fiat Dealership. Leakage of hydraulic fluid from
the braking system will compromise the operation
of the braking system, whether it is of the con-
ventional type or with ABS.WARNING
FAILURE WARNING
ABS failure fig. 86
It is indicated by the
>
warning light on the instrument
panel - together with the dedicated message in the re-
configurable multifunction display (for versions/markets,
where provided) - coming on (see “Warning lights
and messages” chapter).
In this case, the braking system will still be effective, al-
though without the extra capacity offered by the ABS sys-
tem. Drive carefully to the nearest Fiat Dealership to have
the system checked.
EBD failure fig. 87
It is indicated by the
>
and
x
warning lights on the in-
strument panel - together with the dedicated message
in the multifunction display (for versions/markets, where
provided) - coming on (see “Warning lights and messages”
chapter).In this case, the rear wheels may suddenly lock and the ve-
hicle may swerve when braking sharply. Drive carefully
to the nearest Fiat Dealership to have the system checked.
fig. 87
F0Z0159m
fig. 86
F0Z0158m
75KNOW YOUR
VEHICLESAFETY
CORRECT USE
OF THE CAR
WARNING LIGHTS
AND MESSAGES
IN
AN EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
065-090 PANDA EN 7-10-2009 13:45 Pagina 75