fuel ISUZU TROOPER 1995 Workshop Manual

1(H;4 BODY
FUEL FILLER LID OPENER CABLE
2
1
8 8
Chassis harness
DETAIL D
-To lever
Cable
rking
p
~C~~C~~C~~Todooc r
Removal steps 1. Front seat (RH)
2. Rear door sill plate (RH)(L·W·B)
3. Center pillar lower trim cover (L·W.B)
4. Rear end floor trim cover
1••1 REMOVAL
Preparation: Battery ground cable
1. Front seat (RHl
2. Rear door sill plate (RH) (l·W·Bl
5. Luggage side trim panel (RH) 6. Fuel filler lid opener
7. Center console assembly 8. Fuel filler lid opener cable
Fig. 10-125
3. Center pillar lower trim cover (l·W·Bl
4. Rear end floor trim panel
5. Luggage side trim panel (RHl
• Refer to "INTERIOR TRIM PANELS" in this
section.
6.
Fuel filler lid opener (Fig. 10-126)
•
Remove opener 2 fixing screws and discon­
nect the
cable.
7. Center console assembly
8. Fuel filler lid opener cable
• Roll
up the floor carpet and remove the clips
of the chassis harness and body panel to pull
out the cable toward the fuel filler lid.
DETAIL C
~Chassis harness
/~ ~
DETAIL A DETAIL B
Installation steps To install, follow the removal steps in the reverse order.
Fig. 10-126

I•+IINSTALLATION
To install, follow the removal steps in the reverse
'-""' order, noting the following points.
1. Insert the opener cable into the body panel
securely.
(Fig. 10-127)
Fuel filler lid Body panel
Fuel filler lid opener cable
Fig. 10-127
2. Install the cable and clips to its original
position to the chassis harness and the body
panel.
3. Check that the opener operates smoothly.
FUEL FILLER DOOR
Fig. 10-128
1++1 REMOVAL
1. Fuel filler door
I•+IINSTALLATION
1. Fuel filler door
1. Fuel filler door
BODY 10-65