transmission RENAULT KANGOO 1997 KC / 1.G Transmission Workshop Manual

Transmission
CLUTCH
MANUAL GEARBOX
DRIVESHAFTS
Renault 1997
77 11 194 244JULY 1997Edition Anglaise
"The repair methods given by the manufacturer in this document are based on the
technical specifications current when it was prepared.
The methods may be modified as a result of changes introduced by the
manufacturer in the production of the various component units and accessories
from which his vehicles are constructed."All copyrights reserved by Renault.
Copying or translating, in part or in full, of this document or use of the service part
reference numbering system is forbidden without the prior written authority of
Renault
C
FC0A - FC0C - FC0D - FC0E - KC0A - KC0C - KC0D - KC0E

21-1
21-2
21-3
21-4
21-4
21-5
Contents
Page
Transmission
CLUTCH
Mechanism- Disc
Flywheel20
20-1
20-4
ENSEMBLE MOTEUR ET BAS
Identification
Ratios
Capacities-Lubricants
Consumables
Parts to be systematically replaced
Gearbox (Removal-Refitting)MANUAL GEARBOX21
29-1
29-2General
Front driveshaft
DRIVESHAFTS29

MANUAL GEARBOX
Gearbox (Removal - Refitting)
21
Ensure that the rollers of the left driveshaft can-
not be removed by hand. If they can, check if any
of the needles have fallen into the gearbox.
Disconnect and remove the starter motor.
Disconnect:
- the reversing light connector,
- the speedometer connector and remove the
gearbox sensor.
Remove :
- the exhaust downpipe,
- the entire gear control lever by removing the
bolt (E) and the three bolts of the heat shield
for access to the base of the gear lever
- the engine tie-bar bolt,
- the rear support on the gearbox.
12993-1R2
Remove the engine-gearbox tie-rod.
To aid the removal of the steering box, fit, if ne-
cessary, a shim, in order to tilt the engine for-
ward.
Remove the steering box and secure it.
Fit the engine support and take the weight of
the engine and transmission assembly.
Positioning on F8Q engine
13120S
13121S
21-7