Peugeot 208 2017 Owner's Guide

29
Remaining range less than 60 miles
( 100 km) (1.5 BlueHDi Euro 6.2)
When driving, the audible signal and the
message display are triggered every 6
miles
(10
km) until the AdBlue tank is topped up.
It is essential to top up as soon as possible and
before the tank is completely empty; other wise
it will not be possible to restart the engine after
the next stop. When switching on the ignition, this warning
lamp flashes, accompanied by an audible
signal (1 beep) and the display of a message
(e.g. "Top up AdBlue: Starting impossible
in x miles") indicating the remaining range
expressed in miles or kilometres.) Breakdown related to a lack of AdBlue
®
The AdBlue® tank is empty: the starting
inhibition system required by legislation
prevents starting of the engine.
To be able to restart the engine, it is
essential to add at least 4
litres of AdBlue
®
to its tank.
When switching on the ignition, this warning
lamp flashes, associated with an audible
signal and the display of the message "Top up
AdBlue: Starting impossible".
In the event of a fault with the
SCR emissions control system
An engine immobiliser is activated
automatically after you have driven a
further 650
miles (1,100 km) following
confirmation of a fault with the SCR
emissions control system. Have the
system checked by a PEUGEOT dealer or
a qualified workshop as soon as possible. In the event of the detection of a fault
If it is a temporary fault, the alert
disappears during the next journey,
after self-diagnostic checks of the SCR
emissions control system.
The warning lamps come on, accompanied
by an audible signal and the display of the
message "Emissions fault".
The alert is triggered while driving as soon
as the fault is detected for the first time, then
when switching on the ignition for subsequent
journeys, while the fault persists.
When driving, the audible signal and the
message display are triggered every 60

miles
(100

km) until the level is topped up.
It is essential to top up as soon as possible and
before the tank is completely empty; other wise
it will not be possible to restart the engine after
the next stop.
1
Dashboard instruments

30
Trip computer
Instrument panel display
screen
F Each press on the end of the wiper control stalk displays the information in
turn.
-
Trip 1 showing:
•
t

he average speed,
•
t

he average fuel consumption,
•

t
he distance travelled,
for the first trip.
Starting prevented
You have exceeded the authorised driving
limit: the starting prevention system does
not allow the engine to be started.
To be able to restart the engine, you must call
on a PEUGEOT dealer or a qualified workshop. Each time the ignition is switched on, these
warning lamps come on and the AdBlue
warning lamp flashes, accompanied by an
audible signal and the display of the message
"Emissions fault: Starting prevented".
During the permitted driving phase (between
685 and 0 miles (1,100 km and 0 km))
While driving, the message is displayed every
30 seconds while the fault with the SCR
emission control system persists.
The alert is repeated when switching on the
ignition.
You should go to a PEUGEOT dealer or a
qualified workshop as soon as possible.
Other wise you will not be able to restart the
vehicle. If a fault with the SCR system is confirmed
(after 30 miles (50 km) covered with the
permanent display of the message signalling
a fault), these warning lamps come on and the
AdBlue warning lamp flashes, accompanied by
an audible signal and the display of a message
(e.g. "Emissions fault: Starting prevented in
200 miles (300 km") indicating the remaining
range expressed in miles or kilometres.
Dashboard instruments

31
- Trip 2 showing:
• t he average speed,
•
t

he average fuel consumption,
•

t
he distance travelled,
for the second trip.
-
C

urrent information showing:
•

t
he range,
•

t
he current fuel consumption,
•

t
he Stop & Start time counter.
Touch screen
Reset trip
F When the trip required is displayed, press the control for more than 2 seconds or use
the left-hand thumb wheel of the steering
mounted controls.
Trips 1 and 2 are independent but their use is
identical. For example, trip 1 can be used for daily figures
and trip 2 for monthly figures.
The information is accessible in the
Driving / Vehicle menu.
Display of information in the touch screen
Permanent display:
F Sel ect the "
Applications " menu then the
" Vehicle Apps " tab then "Trip computer ".The information of the trip computer is
displayed in tabs.
F

P
ress one of the buttons to display the
desired tab.
Temporar y display in a new window:
F
P
ress the end of the wiper control stalk for
access to the information and to display the
different tabs.
The current fuel consumption tab with:
-

Range.
-

T
he current instantaneous fuel
consumption.
-

T
he Stop & Start time counter,
1
Dashboard instruments

32
A few definitions
Range
(miles or km)The distance which can still be
travelled with the fuel remaining in
the tank (related to the average fuel
consumption over the last few miles
(kilometres) travelled).
This value may fluctuate if a change
of driving style or terrain results in a
significant change in the current fuel
consumption.
Dashes are displayed when the range falls
below 20
miles (30 km).
After filling with at least 5
litres of fuel, the
range is recalculated and is displayed if it
exceeds 60
miles (100 km).
If dashes instead of figures continue to
be displayed when driving, contact a
PEUGEOT dealer or a qualified workshop.
The trip "
1" tab with:
-

A

verage speed for the first trip.
-
A

verage fuel consumption.
- D
istance travelled.
The trip " 2" tab with:
-

A

verage speed for the second trip.
-
A

verage fuel consumption.
-
D

istance travelled.
Trip reset
F When the desired trip is displayed, press the reset button or on the end of the wiper
control stalk.
Tr i p s " 1" and " 2" are independent and are used
identically.
Tr i p " 1" allows daily calculations to be carried
out, for example, and trip " 2" allows monthly
calculations.
Dashboard instruments

33
Date and time adjustment
Instrument panel
F Each press of this button moves between the following settings:
-


h o u r,
-


minutes,
-

1
2 or 24 hour format.
With PEUGEOT Connect
Radio
F Select the Settings menu.
F
Sel
ect "Date and time ".
F

Sel
ect "Date " or "Time ".
F

C
hoose the display formats.
F

C
hange the date and/or time using the
numeric keypad.
F

C
onfirm with " OK".
Current fuel consumption
(mpg or l/100 km or km/l)
T his function is only displayed from
20
mph (30 km/h).
Calculated over the last few seconds.
Average fuel consumption
(mpg or l/100 km or km/l)
C alculated since the last trip computer
reset.
Distance travelled
(miles or km)
Calculated since the last trip computer
reset.
Average speed
Calculated since the last trip computer
reset.
(mph or km/h)
Total time in stop mode
(minutes / seconds or hours / minutes)
If your vehicle is fitted with the Stop & Start, a
time counter adds up the time spent in STOP
mode during a journey.
It resets to zero every time the ignition is
switched on.
1
Dashboard instruments

34
Lighting dimmer
System for the manual adjustment of the
brightness of the instrument panel and the
touch screen to suit the ambient light level.
With two buttons
Lights switched on:F
P
ress this button to raise the
level of brightness.
F

P
ress this button to lower it.
Release the button once the desired level of
brightness is reached.
The system does not automatically
manage the change between winter and
summer time (depending on country).
The system does not automatically
manage the change between winter and
summer time (depending on country).
The change between winter and summer
time is done by changing the time zone.
Additional adjustments
You can choose:
- T o change the display format of the date
and time (12h/24h).
-

T
o change the time zone.
-

T
o activate or deactivate synchronisation
with the GPS (UTC).
With PEUGEOT Connect
Nav
Adjustment of the time and date is only
available if synchronisation with GPS is
deactivated.
F

Sel
ect the Settings menu.
F

P
ress the " OPTIONS " button to go to the
secondary page.
F

Sel
ect "Setting the time- date".
F

Sel
ect the " Date" or "Time " tab.
F

A
djust the date and/or time using the
numeric keypad.
F

C
onfirm with " OK".
Dashboard instruments

35
With one button
F Press this button to adjust the brightness.
F

A

s soon as the lighting reaches the
required level of brightness, release the
button.
When the vehicle lighting is off, or in
day mode (daytime running lamps on),
pressing the button does not have any
effect.
With touch screen
F In the Settings menu, select "Brightness".
F A djust the brightness by pressing the
arrows or moving the cursor.
The brightness can be adjusted differently
for day mode (lighting control stalk in
position " 0") and night mode (lighting
control stalk in any other position).
1
Dashboard instruments

36
Remote control
A.Unfolding / Folding.
B. Unlocking.
Disarming the alarm.
C. Locking.
Locating the vehicle.
Arming the alarm.
Doors
Complete unlocking
With the key
F Turn the key towards the front of the
vehicle.
Using the remote control
F Press.
Selective unlocking
Complete unlocking is selected by default.
It is possible to activate or
deactivate the selective unlocking
with the touch screen from the menu
Driving / Vehicle .
With the remote control
F To unlock the driver's door only,
press this button once.
F

T
o unlock the other doors and
the boot, press this button
briefly twice. Unlocking is confirmed by rapid flashing
of the direction indicators for around
2


seconds.
According to the version you have, the
electric door mirrors fold at the same time.
Locating your vehicle
F A press switches on the vehicle's lighting and flashes
the direction indicators for a few
seconds to help you locate your
vehicle in a car park.
Guide-me-home lighting
Make a long press on this button to
operate the guide-me-home lighting
(switching on the sidelamps, dipped
beams and number plate lamps).
A second press before the end of the timed
period cancels the guide-me-home lighting.
Access

37
Locking – Key
Locking
With the key
F Turn the key towards the rear of the vehicle.
With the remote control
F Press.
M aintaining the lock (key or remote
control) automatically closes the
windows.
Locking is confirmed by fixed lighting of
the direction indicators for approximately
2


seconds.
According the version you have, the
electric door mirrors fold at the same time.
The automatic folding and unfolding of
the door mirrors can be deactivated by a
PEUGEOT dealer or a qualified workshop. If one of the doors or the boot is still open,
the central locking does not take place.
When the vehicle is locked, if it is unlocked
inadvertently, it will lock itself again
automatically after about 30
seconds
unless a door is opened.
As a safety measure (children on board),
never leave the vehicle without taking your
key, even for a short period.
Folding the key
F Press this button before folding the key. If you do not press the button, you risk
damaging the remote control.
Back-up door locking
For mechanically locking and unlocking the
doors in the event of a fault with the central
locking system or a battery failure.
Driver’s side
Insert the key in the door lock to lock or unlock
the door.
Passenger side
F On the rear doors, check that the child lock
is not on.
2
Access

38
F Remove the black cap located on the edge of the door, using the key.
F

I
nsert the key in the socket without forcing
it, then without turning it, move the latch
sideways towards the inside of the door.
F

R
emove the key and refit the cap.
Deadlocking
Deadlocking renders the exterior and
interior door controls inoperative.
It also deactivates the manual central
control button.
You must therefore never leave anyone
inside the vehicle when it is deadlocked.
With the key
F Turn the key to the rear in the driver's door lock.
F

T
urn the key to the rear again within
5
seconds to deadlock the vehicle.
Using the remote control
F Press.
F
P
ress this button again within
5
seconds to deadlock the
vehicle.
Deadlocking is confirmed by fixed
lighting of the direction indicators for
approximately 2


seconds.
According the version you have, the
electric door mirrors fold at the same time.
Remote control problem
Following disconnection of the vehicle battery,
replacement of the remote control battery or
in the event of a remote control malfunction,
you can no longer unlock, lock or locate your
vehicle.
F

F
irst of all, use the key in the door lock to
unlock or lock your vehicle.
F

T
hen reinitialise the remote control.
If the problem persists, contact a PEUGEOT
dealer as soon as possible.
Reset
F Switch off the ignition.
F T urn the key to position 2 (Ignition) .
F

I
mmediately press the closed
padlock button for a few
seconds.
F

S
witch off the ignition and remove the key
from the switch.
The remote control is now fully operational
again.
Access