jack points MITSUBISHI SPYDER 1990 Service User Guide

REAR SUSPENSION Rear Suspension Assembly .
REMOVAL SERVICE POINTS
S H A F T
(1) Make mating marks on the differential-
and flange yoke, and then separate the differential carrier
assembly and the propeller shaft.
(2) Suspend the propeller shaft from the body, wire, etc,
so that there are no sharp bends..,
Caution
Be careful that there are no sharp bends in the pro pel-
ler shaft, as they may damage the joint.
CROSSMEMBER MOUNTING SELF-LOCKING
NUTS REMOVAL
After supporting the crossmember in FWD vehicles or the
differential case in AWD vehicles with a garage jack or trans-
mission jack respectively, remove the crossmember m ounting
nuts.
INSTALLATION SERVICE POINT
PROPELLER SHAFT INSTALLATION
Install with the mating marks of the differential carrier and
propeller aligned.
Caution
Tighten installation bolts and nuts after removing oil and
grease from threads to prevent them from loosening.
INSPECTION
lCheck crossmember for cracks or damage.
,
TSB Revision

A B S
HYDRAULIC UNIT (HU) CHECK
Caution
35200170111
Turn the ignition switch off before connecting ordisconnecting the scan tool.
1.
up the vehicle and support the vehicle with rigid
racks placed at the specified jack-up points or pla ce the
wheels which are checked on the rollers of the brak ing
force tester.
Caution
1.The roller of the braking force tester and the tire
be dry during testing.
2.When testing the front brakes, apply the parking
brake, and when testing the rear brakes, stop the
front by chocking them.
2.Release the parking brake, and feel the drag force (drag
torque) on each road wheel.. __
When using the braking force tester, take a reading of’
the brake drag force.
3. Turn the ignition key to ‘the OFF position and
scan tool as shown in the diagram.
4.After checking that the shift lever or
lever is in neutral, start the engine.
NOTE
1.At this time, the ABS system will switch scan
tool mode -and the
warning light will
2.When the ABS has’ been interrupted by the -fail-saf e
function, the tool actuator testing cannot be
used.
5. Use the scan tool to force-drive the actuator.
TSB Revision