MAZDA MX-5 1994 Workshop Manual

MAZDA MX-5 1994 Workshop Manual MX-5 1994 MAZDA MAZDA https://www.carmanualsonline.info/img/28/57072/w960_57072-0.png MAZDA MX-5 1994 Workshop Manual
Trending: height adjustment, battery replacement, maintenance schedule, jump cable, oil level, brakes, fuse diagram

Page 481 of 1708

MAZDA MX-5 1994  Workshop Manual K TRANSMISSION t- FREE LENGTH 7 -& WIRE DIAMETER Disassembly note Drum support Mark the fourth gear case and the drum support for prop- er reassembly, then remove the drum support. Accumulator plug Re

Page 482 of 1708

MAZDA MX-5 1994  Workshop Manual TRANSMISSION K 2. Apply ATF to the spring and install it into the fourth gear case. 3. Apply ATF to the accumulator piston. 4. Apply even pressure to the perimeter of the piston, and install it into t

Page 483 of 1708

MAZDA MX-5 1994  Workshop Manual K TRANSMISSION STEEL BALL ONE-WAY VALVE 13. Apply ATF to the fourth gear case, and mount it onto the oil pump. 14. Install the steel ball and the one-way valve. 15. Apply ATF to the new seal rings, an

Page 484 of 1708

MAZDA MX-5 1994  Workshop Manual TRANSMISSION K 2ND BAND SERVO Preinspection 2ND band servo operation 1. Apply compressed air through the oil passage as shown. Air pressure: 392 kPa (4.0 kg/cm2, 57 psi) max. 2. Verify that the piston

Page 485 of 1708

MAZDA MX-5 1994  Workshop Manual K TRANSMISSION --/b WIRE DIAMETER Inspection Return spring 1. Measure the spring specifications. Specifications 2. If not within specification, replace the return spring. Outer dia. mm {in} 28.2 11.1

Page 486 of 1708

MAZDA MX-5 1994  Workshop Manual TRANSMISSION K 10. Install and tighten the bolts. Tightening torque: 6.9--8.8 N-m (70-90 kgfmcm, 61-78 in-lbf} On-vehicle Adjustment 1. Remove the exhaust pipe. (Refer to page K-47.) 2. Remove the val

Page 487 of 1708

MAZDA MX-5 1994  Workshop Manual K TRANSMISSION FRONT CLUTCH Preparation SST Preinspection Front clutch operation 1. Install the front clutch onto the drum support along with the seal rings. Apply compressed air through the oil pas-

Page 488 of 1708

MAZDA MX-5 1994  Workshop Manual TRANSMISSION K Disassembly / Inspection / Assembly 1. Disassemble in the order shown in the figure, referring to Disassembly Note. 2. Inspect all parts, and repair or replace as necessary. 3. Assemble

Page 489 of 1708

MAZDA MX-5 1994  Workshop Manual K TRANSMISSION -&- WIRE DIAMETER Disassembly note Snap ring Caution 4 Depress the spring retainer only enough to install the snap ring. Overpressing will damage the re- tainer assembly edges. 1. Comp

Page 490 of 1708

MAZDA MX-5 1994  Workshop Manual Assembly procedure 1. Apply ATF to a new O-ring and install it onto the front clutch drum. 2. Apply ATF to a new seal ring and install it onto the piston. 3. Apply ATF to the inside of the front clutc
Trending: coolant capacity, oil filter, coolant, jump start, lock, change time, steering