Peugeot 308 2016 Owner's Manual

219
308_en_Chap07_info-pratiques_ed02-2015
System which manages the duration of use of certain functions to conserve a sufficient level of
charge in the battery.
After the engine has stopped, you can still use functions such as the audio and telematics
system,
w
indscreen wipers, dipped beam headlamps,
c
ourtesy lamps, etc. for a maximum
combined duration of about forty minutes.
energy economy mode
Switching to economy
mode
A message then appears in the instrument
panel screen indicating that the vehicle has
switched to economy mode and the active
functions are put on standby.
If a telephone call is being made at this time, it
will be maintained for around 10 minutes with
the Bluetooth hands-free system of your audio
system.
Exiting economy mode
these functions are reactivated automatically
n ext time the vehicle is driven.
In order to restore the use of these functions
immediately, start the engine and let it run:
-
fo

r less than ten minutes, to use the
equipment for approximately five minutes,
-
fo

r more than ten minutes, to use the
equipment for up to approximately
thirty
m

inutes.
Let the engine run for the duration specified to
ensure that the battery charge is sufficient.
Do not repeatedly and continuously restart the
engine in order to charge the battery.
A flat battery prevents the engine from starting.
For more information on the battery, refer to the
corresponding section.
Load reduction mode
System which manages the use of certain
functions according to the level of charge
remaining in the battery.
When the vehicle is being driven, the load
reduction function temporarily deactivates
certain functions, such as the air conditioning,
the heated rear screen...
the d

eactivated functions are reactivated
automatically as soon as conditions permit.
7
Practical information

220
308_en_Chap07_info-pratiques_ed02-2015
"Multimedia"
Multimedia support, hands-free kit, DVD player,
driving aids, vehicle tracking system, ...
Accessories
A wide range of accessories and genuine parts is available from the PeugeOt d ealer network.the
se accessories and parts are all suitable for your vehicle and benefit from Peu geOt's r ecommendation and warranty.
"Transport solutions"
Boot liners, roof bars, bicycle carrier on roof
bars, ski carrier, roof box, towbar harness, ...
tow b

ar, which mst be fitted by P
eu
ge
Ot
d

ealer or a qualified workshop.
Conversion kits
You can obtain an "ent erprise" kit to convert a
trade vehicle to a private car and vice-versa.
"Styling"
alloy wheels from 15 inch to 18 inch, finishers
for wheels, door sills, gear lever knobs, ...
"Ligne S": 16 and 17 inch alloy wheels, body
kit, stickers, interior and exterior mirror shells,
gear lever knob, door sills, mats*, …
"Comfort"
Door deflectors, side blinds and rear blind,
cigarette lighter, boot dividers, coat hanger
fixed to head restraint, front centre armrest,
under shelf storage, front and rear parking
sensors, styling mudflaps, window film, boot
management system, ...
*


t
o av
oid any risk of jamming of the pedals:
-
en

sure that the mat is positioned and
secured correctly,
-
ne

ver fit one mat on top of another.
"Security and safety"
Anti-theft alarm, window engraving, wheel
security bolts, child seats and booster
cushions, breathalyzer, first aid kit, warning
triangle, high visibility jacket, stolen vehicle
tracking system, temporary puncture repair kit,
snow chains, non-slip covers, front foglamps
kit, dog guard, ...
"Protection"
Mats*, seat covers compatible with lateral
airbags, mud flaps, side protection rubbing
strips, bumper protection rubbing strips,
bumper protectors, boot sill finishers, boot
mat,
...
Practical information

221
308_en_Chap07_info-pratiques_ed02-2015
the fitting of electrical equipment
o r accessories which are not
recommended by P
eu

ge
Ot m
ay result
in a failure of your vehicle's electronic
system and excessive electrical
consumption.
Contact a P
eu

ge
Ot d
ealer
for information on the range of
recommended equipment and
accessories.
Installation of radio
communication
transmitters
Before installing any after-market radio
communication transmitter, you can
contact a P
eu

ge
Ot d
ealer for the
specification of transmitters which can
be fitted (frequency, maximum power,
aerial position, specific installation
requirements), in line with the Vehicle
ele

ctromagnetic Compatibility
Directive
(

2004/104/
eC)
. Depending on the legislation in force in
the country, certain safety equipment
may be compulsory: high visibility
safety vests, warning triangles,
breathalyzers, spare bulbs, spare fuses,
fire extinguisher, first aid kit, mud flaps
at the rear of the vehicle.
By visiting a P
eu

ge
Ot d
ealer, you can also
obtain products for cleaning and maintenance
(exterior and interior) - including ecological
products in the "
teCH

NA
tuRe" ra
nge, topping
up products (screenwash...), touch-up pens
and paint aerosols for the exact colour of your
vehicle, refills (cartridge for the temporary
puncture repair kit...), ...
7
Practical information

222
308_en_Chap07_info-pratiques_ed02-2015
Changing a wiper blade
Before removing a front
wiper blade
F Within one minute after switching off
the ignition, operate the wiper stalk to
position the wiper blades vertically on
the
w

indscreen.
Removing
F Raise the corresponding wiper arm.
F unc lip the wiper blade and remove it.
Fitting
F Put the corresponding new wiper blade in
place and clip it.
F
Fo

ld down the wiper arm carefully.
After fitting a front wiper
blade
F Switch on the ignition.
F Op erate the wiper stalk again to park the
wiper blades.
Practical information

223
308_en_Chap07_info-pratiques_ed02-2015
Fitting roof bars
Do not exceed the maximum authorised
load, shown in the instructions for the
roof bars.
When fitting transverse roof bars, take care to
position them correctly on the retaining pins
located in the door apertures.
use

accessories recommended by
P
eu

ge
Ot o

bserving the manufacturer's
recommendations and fitting instructions
so as to avoid the risk of damaging the
body (deformation, scratches, ...). If the height exceeds 40 cm, adapt the
speed of the vehicle to the profile of the
road to avoid damaging the roof bars
and the fixings on the roof.
Be sure to refer to national legislation in
order to comply with the regulations for
transporting objects which are longer
than the vehicle.With longitudinal bars
You must fit the transverse bars to the
longitudinal bars at the fixing points indicated
by engraved markings on the longitudinal bars.
Recommendations
- For safety reasons and to avoid damaging
t
he roof, it is essential to use the transverse
bars listed for your vehicle.
-
Di

stribute the load evenly, avoiding
overloading on one side.
-
Ar

range the heaviest part of the load as
close as possible to the roof.
-
An

chor the load securely and fit a warning
flag if part of it overhangs the vehicle.
-
Dr

ive gently, as the vehicle will be more
susceptible to the effects of side winds
(vehicle stability may be affected).
-
Re

move the roof bars as soon as they are
no longer needed.
7
Practical information

224
308_en_Chap07_info-pratiques_ed02-2015
Do not fit an accessory carrier to the
tailgate.
Bicycle / accessory
carrier
Practical information

225
308_en_Chap07_info-pratiques_ed02-2015
PeugeOt & tOtAL,
A PARtNeRSHIP tO DeLI VeR
Bet

te
R PeR
FORMANC
e!
Innovation, the key to success
the tOtAL Research and Development and
Peu geOt teams work together to develop high
quality lubricants that meet the requirements
of P
eu

ge
Ot v
ehicles. For you, this is the
assurance that the performance of your engine
is optimised while also ensuring its durability.
the 2

08 HYbrid F
e d
emonstrates the ability of
P
eu

ge
Ot
and
tOtAL
to develop innovative
technologies and provide other ways of moving
towards the future.
208 HYbrid FE, a technology demonstrator with exceptional characteristics:
1.9 l/100 km (148.7 mpg) and 0 to 100 km/h (0 to 62 mph) in 8 seconds.
Reduced exhaust emissions,
a true reality
tOtAL lubricants are formulated to optimise the
e fficiency of engines and the protection of the
emissions post-treatment systems. It is important
to observe the servicing recommendations
made by P
eu

ge
Ot
to assure correct operation.
RECOMMENDS
7
Practical information

226
308_en_Chap07_info-pratiques_ed02-2015
Bonnet
Before doing anything under the
bonnet, switch off the Stop & Start
system to avoid any risk of injury
resulting from an automatic change to
S
tA
R
t m o
d e .
Opening Closing
F take the stay out of its support slot.
F Cl ip the stay back into its housing.
F
Lo

wer the bonnet and release it at the end
of its travel.
F
Pu

ll on the bonnet to check that it has
latched correctly.
F


u
nc
lip the stay from its housing and place
it in the support slot to hold the bonnet
open.
Do not open the bonnet under very
windy conditions.
When the engine is hot, handle the
exterior safety catch and the stay with
care (risk of burns).
to a

void damaging electrical units,
it is strictly forbidden to use a high
pressure jet wash under the bonnet.
F
Pu

ll the safety catch towards you, then
raise the bonnet.
F
Op

en the door.
F
Pu

ll the release lever, located at the bottom
of the door aperture, towards you.
Practical information

227
308_en_Chap07_info-pratiques_ed02-2015
Petrol engine
1. Screenwash and headlamp wash reservoir.
2. Co olant header tank.
3.
Br

ake fluid filler cap.
4.
Ba

ttery / Fuses.
5.
F

usebox.
6.
A i

r f i l t e r.
7.
engin

e oil dipstick.
8.
eng

ine oil filler cap.
thi

s engine is shown as an example.
the l
ocations of the engine oil dipstick and filler cap may vary.
7
Practical information

228
308_en_Chap07_info-pratiques_ed02-2015
* According to engine.
Diesel engine
1. Screenwash and headlamp wash reservoir.
2. Co olant header tank.
3.
Br

ake fluid filler cap.
4.
Ba

ttery / Fuses.
5.
F

usebox.
6.
A i

r f i l t e r.
7.
engin

e oil dipstick.
8.
eng

ine oil filler cap.
9.
Pr

iming pump*.
thi

s engine is shown as an example.
the l
ocations of the engine oil dipstick and filler cap may vary.
Practical information