MAZDA MX-5 1994 Workshop Manual

MAZDA MX-5 1994 Workshop Manual MX-5 1994 MAZDA MAZDA https://www.carmanualsonline.info/img/28/57072/w960_57072-0.png MAZDA MX-5 1994 Workshop Manual
Trending: mileage, spare tire, park assist, service interval, fuel filter, oil level, ABS

Page 601 of 1708

MAZDA MX-5 1994  Workshop Manual M REAR AXLE Rear wheel hub assembly 1. Apply grease to the wheel bearing inner race. 2. Press the rear wheel hub assembly in by using the SST. Oil seal 1. Apply grease to the new oil seal lip. 2. Inst

Page 602 of 1708

MAZDA MX-5 1994  Workshop Manual DRIVE SHAFT M DRIVE SHAFT b 1. Rear wheel 3. Drive shaft 2. Locknut Inspection ................. page M-17 Installation Note ........... page M-18 Removal Note ............. page M-17 Installation No

Page 603 of 1708

MAZDA MX-5 1994  Workshop Manual M DRIVE SHAFT Note If the drive shaft will not come out of the wheel hub easily, install a discarded nut onto the drive shaft so that the nut is flush with the end of the drive shaft. Tap _i the nut w

Page 604 of 1708

MAZDA MX-5 1994  Workshop Manual DRIVE SHAFT M Overhaul 1. Disassemble in the order shown in the figure, referring to Disassembly Note. 2. lnspect all parts and repair or replace as necessary. -- 3. Verify that all parts are free of

Page 605 of 1708

MAZDA MX-5 1994  Workshop Manual M DRIVE SHAFT Disassembly note Boot bands To remove the boot bands, pry up the locking clip with a screwdriver, then raise the end of the band. d Clip 1. Mark the drive shaft and outer ring with paint

Page 606 of 1708

MAZDA MX-5 1994  Workshop Manual DRIVE SHAFT M TAPE 45UOMX-031 DIFFERENTIAL SlDE WHEEL SlDE 45UOMX-031 SNAP RING GROOVE I 45UOMX-032 Boots 1. Wrap the shaft splines with tape. 2. Remove the boot. Assembly note Boots 1. Before putting

Page 607 of 1708

MAZDA MX-5 1994  Workshop Manual M DRIVE SHAFT 5. Align the marks, then install a new clip. Boot bands 1. Set the boots onto the rings. 2. Release any trapped air from the boots by carefully lifting up the small end of each boot with

Page 608 of 1708

MAZDA MX-5 1994  Workshop Manual DIFFERENTIAL M DIFFERENTIAL PREPARATION u SST 49 01 07 680A Engine stand For disassembly and assembly of differential 49 MOO5 561 Hanger, differential carrier For disassembly and assembly of different

Page 609 of 1708

MAZDA MX-5 1994  Workshop Manual M DIFFERENTIAL 49 DO1 7 2A1 Installer set, bearing 49 F401 331 Body (Part of 49 DO17 2A1) 49 GO30 338 Attachment E (Part of 49 DO1 7 2A1) Puller set, bearing 49 0259 720 Wrench, differential side bear

Page 610 of 1708

MAZDA MX-5 1994  Workshop Manual DIFFERENTIAL M DIFFERENTIAL OIL Inspection 1. Remove the filler plug. 2. Verify that the oil is at the bottom of the filler plug hole. If it is low, add the specified oil. 3. Install the filler plug.
Trending: brake, fuse box location, set clock, CD player, fuel fill door release, fuel type, start stop button