Lexus CT200h 2014 (in English) Repair Manual

611-1. For safe use
1
For safety and security
CT200h_OM_OM76135E_(EE)
Installing child restraints
Seat belts (An ELR belt requires a lock-
ing clip.)
ISOFIX rigid anchors (ISOFIX child
restraint system)
Lower anchors are provided for the out-
board rear seats. (Buttons displaying the
location of the anchors are attached to
the seats.)
Anchor brackets (for top strap)
An anchor bracket is provided for out-
board rear seats.
Follow the child restraint system manufacturer’s instructions. Firmly secure
child restraints to the seats using a seat belt or ISOFIX rigid anchors. Attach
the top strap when installing a child restraint.
CT200h_OM_OM76135E_(EE).book Page 61 Friday, May 30, 2014 11 :14 AM

621-1. For safe use
CT200h_OM_OM76135E_(EE)
■Rear facing  Baby seat/child seat
Place the child restraint system
on the rear seat facing the rear of
the vehicle.
Run the seat belt through the
child restraint system and insert
the plate into the buckle. Make
sure that the belt is not twisted.
Keep the lap portion of the belt
tight.
Install a locking clip near the tab
of the lap and shoulder belt by
inserting the lap and shoulder
webbing through the recesses of
locking clip.
■Forward-facing  Child seat
Adjust the head restraint to the
upmost position.
Installing child restraints using a seat belt
1
2
3
1
CT200h_OM_OM76135E_(EE).book Page 62 Friday, May 30, 2014 11 :14 AM

631-1. For safe use
1
CT200h_OM_OM76135E_(EE)
For safety and security
Place the child restraint system
on the seat facing the front of the
vehicle.
Run the seat belt through the
child restraint system and insert
the plate into the buckle. Make
sure that the belt is not twisted.
Keep the lap portion of the belt
tight.
Install a locking clip near the tab
of the lap and shoulder belt by
inserting the lap and shoulder
webbing through the recesses of
locking clip.
■Junior seat Place the child restraint system
on the seat facing the front of the
vehicle.
2
3
4
1
CT200h_OM_OM76135E_(EE).book Page 63 Friday, May 30, 2014 11 :14 AM

641-1. For safe use
CT200h_OM_OM76135E_(EE)
Sit the child in the child restraint
system. Fit the seat belt to the
child restraint system according
to the manufacturer’s instructions
and insert the plate into the
buckle. Make sure that the belt is
not twisted.
Check that the shoulder belt is cor-
rectly positioned over the child’s
shoulder and that the lap belt is as
low as possible. ( →P. 3 8 )
Press the buckle release button and
fully retract the seat belt.
Open the fasteners on the lower
part of the seatback.
2
Removing a child restraint installed with a seat belt
Installation with ISOFIX rigid anchor (ISOFIX child restraint system)
1
CT200h_OM_OM76135E_(EE).book Page 64 Friday, May 30, 2014 11 :14 AM

651-1. For safe use
1
CT200h_OM_OM76135E_(EE)
For safety and security
Adjust the head restraint to the
upmost position.
Check the positions of the exclusive
fixing bars, and install the child
restraint system to the seat.
The bars are installed in the clearance
between the seat cushion and seatback.
If the child restraint has a top strap, the
top strap should be latched onto the
anchors.
Adjust the head restraint to the
upmost position.
2
3
Child restraint systems with a top strap
1
CT200h_OM_OM76135E_(EE).book Page 65 Friday, May 30, 2014 11 :14 AM

661-1. For safe use
CT200h_OM_OM76135E_(EE)
Secure the child restraint system
using the seat belt or ISOFIX rigid
anchors.
Open the anchor bracket cover,
latch the hook onto the anchor
bracket and tighten the top strap.
Make sure the top strap is securely
latched.
■When installing a child restraint system
You need a locking clip to install the child restraint system. Follow the instructions pro-
vided by the manufacturer of the system. If yo ur child restraint system does not provide a
locking clip, you can purchase the following item from any authorized Lexus dealer or
repairer, or another duly qualified and eq uipped professional: Locking clip for child
restraint system
(Part No. 73119-22010)
2
3
WA R N I N G
■When installing a child restraint system
Follow the directions given in the child restra int system installation manual and fix the
child restraint system securely in place.
If the child restraint system is not correctly fixed in place, the child or other passengers
may be seriously injured or even killed in the event of sudden braking, sudden swerving
or an accident.
●If the driver’s seat interferes with the child
restraint system and prevents it from being
attached correctly, attach the child restraint
system to the right-hand rear seat (left-hand
drive vehicles) or the left-hand rear seat
(right-hand drive vehicles).
●Adjust the front passenge r seat so that it does
not interfere with the child restraint system.
CT200h_OM_OM76135E_(EE).book Page 66 Friday, May 30, 2014 11 :14 AM

671-1. For safe use
1
CT200h_OM_OM76135E_(EE)
For safety and security
WA R N I N G
■When installing a child restraint system
●Only put a forward-facing child restraint sys-
tem on the front seat when unavoidable.
When installing a forward-facing child
restraint on the front passenger seat, move
the seat as far back as possible.
Failing to do so may result in death or serious
injury if the airbags deploy (inflate).
●Never use a rear-facing child restraint system
on the front passenger seat when the airbag
manual on-off switch is on. ( →P. 5 1 )
The force of the rapid inflation of the front
passenger airbag can cause death or serious
injury to children in the event of an accident.
●There is a label(s) on the passenger side sun
visor, indicating it is forbidden to attach a rear-
facing child restraint system to the front pas-
senger seat.
Details of the label(s) are shown in the illustra-
tion below.
CT200h_OM_OM76135E_(EE).book Page 67 Friday, May 30, 2014 11 :14 AM

681-1. For safe use
CT200h_OM_OM76135E_(EE)
WA R N I N G
■When installing a child restraint system
●If child restraint system regulations exist in the country where you reside, please con-
tact any authorized Lexus dealer or repair er, or another duly qualified and equipped
professional for the child restraint system installation.
●When a junior seat is installed, always en sure that the shoulder belt is positioned
across the center of the child’s shoulder. The belt should be kept away from the child’s
neck, but not so that it could fall off the child’s shoulder. Failing to do so may result in
death or serious injury in the event of su dden braking, sudden swerving or an acci-
dent.
●Ensure that the belt and plate are securely locked and the seat belt is not twisted.
●Shake the child restraint system left and right, and forward and backward to ensure
that it has been securely installed.
●After securing a child restraint system, never adjust the seat.
●Follow all installation instructions provided by the child restraint system manufacturer.
■To correctly attach a child restraint system to the anchors
When using the lower anchors, be sure that there are no foreign objects around the
anchors and that the seat belt is not caught behind the child restraint system. Make sure
the child restraint system is securely attached, or it may cause death or serious injury to
the child or other passengers in the event of a sudden stop, sudden swerve or accident.
CT200h_OM_OM76135E_(EE).book Page 68 Friday, May 30, 2014 11 :14 AM

691-1. For safe use
1
For safety and security
CT200h_OM_OM76135E_(EE)
Exhaust gas precautions
Harmful substance to the human body is included in exhaust gases if inhaled.
WA R N I N G
Exhaust gases include harmful carbon monoxi de (CO), which is colorless and odorless.
Observe the following precautions.
Failure to do so may cause exhaust gases enter the vehicle and may lead to an accident
caused by light-headedness, or may lead to death or a serious health hazard.
■Important points while driving
●Keep the back door closed.
●If you smell exhaust gases in the vehicle even when the back door is closed, open the
windows and have the vehicle inspected at any authorized Lexus dealer or repairer,
or another duly qualified and equipped professional as soon as possible.
■When parking
●If the vehicle is in a poorly ventilated area or a closed area, such as a garage, stop the
hybrid system.
●Do not leave the vehicle with the hybrid system on for a long time.
If such a situation cannot be avoided, park the vehicle in an open space and ensure
that exhaust fumes do not enter the vehicle interior.
●Do not leave the hybrid system operating in an area with snow build-up, or where it is
snowing. If snowbanks build up around the vehicle while the hybrid system is operat-
ing, exhaust gases may collect and enter the vehicle.
■Exhaust pipe
The exhaust system needs to be checked periodically. If there is a hole or crack caused
by corrosion, damage to a joint or abnormal exhaust noise, be sure to have the vehicle
inspected and repaired by any authorized Lexus dealer or repairer, or another duly
qualified and equipped professional.
CT200h_OM_OM76135E_(EE).book Page 69 Friday, May 30, 2014 11 :14 AM

701-2. Hybrid system
CT200h_OM_OM76135E_(EE)
Hybrid system features
The illustration is an example for explanation and may differ from the actual item. Gasoline engine
Electric motor (traction motor)
Your vehicle is a hybrid vehicle. It ha s characteristics different from conven-
tional vehicles. Be sure you are closely familiar with the characteristics of your
vehicle, and operate it with care.
The hybrid system combines the use of a gasoline engine and an electric
motor (traction motor) according to dr iving conditions, improving fuel effi-
ciency and reducing exhaust emissions.
1
2
CT200h_OM_OM76135E_(EE).book Page 70 Friday, May 30, 2014 11 :14 AM