HONDA ACCORD HYBRID 2023 Owners Manual
Manufacturer: HONDA, Model Year: 2023, Model line: ACCORD HYBRID, Model: HONDA ACCORD HYBRID 2023Pages: 627, PDF Size: 23 MB
Page 401 of 627

Continued399
uuWhen Driving uBlind Spot Information System
Driving
■When the system detects a vehicle
Blind spot information system alert indicator: 
Located on the outside door mirror on both 
sides.
Comes on when:
•A vehicle approaches you from behind to 
overtake you at a speed difference of no 
more than about 31 mph (50 km/h).
• You pass a vehicle at a speed difference of 
no more than about 12 mph (20 km/h).
Blinks and a beeper sounds when:
You use the turn signal lever to signal a turn in 
the direction of the detected vehicle while the 
blind spot information system alert indicator is 
on. u The beeper sounds three times.1Blind Spot Information System
For proper blind spot information system operation:
•Always keep the rear  bumper and area around the 
radar sensors clean.
•Do not cover the rear bumper corner area with 
labels or sticke rs of any kind.
The system is for your convenience only. Even if an 
object is within the alert zone, the following 
situations may occur:
•The blind spot informatio n system alert indicator 
does not come on and the message  Blind spot 
information system not available  appears on 
the driver information interface.
•The blind spot informatio n system alert indicator 
may come on even with  the message displayed.
The Vehicle Stability Assist
TM (VSA ®) system, Adaptive 
Cruise Control (ACC) with Low Speed Follow, safety 
support, low tire pressure/TPMS
*, and parking brake 
and brake system (amber) indicators may come on in 
amber along with a message in the driver information 
interface when you set the power mode to ON after 
reconnecting the 12-volt battery.
Drive a short distance at more than 12 mph (20 km/h). 
Each indicator should go off. If any do not, have your 
vehicle checked by a dealer.
Comes On
Blinks
* Not available on all models
23 ACCORD 4D US HEV MAP-3130B6000.book  399 ページ  2022年10月13日 木曜日 午後4時50分 
Page 402 of 627

uuWhen Driving uBlind Spot Information System
400
Driving
You can turn the system on and off us ing the driver information interface.
2Switching the Display P. 119
2 Safety Support  P. 129
The blind spot information system will stay  on the previously selected on or off 
setting each time you turn the power system on.
■Blind Spot Information System On and Off1 Blind Spot Information System
You can change the settings for the blind spot 
information system.
2 Customized Features  P. 318
23 ACCORD 4D US HEV MAP-3130B6000.book  400 ページ  2022年10月13日 木曜日 午後4時50分 
Page 403 of 627

401
uuWhen Driving uBlind Spot Information System
Driving
The blind spot information system alert indicator may not come on under the 
following conditions:
• There is a large speed difference between  your vehicle and the vehicle in the 
adjacent lane.
• A vehicle is parked in a side lane.
• An object not detected by the radar sensors approaches or passes your vehicle.
• The vehicle driving in the ad jacent lane is a motorcycle or other small vehicle.
The blind spot information system may  not operate correctly under the following 
conditions:
• Making a turn at an intersection.
• Objects (guard rails, poles,  trees, etc.) are detected.
• An object that does not reflect radio wave s well or a motorcycle is in the alert 
zone.
• Driving on a curved road.
• A vehicle is moving from a far lane to the adjacent lane.
• The system picks up signal interference su ch as other radar sensors from another 
vehicle or strong radio wave tra nsmitted from a facility nearby.
• The rear bumper or the area around the  radar sensors is covered by dirt, mud, 
snow, ice, etc.
• The rear bumper or the area around the radar sensors has been damaged or 
deformed.
• In bad weather (heavy rain, snow, and fog).
• Making a short turn or driving on a bump y road that slightly tilts the vehicle.
• An object such as a bicycle rack is  attached to the rear of the vehicle.
■Blind Spot Information System Conditions and Limitations
23 ACCORD 4D US HEV MAP-3130B6000.book  401 ページ  2022年10月13日 木曜日 午後4時50分 
Page 404 of 627

402
uuWhen Driving uHigh Voltage Battery
Driving
High Voltage Battery
The High Voltage battery gradually discharges  even if the vehicle is not in use. As a 
result, if your vehicle is parked for an  extended period of time, the battery charge 
level will become low. Extended periods of ti me at a low state of charge will shorten 
battery life. To maintain the battery state of  charge, drive your vehicle for more than 
30 minutes at least once every three months.
Extreme high temperatures can affect the battery life. You can minimize the effects 
by parking the vehicle in the shade during the summer.1 High Voltage Battery
Be careful not to let the  High Voltage battery drain 
too much. If the battery level becomes close to zero, 
it will make it impossible to start the engine.
23 ACCORD 4D US HEV MAP-3130B6000.book  402 ページ  2022年10月13日 木曜日 午後4時50分 
Page 405 of 627

403Continued
Driving
Honda Sensing®
Honda Sensing® is a driver support system which employs the use of three distinctly 
different kinds of sensors: a radar sensor located behind the Honda emblem on the 
front grille, a front sensor camera mounted to the interior side of the windshield 
behind the rearview mirror,  and the sonar sensors located in the front and rear 
bumpers.
Honda Sensing ® is a driver support system which employs the use of two distinctly 
different kinds of sensors: a radar sensor  located behind the Honda emblem on the 
front grille and a front sensor camera mounte d to the interior side of the windshield 
behind the rearview mirror.
Honda Sensing ® has the following functions.
■The functions which do not requir e switch operations to activate
• Collision Mitigation Braking SystemTM (CMBSTM) 2 P. 406
• Low Speed Braking Control* 2 P. 418
• Road Departure Mitigation System 2 P. 465
• Traffic Sign Recognition System 2 P. 473
■The functions wh ich require switch operations to activate
• Adaptive Cruise Control ( ACC) with Low Speed Follow 
2 P. 424
• Lane Keeping Assist System (LKAS) 2 P. 445
• Traffic Jam Assist 2 P. 456
Models with Low Speed Braking Control
Models without Low Speed Braking Control
* Not available on all models
23 ACCORD 4D US HEV MAP-3130B6000.book  403 ページ  2022年10月13日 木曜日 午後4時50分 
Page 406 of 627

404
uuHonda Sensing ®u
Driving
■ Button
Press to activate standby mode for ACC with 
Low Speed Follow.
Or press to cancel the system.
■LKAS Button
Press to activate standby mode for LKAS and 
Traffic Jam Assist.
Or press to cancel these systems.
■CANCEL Button
Press to cancel ACC with Low Speed Follow.
■Interval Button
Press to change the ACC with Low Speed 
Follow following-interval.
■RES/+/SET/− Switch
Press the  RES/+/SET/− switch up to set or 
resume the ACC with Low Speed Follow or 
increase the vehicl e speed. Press the  RES/+/
SET/−  switch down to set the ACC with Low 
Speed Follow or decrease the vehicle speed.
■Operation Switches for the Adaptive Cruise Control (ACC) 
with Low Speed Follow/Lane Keeping Assist System (LKAS)/
Traffic Jam Assist
Interval Button
 Button
LKAS Button
CANCEL  Button
RES/J/SET/−  Switch
23 ACCORD 4D US HEV MAP-3130B6000.book  404 ページ  2022年10月13日 木曜日 午後4時50分 
Page 407 of 627

405
uuHonda Sensing ®u
Driving
You can see the current state of Adaptive Cruise Control (ACC) with Low Speed 
Follow, Lane Keeping Assist System  (LKAS) and Traffic Jam Assist.
aIndicates that ACC with Low Speed Follow 
is ready to be activated.
• Green, White/Green: The system is on.
u White/Green indicates  that a vehicle is 
not detected ahead.
• White: The system is on standby.
• Amber: There is a problem with the system.
bIndicates that LKAS or Traffic Jam Assist is 
ready to be activated.
• Green: The system is on.
• White: The system is standby.
• Amber: There is a problem with the system.
cIndicates that LKAS or Traffic Jam Assist is 
activated and whether or not traffic lane 
lines are detected.
• Green lines: The system is on.
• White lines: Traffic lane lines are detected.
• Amber line: Lane departure is detected.
dIndicates whether or not a vehicle is 
detected ahead.
• Control target vehicle:  White and outlined 
in green
• Outside of control target vehicle: Gray
eIndicates that ACC with Low Speed Follow 
shows the set vehicle speed.
fIndicates that ACC with Low Speed Follow 
shows the set vehicle interval.
■Gauge Content1Gauge Content
You can have the head-up display show you the 
current state of each function.
2 Head-Up Display
* P. 135
Models with Head-up display
* Not available on all models
23 ACCORD 4D US HEV MAP-3130B6000.book  405 ページ  2022年10月13日 木曜日 午後4時50分 
Page 408 of 627

406
uuHonda Sensing ®u Collision Mitigation Braking SystemTM (CMBSTM)
Driving
Collision Mitigati on Braking SystemTM (CMBSTM)
The system can assist you when it determin es there is a possibility of your vehicle 
colliding with a vehicle (including moto rcycles) ahead from behind, an oncoming 
vehicle in front, a pedestrian, or someone riding a bicycle (moving bicycle). 
The CMBS
TM is designed to alert you when the po tential for a collision is determined, 
as well as assist in reducing speed, avoiding collisions, and reducing collision 
severity.
1 Collision Mitigation Braking SystemTM (CMBSTM)
Important Safety Reminder
The CMBS
TM is designed to reduce the severity of an 
unavoidable collision. It does not prevent collisions 
nor stop the vehicle automati cally. It is still your 
responsibility to operate the brake pedal and steering 
wheel appropriately acco rding to the driving 
conditions.
The CMBS
TM may not activate or may not detect a 
vehicle in front of y our vehicle under certain 
conditions:
2 CMBS
TM Conditions and Limitations  P. 411
For directions on the prop er handling of the radar 
sensor, refer to the following page. 2 Radar Sensor  P. 481
You can read about handling information for the 
camera equipped with this system. 2 Front Sensor Camera  P. 479
When the CMBS
TM is activated, it will continue to 
operate even if the accele rator pedal is partially 
depressed. However, it w ill be canceled if the 
accelerator pedal is fully depressed.
23 ACCORD 4D US HEV MAP-3130B6000.book  406 ページ  2022年10月13日 木曜日 午後4時50分 
Page 409 of 627

Continued407
uuHonda Sensing ®u Collision Mitigation Braking SystemTM (CMBSTM)
Driving
■How the system works
The CMBS
TM will be canceled when your vehicl e stops or the system determines 
there no longer is the  potential for a collision.
The CMBS
TM may also be canceled when a driver operates the steering wheel and 
the brake or accelerator pe dal to avoid a collision.
1How the system works
The camera in the CMBS
TM is also designed to detect 
pedestrians.
However, this pedestrian  detection feature may not 
activate or may not detect  a pedestrian in front of 
your vehicle under certain conditions.
Refer to the ones indicating  the pedestrian detection 
limitations from the list. 2 CMBS
TM Conditions and Limitations  P. 411A front sensor 
camera is located 
behind the 
rearview mirror.
The system starts monitoring the roadway ah ead when your vehicle speed is about 
3 mph (5 km/h) or above and will search for a vehicle, pedestrian, or moving bicycle 
in front of you.
The CMBS
TM activates when:●The speed difference between your vehicle and a vehicle, pedestrian, or moving 
bicycle detected in front of you becomes about 3 mph (5 km/h) and over with a 
chance of a collision.
●Your vehicle drives at about 18 mph (30 km/h) or less and there is a chance of a 
frontal collision with a detected oncoming vehicle when you turn left at an 
intersection.
●Your vehicle speed is about 62 mph (100 km/h) or less and the system determines 
there is a chance of a collision with:
- An oncoming or stationary vehicle detected in front of you.
- A pedestrian or moving bicycle detected in front of you.
When to use
The radar sensor is 
behind the Honda 
emblem on the 
front grille.
23 ACCORD 4D US HEV MAP-3130B6000.book  407 ページ  2022年10月13日 木曜日 午後4時50分 
Page 410 of 627

uuHonda Sensing ®u Collision Mitigation Braking SystemTM (CMBSTM)
408
Driving
■When the system activates
You can change the distance ( Long/Normal /Short ) between vehicles at which the 
system’s earliest collision alert will come  on through the audio/information screen 
setting options.
2 Customized Features  P. 318
1When the system activates
The head-up warning uses a  lens located at the front 
end of the dashboard.
Do not cover the lens or  spill any liquid on it.
Models with Head-up display
Lens
The system provides visual and audible alerts  of a possible collision, and stops if the 
collision is avoided.
u Take appropriate action to prevent a collision (apply the brakes, change 
lanes, etc.)
Visual Alerts Beep
Audible Alert
Head-up Warning Lights
*
* Not available on all models
23 ACCORD 4D US HEV MAP-3130B6000.book  408 ページ  2022年10月13日 木曜日 午後4時50分