torque JAGUAR XFR 2010 1.G Workshop Manual
Page 928 of 3039
18.
19. WARNING: Make sure that a new bolt is installed.
Apply loctite 270 to the thread of the bolts.
Torque: 65 Nm
Page 932 of 3039
4. NOTE: Tighten the bolts in the indicated sequence.
Special Tool(s): JLR-303-1622 Torque: 11 Nm
Page 933 of 3039
Torque: 11 Nm
6. Refer to: Flexplate (303-01D Engine - V8 S/C 5.0L Petrol, Removal and Installation).
Page 940 of 3039
3. CAUTION: Make sure that new cylinder head bolts are
installed.
NOTE: Tighten the bolts in the indicated sequence.
Torque: 20 Nm
4. NOTE: Tighten the bolts in the indicated sequence.
Torque: 35 Nm
Page 942 of 3039
7.
8.
9.
10. Torque: 25 Nm
NOTE: Tighten the bolts in the indicated sequence.
Torque: 12 Nm
CAUTIONS:
If a new cylinder head has been installed then new
tappets must be installed.
If the cylinder head is being removed without a new
component being installed, the tappets must be installed in
their original positions.
Lubricate the valve tappets with clean engine oil.
Torque: 10 Nm
Page 943 of 3039
11.
12.
13.
CAUTION: Install the new seals.
Torque: 10 Nm
Page 944 of 3039
14.
15.
16.
CAUTION: Install a new seal.
NOTE: Engine shown removed for clarity.
Torque: 12 Nm
Page 945 of 3039
Torque: 20 Nm
Page 946 of 3039
Torque: 12 Nm
22.
Refer to: Exhaust Manifold LH (303-01C Engine - V8 5.0L Petrol, Removal and Installation).
23. Refer to: Camshaft LH (303-01D Engine - V8 S/C 5.0L Petrol, Removal and Installation).
24. Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures). www.JagDocs.com
Page 955 of 3039
3. CAUTION: Make sure that new cylinder head bolts are
installed.
Torque: 20 Nm
4. Torque: 35 Nm