fuses FIAT PANDA 2009 169 / 2.G Owners Manual

149KNOW
YOUR VEHICLE
SAFETY
CORRECT USE
OF THE CAR
WARNING LIGHTS
AND MESSAGESIN
AN EMERGENCYCAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
CHANGING A BULBGENERAL INSTRUCTIONS❒
Before changing a bulb check the contacts for oxidation;
❒
burnt bulbs must be replaced by others of the same type
and power;
❒
always check the headlight beam aiming after changing
a bulb;
❒
when a light is not working, check that the corre-
sponding fuse is intact before changing a bulb. For the
location of fuses, refer to the paragraph “Replacing fus-
es” in this chapter.
Modifications or repairs to the electric sys-
tem that are not carried out properly or
do not take the system technical specifications in-
to account can cause malfunctions leading to the
risk of fire.
WARNING
Halogen bulbs contain gas under pressure;
if they break, glass fragments may be dis-
persed.
WARNING
When handling halogen bulbs, only touch
the metal part. If the transparent bulb is
touched with the fingers, its lighting inten-
sity is reduced and life of the bulb may be com-
promised. In the event of accidental contact, wipe
the bulb with a cloth moistened with alcohol
and leave it to dry.
IMPORTANT The headlight inner surface might be slight-
ly misted: this should not be considered irregular rather
a natural phenomenon due to low temperature and the air
humidity level. Misting will disappear as soon as the head-
lights are turned on. The presence of drops inside the
headlights indicates infiltration of water. Contact a Fiat
Dealership.
Where possible, it is advisable to have bulbs
changed at a Fiat Dealership. The correct
operation and aiming of the outer lights are
absolutely important to the safety of the car and
its passengers and the subject of specific laws about
road traffic.
135-168 PANDA EN 7-10-2009 14:07 Pagina 149

160KNOW
YOUR VEHICLE
SAFETY
CORRECT USE
OF THE CAR
WARNING LIGHTS
AND MESSAGES
IN
AN EMERGENCYCAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
F0Z0087m
fig. 165
Refer to the tables on the following pages to identify the
protection fuse.
If a general fuse (MEGA-FUSE, MIDI-
FUSE, MAXI-FUSE) cuts in, do not at-
tempt any repair and contact a Fiat Dealership.
WARNING
Before replacing a fuse, make sure the ig-
nition key has been removed and that all
the other services are switched off and/or
disengaged.If the replaced fuse blows again, contact
a Fiat Dealership.
WARNING
Never replace a blown fuse with metal
wires or other recovered material.
WARNING
Never replace a fuse with another of high-
er power: FIRE HAZARD.
WARNING
REPLACING FUSESGENERAL FEATURES fig. 165
Fuses protect the electric system: they cut in (i.e. they
blow) in the event of a failure or improper action on the
system.
When a device does not work, check the efficiency of its
fuse: the filament A must be intact. If it is, replace the blown
fuse with another with the same amperage (same colour).
B undamaged fuse.
C fuse with damaged filament.
To facilitate fuse replacement, use the pliers D hooked
to the fuse-box on the dashboard left-hand side.
135-168 PANDA EN 7-10-2009 14:07 Pagina 160

162KNOW
YOUR VEHICLE
SAFETY
CORRECT USE
OF THE CAR
WARNING LIGHTS
AND MESSAGES
IN
AN EMERGENCYCAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
A second fuse-box is located on the right-hand of the en-
gine compartment, next to the battery; to reach it re-
lease the spring I, the tabs M and remove the lid L.
The number identifying the electrical component corre-
sponding to each fuse is on the cover back.
fig. 168
fig. 169
F0Z0652m
F0Z0704m
Fuses in the engine compartment fig. 168 and 169
135-168 PANDA EN 7-10-2009 14:07 Pagina 162

219KNOW
YOUR VEHICLE
SAFETY
CORRECT USE
OF THE CAR
WARNING LIGHTS
AND MESSAGES
IN
AN EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONSINDEX
Fuse replacement
– fuse location
(control units) ............. 161-162
– general information
and warnings ........................... 160
– list .......................... 163-164-165
Fuse summary
table ...............................163-164-165
Fuses:
– fuse location
(central units) ...................161-162
– general instructions
and warnings ........................... 160G
earbox use ................................ 114
Gearbox ......................................... 114
– technical specifications ......... 195
Gearshifting lever ........................ 114
Glove compartment ................... 57
Glove compartments .................. 57
Gloveboxes ................................... 56
H
andbrake ................................... 113
Handbrake lever .......................... 113Hazard warning lights
– switching on ............................ 53
Headlight aiming
(corrector) ................................. 72
Headlight
– alignment corrector .............. 72
– bulb replacement ................... 153
– bulbs (type) ............................. 150
Headlights
(switching on controls) ............ 48
Headlights ...................................... 72
– adjusting the headlights when
abroad ...................................... 73
– beam adjustment ................... 72
– bulb replacement ................... 153
– headlight beam aiming .......... 72
Headrests
– front ......................................... 33
– rear ........................................... 34
Headrests
– front ......................................... 33
– rear ........................................... 34
Heated rear window....... 54-55-72
Heating and ventilation system ... 37Heating and ventilation .............. 37
– adjustable side and
centre vents ............................ 37
– controls ................................... 38
– front window
defrosting/demisting ............. 39
– passenger compartment
heating and ventilation ......... 39
– rear window defrosting/
demisting ................................. 40
Hill holder system ....................... 76
Ignition barrel .............................. 10
Ignition switch .............................. 10
Ignition switch and steering
column lock ................................ 9-10
Ignition switch .............................. 9
In an emergency..................... 135
Installing the tow hook .............. 118
Instrument panel .......................... 11
Interior equipment ...................... 55
Interior fittings ............................. 55
Interiors (cleaning) ...................... 190
Internal lighting ............................. 52
215-224 PANDA EN 7-10-2009 15:09 Pagina 219