Stop NISSAN PATROL 1998 Y61 / 5.G Electrical System Workshop Manual

NISSAN PATROL 1998 Y61 / 5.G Electrical System Workshop Manual PATROL 1998 Y61 / 5.G NISSAN NISSAN https://www.carmanualsonline.info/img/5/616/w960_616-0.png NISSAN PATROL 1998 Y61 / 5.G Electrical System Workshop Manual

Page 2 of 326

NISSAN PATROL 1998 Y61 / 5.G Electrical System Workshop Manual Wiring Diagram Ð H/AIM Ð .....................................71
PARKING, LICENSE AND TAIL LAMPS......................73
Wiring Diagram Ð TAIL/L Ð/Type A .........................73
Wiring Diagram

Page 44 of 326

NISSAN PATROL 1998 Y61 / 5.G Electrical System Workshop Manual Battery Test and Charging Chart
Chart I
VISUAL INSPECTION
+Check battery case for cracks or bends.
+Check battery terminals for damage.
+If the difference between the max. and min. electrolyte level i

Page 46 of 326

NISSAN PATROL 1998 Y61 / 5.G Electrical System Workshop Manual A: SLOW CHARGE
Determine initial charging current from speci®c gravity refer-
ring to Fig. 2.
+Charge battery.
+Check charging voltage 30 minutes after starting the bat-
tery charge.
12 to 15 volts
O

Page 47 of 326

NISSAN PATROL 1998 Y61 / 5.G Electrical System Workshop Manual B: STANDARD CHARGE
Determine initial charging current from
speci®c gravity, referring to Fig. 4.
Charge battery for 8 hours.
CHECKING SPECIFIC GRAVITY
Refer to ``Speci®c Gravity Check.
Conduct add

Page 48 of 326

NISSAN PATROL 1998 Y61 / 5.G Electrical System Workshop Manual C: QUICK CHARGE
Determine initial charging current setting and charg-
ing time from speci®c gravity, referring to Fig. 6.
Charge battery.
Go to ``CAPACITY TEST.Fig. 6 INITIAL CHARGING CURRENT SETTI

Page 50 of 326

NISSAN PATROL 1998 Y61 / 5.G Electrical System Workshop Manual Trouble Diagnoses
If any abnormality is found, immediately disconnect battery negative terminal.
Starter does not stop.cReplace magnetic switch.
Engine does not start.
Does engine turn by cranking?
No

Page 54 of 326

NISSAN PATROL 1998 Y61 / 5.G Electrical System Workshop Manual 5. Check depth of insulating mold from commutator surface.
+Less than 0.2 mm (0.008 in) ... Undercut to 0.5 to 0.8 mm
(0.020 to 0.031 in)
Assembly
Apply high-temperature grease to lubricate the bearin

Page 55 of 326

NISSAN PATROL 1998 Y61 / 5.G Electrical System Workshop Manual +Not in the speci®ed value ... Adjust by adjusting plate.
Service Data and Speci®cations (SDS)
STARTER
TypeS13-502
HITACHI make
Reduction gear type
Applied model RD28
System voltage V 12
No-load
Ter

Page 69 of 326

NISSAN PATROL 1998 Y61 / 5.G Electrical System Workshop Manual System Description
OPERATION
Headlamp system on vehicles for North Europe contains a daytime light system. The unit operates to illumi-
nate headlamps low beam, parking, tail, license lamps and illumi

Page 73 of 326

NISSAN PATROL 1998 Y61 / 5.G Electrical System Workshop Manual Trouble Diagnoses
DAYTIME LIGHT CONTROL UNIT INSPECTION TABLE
Terminal No. ConnectionsINPUT (I)/
OUTPUT (O)Operated conditionVoltage (V)
(Approximate
values)
1Power source for illumi-
nation & tail la
Page:   1-10 11-20 21-30 next >