MAZDA MODEL 6 2015 Smart Start Guide (in English)
Manufacturer: MAZDA, Model Year: 2015, Model line: MODEL 6, Model: MAZDA MODEL 6 2015Pages: 42, PDF Size: 6.01 MB
Page 21 of 42
20
www.MazdaUSA.com
ACCELERATOR PEDAL KICKDOWN SWITCH*
The accelerator pedal is equipped with a
kickdown switch to give the driver more
control and to improve fuel economy.
When you depress the accelerator 95% of the
way, you will feel an increase in resistance.
Push harder, and you will feel a click as you
activate the kickdown switch. The transmission
will usually downshift (depending on engine
speed) and the engine will switch to maximum
power mode. This kickdown switch function is
the same in both Manual mode and in “D”.
*Available on vehicles with automatic transmission only.
NOTE: The HL A system will hold the vehicle for a maximum of 2.0 seconds
while the driver is changing from the brake pedal to the accelerator pedal.
HILL LAUNCH ASSIST (HLA)
HL A helps assist you when
accelerating the vehicle from
a stop while on a hill or slope.
When the brake pedal is released
and the accelerator pedal is pushed, HLA prevents the vehicle from rolling
forward or backward. It operates on a downward slope when the shift lever
is in the reverse (R) position, and on an upward slope when the shift lever is
in a position other than the reverse (R) position.
1660320_15b_Mazda6_SSG_021714.indd 202/17/14 11:12 AM
Page 22 of 42
21
NOTE: Genuine Mazda Accessory Auto-Dimming Mirror with Compass and
Homelink is available at your Authorized Mazda Dealer.
HomeLink®
Refer to your Owner’s Manual for programming details.
AUTO-DIMMING MIRROR AND HOMELINK® (if equipped)
Auto-Dimming
Indicator LightAuto-Dimming
On
HomeLinkRear
Light
SensorAuto-Dimming
Off
Mirrors
REAR VIEW MONITOR (if equipped)
Placing the gearshift lever into Reverse automatically operates the Rear
View Parking Camera and is viewable via the 5.8” LCD screen.
Rear View Parking Camera
Rear View Monitor
NOTE: When using the Rear View Parking Camera, please check your
surroundings as objects may be closer than they appear.
1660320_15b_Mazda6_SSG_021714.indd 212/17/14 11:12 AM
Page 23 of 42
22
STORAGE
The Mazda6 is equipped with
several storage locations:
•
Glo
vebox
•
Ce
nter Console (including storage tray)
•
Doo
r Pockets
CUPHOLDERS
The Mazda6 is equipped with cup holders and bottle holders conveniently
located throughout the cabin.
Bottle Holder
The front cup holders are
located in the center console
behind the shifter and
commander switch (if equipped). The rear cup holders
are located on the
rear center armrest.
Bottle holders
are located on the
inside of the doors.
Commander Switch
SELECTING SCREEN BUTTON
1 Tilt and/or turn the commander
k nob to move the cursor to the
desired on-screen location. 2 Pus h the commander ENTER
button to select your choice on
the screen.
COMMANDER SWITCH (if equipped)
Select a button around the commander knob to operate the desired system.
AUDIO:
Audio screen
is displayed.
NAV:
Navigation screen
is displayed. PHONE:
Bluetooth®
dial screen
is displayed.
SETUP:
Setup setting
screen is
displayed.
:
Same operations
such as
on-screen button.
ENTER
CAUTION: Damage to the Commander Switch may occur if heavy objects are
placed on top of it.
1660320_15b_Mazda6_SSG_021714.indd 222/17/14 11:12 AM
Page 24 of 42
23
i-ELOOP
i-ELOOP (if equipped)
The Mazda-unique regenerative braking system (i-ELOOP) generates and
stores electrical energy in a capacitor during deceleration. Through efficient
energy regeneration, storage, and usage, fuel economy is improved.
i-ELOOP Pre-Charge Mode
If the capacitor is discharged because of vehicle storage (the vehicle \
is parked
for long periods of time), the Multi-Information Display will display t\
he following
i-ELOOP warning message after engine startup:
Multi-Information
Display
Regenerative
braking power
Capacitor power
storage
Capacitor
charge Capacitor
discharge
In Pre-charge mode Driving in Pre-charge mode
i-ELOOP
warning alarm sound
When the warning message is displayed, do not drive the vehicle. Allow the
engine to idle until the warning message is no longer displayed. This time is
needed for normal generator operation.
NOTE:
•
If
the vehicle is jump started, leave the jumper cables connected
until the warning message is no longer displayed.
•
If t
he vehicle is driven while the warning is displayed, a warning
sound will be heard and power steering assist will be limited.
1660320_15b_Mazda6_SSG_021714.indd 232/17/14 11:12 AM
Page 25 of 42
24
Smart City Brake Support
SMART CITY BRAKE SUPPORT (SCBS) SYSTEM
(if equipped)
The Smart City Brake Support (SCBS) system is designed to reduce
damage in the event of a collision by operating the brake control (SCBS)
when the system’s laser sensor detects a vehicle ahead:
• When your vehicle speed is 2 to 18 mph (4 to 30 km/h).
•
The
system determines that a collision with a vehicle ahead is unavoidable.
•
It m
ay be possible to avoid a collision if the relative speed between
your vehicle and the vehicle ahead is less than 9.3 mph (15 km/h).
•
Wh
en the driver depresses the brake pedal while the system is in
the operation range at about 2 to 18 mph (4 to 30 km/h), the brakes are
applied firmly and quickly to assist. (SCBS Automatic Brake is displayed
in the Multi-information Display)
•
SC
BS automatic brake is released approximately 2 seconds after the
vehicle comes to a stop.
Refer to your Owner’s Manual for complete details.
SCBS system can be turned
off using DSC Off button.
Laser Sensor
1660320_15b_Mazda6_SSG_021714.indd 242/17/14 11:12 AM
Page 26 of 42
25
Blind Spot Monitoring System
BLIND SPOT MONITORING (BSM) (if equipped)
The Blind Spot Monitoring (BSM) system is designed to assist the driver
by monitoring blind spots on both sides of the vehicle to the rear in
certain situations such as when changing lanes on roads and freeways or
reversing the vehicle from a parking garage.
The Blind Spot Monitoring (BSM) System consists of the Blind Spot Moni\
toring
(BSM) and Rear Cross Traffic Alert (RCTA).
Turning BSM System Off
Turning the BSM system off will turn off both the light and sound
indicators. To manually turn the BSM system off, push the BSM
OFF switch on the dash. The BSM OFF indicator will illuminate
in the instrument cluster when the BSM system is off. The BSM
system will automatically turn on the next time the vehicle is started.
•
If y
our vehicle speed is 6.7 mph (10.8 km/h) or more, the BSM will warn
you of vehicles in the detection area by illuminating the BSM warning
lights located on the left and right door mirrors.
•
If y
ou operate a turn signal in the direction of an illuminated BSM warning
light, the system will also warn you with a beep and warning light flash.
•
BS
M sensors are located under the left and right rear bumper areas.
The BSM system may not operate properly if the rear bumper gets too
dirty, so keep the rear bumper area clean.
Your Vehicle
Detection Areas
Please refer to
your Owner’s
Manual for
complete details.
NOTE: Do not rely completely on the BSM system and be sure to look
over your shoulder before changing lanes:
•
Th
e BSM can assist the driver in confirming the safety of the surroundings,
but is not a complete substitute.
•
The
driver is responsible for ensuring safe lane changes and other maneuvers.
•
Al
ways pay attention to the direction in which the vehicle is traveling and the
vehicle’s surroundings.
•
Th
e BSM does not operate when the vehicle speed is lower than about 6.7
mph (10.8 km/h).
1660320_15b_Mazda6_SSG_021714.indd 252/17/14 11:12 AM
Page 27 of 42
26
REAR CROSS TRAFFIC ALERT (RCTA) (if equipped)
The Rear Cross Traffic Alert (RCTA) is designed to alert the driver of
oncoming traffic when backing out of a parking spot. RCTA is active:
• When your vehicle is in reverse.
If your vehicle speed is 0 to 7.8 mph (0 to 12.6 km/h).
When BSM sensors detect an object moving more then 2.8 to
18.6 mph (4.5 to 29.9 km/h) (vehicle/motorcycle).
RCT
A will notify the driver with indicators and sound:
•
Rea
r View Monitor and outside mirror flashing indications.
•
Be
ep sound same as BSM.
Please refer to your Owner’s Manual for complete details.
Object Detected Object Detected
Rear View Monitorwww.MazdaUSA.com
1660320_15b_Mazda6_SSG_021714.indd 262/17/14 11:12 AM
Page 28 of 42
27
Dashboar d
vents
Dashboar
d
and floor vents
Floor
vents
Defr
oster and
floor vents
W
indshield
defroster
Manual Climate Control
NOTE: When set
to MA X A /C with
dashboard vents
or dashboard and
floor vents, the A /C
will turn on, and
recirculated air will
be selected for
maximum cooling.
Temperature
Control Dial
Rotate the dial for
temperatur
e control. Fan Control Dial
Rotate the dial to set desired
fan speed.
Push to recir
culate
cabin air to reduce
outside odors and
improve cooling.
Push for fresh
air circulation.
Push to manually turn air
conditioning on or off.
Push to defrost the
rear window.Mode Selector Dial
Rotate the dial to
select airflow mode.
Best Cooling Settings
Indicator ON (automatically)
NOTE: • When selecting either defroster mode ( or ), the air conditioner and fresh
air mode are automatically turned on by the system. This helps defrost the
windows more efficiently by dehumidifying the air. Manually set the fan control
and temperature control dials as desired.
•
In e
ither defroster mode (
or ), air will blow from the side dashboard vents.
To defrost the side windows faster, point the vents toward the side windows.
Best Heating Settings
1660320_15b_Mazda6_SSG_021714.indd 272/17/14 11:12 AM
Page 29 of 42
28
Automatic Climate Control
NOTE: Automatic climate
control will allow you to
maintain individual preset
cabin temperatures for the
driver and passenger when
DUAL mode is selected.
Driver Temperature
Control Dial
AUTO ON: Push dial
to turn Automatic Air
Conditioning system
on (indicator light on).
Rotate dial to select your
desired set temperature
(shown above). The
airflow mode and the
amount of airflow will be
automatically controlled
in accordance with the
set temperature.
Push to defrost
the windshield.
Push to defrost
the rear window.
Push to
manually turn
air conditioning
on or off.Passenger
Temperature
Control Dial
Push to turn DUAL
mode ON/OFF.
•
W
ith DUAL mode
ON (indicator on),
rotate the dial to
set passenger
side temperature
separate from
the driver’s side
(shown above).
•
With DUAL mode
OFF (indicator off),
driver controls the
temperature setting
on both sides.
Push to select the
following airflow mode:
Push to recirculate
cabin air to reduce
outside odors and
improve cooling.
Push for fresh
air circulation.
Dashboar
d vents
Dashboard
and floor vents
Floor vents
Defr
oster and
floor vents
NOTE: Automatic
temperature control
always works even
if the AUTO indicator
turns off by changing
the fan speed or the
airflow mode.
Fan Control Dial
•
Rotate the dial to
select the desir
ed
fan speed.
•
Push OFF to turn
climate control
system off.
1660320_15b_Mazda6_SSG_021714.indd 282/17/14 11:12 AM
Page 30 of 42
29
CD SlotAUDIO CONTROLS
Audio Controls (without 5.8” LCD screen)
POWER ON
Push the Volume/Power dial to turn
the audio system on.
MEDIA SELECTION
FM/AM: Push FM/AM button to
select the FM1, FM2, or AM band.
The selected band will be indicated
in the display.
CD: Push CD button to select the
CD player when inserting a CD.
U S B/AUX : Push USB/AUX button to
select the USB or iPod player when
connecting USB or iPod.
AUX: Push USB/AUX button to
switch to AUX jack input.
TUNING
The radio has the following
tuning controls:
M anual: Turn the TUNE dial to
manually change the frequency. S
eek: Push the SEEK
tuning buttons to automatically
seek a higher or lower frequency
with a station.
S can: Push the SCAN button
to automatically sample strong
stations for seconds each. Push
again to cancel.
Preset Channel: P u s h 1/2 /3 /4 /5 /6
button to select a station stored in
memory. To store a station, push
and hold 1/2/3/4/5/6 until station
is displayed.
Auto Memory Tuning: Push and
hold the AUTO-M button to store
an additional 6 stations on each FM
and AM band without disturbing the
previously stored stations. To return
to the previously stored stations,
push FM or AM button. Refer to the
Owner’s Manual for complete details.
1660320_15b_Mazda6_SSG_021714.indd 292/17/14 11:12 AM