open bonnet Lancia Delta 2010 Owner handbook (in English)

6GETTING TO KNOW YOUR CAR
DASHBOARD
The presence and position of controls, instruments and gauges may vary according to different versions.
1. Air vent for side windows - 2. Adjustable air vent - 3. Exterior lighting control lever - 4. Instrument panel -
5. Windscreen wiper/rearscreen wiper/trip computer control lever - 6. Adjustable air vents - 7. Hazard warning lights
- 8. Passenger front air bag - 9. Glove compartment - 10. Dashboard controls - 11. Climate controls - 12. Ignition key
and ignition device - 13. Driver front air bag - 14. Driver front knee air bag (for versions/markets, where provided) -
15. Steering lock lever - 16. Fuse box access flap - 17. Bonnet opening lever.
fig. 1L0E0001m
001-142 Delta 3ed gb 30-11-2009 11:21 Pagina 6

GETTING TO KNOW YOUR CAR13
1
“Dualdrive” electric power steering
failure (red)
This warning light comes on when the ignition
key is turned to MAR, but it should go off after a
few seconds.
If the warning light (or symbol on the display) remains on,
you will not have steering assistance and the effort required
to operate the steering wheel will be increased; steering is,
however, possible. In this case contact a Lancia Dealership.
The display will show a dedicated message.
g
“Dualdrive” electric steering engagement
The warning light comes on (or the word
“CITY” appears on the display) when the
“Dual drive” electric power steering system is ac-
tivated by pressing the relevant control button. Pressing
the button again causes the “CITY” indication to go off.
CITY
Excessive engine coolant temperature
(red)
This warning light comes on when the ignition
key is turned to MAR, but it should go out after
a few seconds. The warning light turns on when the en-
gine is overheated. If the warning light comes on, pro-
ceed as follows:
❍during normal travel: stop the car, stop the engine and
check that the water level in the reservoir is not un-
der the MIN line.
u
If it is, wait for a few minutes for the engine to cool down,
then slowly and carefully open the cap, top-up with coolant
and check that the level is between the MIN and MAX ref-
erences on the reservoir. Also check for leaks. Should the
warning light turn on again at the next start-up, contact
a Lancia Dealership.
❍If the vehicle is used under harsh conditions (e.g. tow-
ing of trailers uphill or fully loaded vehicle): slow down
and stop the car if the warning light stays on. Stop
for 2 or 3 minutes with the engine running and slight-
ly accelerated to favour better coolant circulation. Then
stop the engine. Check correct liquid level as described
above.
IMPORTANT Over demanding routes, it is advisable to
keep the engine on and slightly accelerated for a few min-
utes before switching it off.
The display will show a dedicated message.
Doors not closed correctly (red)
This warning light (or symbol on the display)
lights up when one or more doors are not closed
correctly. A buzzer will sound when doors are
open and the car is moving. On the multifunctional dis-
play, the warning light also comes on when the bonnet
and/or tailgate are not closed correctly. The display will
show a dedicated message.
´
001-142 Delta 3ed gb 30-11-2009 11:21 Pagina 13

GETTING TO KNOW YOUR CAR41
1
fig. 13L0E0106m
Replacing the remote control cover fig. 13
To replace the remote control cover, follow the procedure
shown in the diagram.ALARM
(for versions/markets, where provided)
The alarm, which is provided in addition to the remote
control functions described previously, is controlled by a
receiver located under the dashboard, near the fuse box.
ALARM TRIPPING
The alarm trips in the following cases:
❍when a door, the bonnet or the tailgate is opened ille-
gally (perimeter protection);
❍when the ignition system is operated (ignition key ro-
tated to MAR);
❍when the battery cables are cut;
❍when someone is moving inside the passenger com-
partment (volume-sensing protection);
❍when the vehicle is lifted or tilted.
According to the market, when the alarm is tripped this
operates the alarm siren and direction indicators (for ap-
proximately 26 seconds). Alarm tripping and the number
of cycles depend on the sales market.
There are a maximum number of acoustic/visual cycles.
When this is reached the system returns to normal oper-
ation.
The volume sensing and anti-tilt protection can be ex-
cluded by adjusting the dedicated control on the front
courtesy light (see “volume sensing/anti-tilt protection”).
001-142 Delta 3ed gb 30-11-2009 11:21 Pagina 41

GETTING TO KNOW YOUR CAR97
1
fig. 65L0E0053m
BONNET
OPENING fig. 65
Proceed as follows:
❍pull lever A in the direction indicated by the arrow;
❍operate lever B as shown in the diagram;
❍lift the bonnet and at the same time release support
rod C from its catch, then insert the end of the rod in-
to seat D in the bonnet (larger hole) and push to safe-
ty position (smaller hole), as shown in the diagram.
Incorrect positioning of the support rod may
cause the bonnet to drop suddenly. Perform these
operations when the car is stationary only .
Before lifting the bonnet, ensure that the
wiper arm is not lifted from the windscreen.
001-142 Delta 3ed gb 30-11-2009 11:22 Pagina 97

98GETTING TO KNOW YOUR CAR
With the engine hot, work with caution inside
the engine compartment to avoid burns. Do
not place your hands near the fan: it may
switch on even if the ignition key has been removed.
Wait for engine cooling.
Pay attention to scarves, ties and other loose
fitting garments. If they accidentally touch
moving parts, they may get dragged in, pos-
ing serious risk to the wearer.
To close fig. 65
Proceed as follows:
❍hold the bonnet up with one hand and with the other
remove rod C from seat D and fit it back into its catch;
❍lower the bonnet to approximately 20 centimetres
above the engine compartment and let it drop. Make
sure that the bonnet is completely closed and not on-
ly fastened by the safety catch by trying to open it. If
it is not fully closed, open the bonnet and repeat the
procedure. Do not simply press it.
For safety reasons, the bonnet must always
be fully closed while travelling. Make sure
that the bonnet is perfectly closed and that
the lock is engaged. If you discover that the bonnet
is not perfectly closed while travelling, stop imme-
diately and close the bonnet in the correct manner.
001-142 Delta 3ed gb 30-11-2009 11:22 Pagina 98

240CARE AND MAINTENANCE
To wash the car correctly, proceed as follows:
❍remove the aerial from the roof to prevent damage to
it if the car is washed in an automatic system;
❍in washing stations keep the steam jet/high pressure
washing nozzles at least 40 cm away from the body-
work to prevent damage. Remember that in the long-
term puddles of water can damage the car;
❍wash the body using a low pressure jet of water;
❍wipe a sponge with a slightly soapy solution over the
bodywork, frequently rinsing the sponge;
❍rinse well with water and dry with a jet of air or leather
pad.
When drying take care to dry the least exposed parts where
the water could collect most easily. It is a good idea to leave
the car in the open for a while after washing it to give time
for the water to evaporate.
Do not wash the car after it has been parked in the sun
or when the engine is bonnet is hot: this could take the
shine off the paint. ADVICE FOR PRESERVING THE BODYWORK
Paint
Paintwork does not only serve an aesthetic purpose, but
also protects the underlying sheet metal.
Touch up abrasions and scratches immediately to prevent
the formation of rust. Only use genuine spare paint prod-
ucts for touch-ups (see “Bodywork paint identification
plate” in the “Technical Specifications” section).
Normal maintenance of paintwork consists in washing the
car: the frequency depends on the conditions and envi-
ronment where the car is used. For example, it is advis-
able to wash the car more often in areas with a high en-
vironmental pollution or on roads sprinkled with salt.
215-242 Delta 3ed gb 11-11-2009 12:14 Pagina 240