JAGUAR XFR 2010 1.G Workshop Manual
Page 921 of 3039
2. CAUTION: Install a new friction washer before
installing the crankshaft pulley.
NOTES:
Make sure to clean the threads in the end of the
crankshaft and that the crank nose is free of any foreign
materials.
Skip to step 11 for engines fitted with early RH thread
crankshaft bolt.
3. Install the special tool. www.JagDocs.com
Page 922 of 3039
Page 923 of 3039
6. CAUTION: Rotate the crankshaft pulley installation tool
anti-clockwise until the pulley is fully located, do not over
tighten. Failure to do this may result in damge to the
components.
7. Remove the special tool.
Page 924 of 3039
Page 925 of 3039
10.
11.
12. WARNING: Make sure that a new bolt is installed.
Apply loctite 270 to the thread of the bolts.
Torque: 65 Nm
WARNING: Make sure that a new bolt is installed.
Install the special tool.
Page 926 of 3039
13.
14.
15. Torque: 65 Nm
NOTE: The graphic shows the tool position for LH
thread only, RH thread will be the opposite.
Using a suitable stand, support the special tool.
NOTE: The graphic shows the step for LH thread only,
RH thread will be the opposite.
Torque: 200 Nm www.JagDocs.com
Page 927 of 3039
16.
17. NOTES:
The graphic shows the step for LH thread only, RH
thread will be the opposite.
The use of a torque multiplyer capable of 600Nm will
be required.
Make sure that the socket is turned through 270
degrees not the torque wrench.
Torque: 270°
Remove the special tools.
Page 928 of 3039
18.
19. WARNING: Make sure that a new bolt is installed.
Apply loctite 270 to the thread of the bolts.
Torque: 65 Nm
Page 929 of 3039
5.0L Petrol, Removal and Installation).
23. Refer to: Cooling Fan Motor and Shroud - Vehicles With: Supercharger (303-03C Engine Cooling - V8 5.0L Petrol/V8 S/C 5.0L Petrol, Removal
and Installation).
24. Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).
Page 930 of 3039
Engine - V8 S/C 5.0L Petrol - Crankshaft Rear Seal
Removal and Installation
Special Tool(s)
Removal
NOTE: Removal steps in this procedure may contain installation details. Published: 12-May-2014
1. Refer to: Flexplate (303-01D Engine - V8 S/C 5.0L Petrol, Removal and Installation).
2. 303-1442
Rear Crankshaft Seal Installer JLR-303-1622
Alignment Tool, Engine Rear Oil Seal