MAZDA MX-5 1994 Workshop Manual

MAZDA MX-5 1994 Workshop Manual MX-5 1994 MAZDA MAZDA https://www.carmanualsonline.info/img/28/57072/w960_57072-0.png MAZDA MX-5 1994 Workshop Manual
Trending: wheel alignment, check transmission fluid, service schedule, brake pads replacement, radio, light, inflation pressure

Page 611 of 1708

MAZDA MX-5 1994  Workshop Manual M DIFFERENTIAL 5. Separate the driveshaft from the differential and sus- pend it. 6. Remove the output shaft by using two pry bars as shown in the figure. J 7. Remove the oil seal. 8. Apply lithium-ba

Page 612 of 1708

MAZDA MX-5 1994  Workshop Manual DIFFERENTIAL M DIFFERENTIAL, STANDARD; DIFFERENTIAL, TORQUE SENSING LIMITED SLIP ("TORSEN" LSD) Removal 1 lnstallation 1. Drain the differential oil. ,, 2. Remove in the order shown in the figure, ref

Page 613 of 1708

MAZDA MX-5 1994  Workshop Manual M DIFFERENTIAL SLEEVE BLOCK BOLT (MI 4 x 1.5) dl Removal note Power plant frame (PPF) 1. Disconnect the wire harness from the PPF. 2. Support the transmission with a jack. 3. Remove the power plant fr

Page 614 of 1708

MAZDA MX-5 1994  Workshop Manual DIFFERENTIAL M t- 900mm (35.43 in) 10. Remove the transmission-side bolts, and remove the PPF. Do not remove the spacers from the PPF. If they are removed, replace the PPF as an assembly. Drive shaft

Page 615 of 1708

MAZDA MX-5 1994  Workshop Manual M DIFFERENTIAL Installation note Differential 1. Connect the drive shaft to the output shaft with the marks aligned. 2. Install the differential. - JOMX- Tightening torque 0: 83-98 N-m (8.5-10 kgf.m,

Page 616 of 1708

MAZDA MX-5 1994  Workshop Manual DIFFERENTIAL M 8. Tighten the differential-side bolts. Tightening torque: lO4--123 N.m (1 0.6-1 2.6 kgf.m, 77-91 ft~lbf) 9. Install the power plant frame bracket. (Manual transmis- sion) Tightening to

Page 617 of 1708

MAZDA MX-5 1994  Workshop Manual M DIFFERENTIAL Overhaul 1. Disassemble in the order shown in the figure, referring to Disassembly Note. 2. Inspect all parts and repair or replace as necessary. 3. Assemble in the reverse order of dis

Page 618 of 1708

MAZDA MX-5 1994  Workshop Manual DIFFERENTIAL M 1. Output shafts Disassembly Note .......... page M-34 Assembly Note ............ page M-42 u 2. Differential case Disassembly Note .......... page M-34 Assembly Note ............ page

Page 619 of 1708

MAZDA MX-5 1994  Workshop Manual M DIFFERENTIAL Disassembly note Output shafts Remove the output shafts with two pry bars as shown in the figure. -J Differential case Caution The differential case is made of aluminum, and is therefor

Page 620 of 1708

MAZDA MX-5 1994  Workshop Manual DIFFERENTIAL id Locknut (Companion flange) Hold the companion flange by using the SST and remove the locknut. Companion flange Pull the companion flange off by using the SST. Drive pinion Push out the
Trending: jack points, turn signal, jacking, fuse box location, radiator, cooling, bolt pattern