height adjustment NISSAN X-TRAIL 2003 Electronic User Guide

MAINSHAFT AND GEARS
MT-81
D
E
F
G
H
I
J
K
L
MA
B
MT
15. Install 6th main gear.
16. Adjustment between 6th main gear and 6th main adjusting shim.
lCalculate thickness “Q” of 6th main adjusting shim by proce-
dure below so that end play dimension between 6th main
gear and mainshaft rear bearing becomes the dimension
shown below.
Adjusting Shim
CAUTION:
Only one adjusting shim can be selected.
a. Using height gauge, measure dimension “Q1”and“Q2”.
b. Install selected 6th main adjusting shim to mainshaft.
17. Install mainshaft rear bearing.
SCIA0977E
Endplay :0-0.1mm(0-0.004in)
Dimension“Q” = (Q
1-Q2)+Endplay
Q : Thickness of adjusting shim
Q
1: Dimension from mainshaft reference face to
mainshaft rear bearing press-fit end face
Q
2: Dimension from mainshaft reference face to
6th main gear end face
SCIA0995E
Thickness Part number Thickness Part number
0.88mm (0.0346 in)
0.96mm (0.0378 in)
1.04mm (0.0409 in)
1.12mm (0.0441 in)32237 8H560
32237 8H561
32237 8H562
32237 8H5631.20mm (0.0472 in)
1.28mm (0.0504 in)
1.36mm (0.0535 in)32237 8H564
32237 8H565
32237 8H566
SCIA0978E

RF-6
SUNROOF
Fitting Adjustment
EIS000MR
LONGITUDINAL/LATERAL CLEARANCE ADJUSTMENT
1. Tilt up glass lid to remove side trim.
2. After loosening glass lid mounting nuts (4 each on left/right), tilt down glass lid.
3. Adjust glass lid according to sections A–A, B–B, C–C as shown in the figure.
4. After adjusting glass lid, tighten nuts to the specified torque.
5. Tilt glass lid 4 to 5 times to check that it smoothly goes up and down
SURFACE MISMATCH ADJUSTMENT
1. Adjust surface height of glass lid and roof panel to 0±1.5 mm
(0±0.059 in) by altering the number of shims between glass lid
and link assembly. (Standard: 2, max: 4)
2. After fitting adjustment, use a hose to flush the entire surface of
the roof with water to check for leaks.
SIIA0167E
SIIA0119E