NISSAN PICK-UP 1999 Repair Manual

VA
Note
Check circuit continuity between A/C relay
harness terminal No.
V2and thermo
switch harness terminal No.
V2.
Continuity should exist.
If OK, check harness for short.
OK
CHECK THERMO SWITCH.
Refer to HA-2074.
OK
cNG
Replace thermo switch.
Note
Check circuit continuity between thermo
switch harness terminal No.
V1and
triple-pressure switch harness terminal
No.
V4.
Continuity should exist.
If OK, check harness for short.
OK
CHECK TRIPLE-PRESSURE SWITCH.
Refer to HA-2073.
OK
cNG
Check refrigerant charge
amount.
OK
Note
Check circuit continuity between triple-
pressure switch harness terminal No.
V1
and thermo control amp. harness terminal
No.
V3.
Continuity should exist.
If OK, check harness for short.
OKReplace triple-pressure
switch.
CHECK POWER SUPPLY FOR
THERMO CONTROL AMP.
Do approx. 12 volts exist between thermo
control amp. harness terminal No.
V1and
body ground?
Yes
cNo
Check power supply circuit
and 7.5A fuse (No.
23,
located in fuse block).
(Refer to ªPOWER SUP-
PLY ROUTINGº in EL sec-
tion and Wiring Diagram.)
VB
(Go to next page.)
Note:
If the result is NG or No after checking circuit continuity, repair harness or
connector.
RHA980G
RHA981G
RHA328GA
RHA319GB
.
.
.
.
..
.
.
TROUBLE DIAGNOSESAUTO
Magnet Clutch (Cont'd)
HA-2071

VB
Do approx. 12V exist between thermo
control amp. harness terminal No.
V2and
body ground?
Yes
cNo
Replace thermo control
amp.
Note
Check circuit continuity between thermo
control amp. harness terminal No.
V2and
auto amp. harness terminal No.
V4.
Continuity should exist.
If OK, check harness for short.
OK
Replace auto amp.
Note:
If the result is NG or No after checking circuit continuity, repair harness or
connector.
RHA497H
RHA498H
.
.
.
TROUBLE DIAGNOSESAUTO
Magnet Clutch (Cont'd)
HA-2072

COMPONENT INSPECTION
A/C relay
Check continuity between terminal Nos.V3andV5.
Conditions Continuity
12V direct current supply between terminal Nos.
V1andV2Yes
No current supply No
If NG, replace relay.
Triple-pressure switch
TerminalsHigh-pressure side line
pressure
kPa (bar, kg/cm2, psi)Operation Continuity
Low-pres-
sure side
V1-V4
Increasing to
152.0 - 201.0
(1.520 - 2.010,
1.55 - 2.05, 22.0 - 29.2)ON Exists.
Decreasing to
152.0 - 201.0
(1.520 - 2.010,
1.55 - 2.05, 22.0 - 29.2)OFFDoes not
exist.
Medium-
pressure
side*
V2-V3
Increasing to
1,422 - 1,618
(14.22 - 16.18,
14.5 - 16.5, 206 - 235)ON Exists.
Decreasing to
1,128 - 1,422
(11.28 - 14.22,
11.5 - 14.5, 164 - 206)OFFDoes not
exist.
High-pres-
sure side
V1-V4
Decreasing to
2,059 - 2,256
(20.6 - 22.6,
21 - 23, 299 - 327)ON Exists.
Increasing to
2,648 - 2,844
(26.5 - 28.4,
27 - 29, 384 - 412)OFFDoes not
exist.
*: For cooling fan motor operation
Thermo control amp.
Evaporator outlet air temperature
ÉC (ÉF)Thermo amp.
operationTester
Decreasing to 0.1 - 0.9 (32 - 34) Turn OFF Approx. 12V
Increasing to 2.5 - 3.5 (37 - 38) Turn ON Approx. 0V
SEF090M
RHA364GA
RHA365GA
TROUBLE DIAGNOSESAUTO
Magnet Clutch (Cont'd)
HA-2073

Thermo switch
Water temperature
ÉC (ÉF)Terminal No.
Continuity
Å@
Over 105 (221)
V1V2No
Less than 100 (212) Yes
RHA141H
TROUBLE DIAGNOSESAUTO
Magnet Clutch (Cont'd)
HA-2074

Insufficient Cooling
TROUBLE DIAGNOSIS PROCEDURE FOR INSUFFICIENT COOLING
SYMPTOM:
lInsufficient cooling.
Inspection flow
*1: HA-2035
*2: HA-2036
*3: HA-2038
*4: HA-2055
*5: HA-2060
*6: HA-2065*7: HA-2070
*8: HA-2052
*9: Refer to HA-27, D22 Service
Manual, Publication No.
SM8E-0D22E0E.*10: HA-2039
*11: HA-2041
*12: HA-2049
SHA347F
TROUBLE DIAGNOSESAUTO
HA-2075

Insufficient Heating
TROUBLE DIAGNOSIS PROCEDURE FOR INSUFFICIENT HEATING
SYMPTOM:
lInsufficient heating.
Inspection flow
*1: HA-2041
*2: HA-2035
*3: HA-2036
*4: HA-2038*5: HA-2055
*6: HA-2060
*7: HA-2065
*8: HA-2057*9: HA-2055
*10: HA-2039
*11: HA-2049
SHA346F
TROUBLE DIAGNOSESAUTO
HA-2076

Noise
TROUBLE DIAGNOSIS PROCEDURE FOR NOISE
SYMPTOM:
lNoise
Inspection flow
*1: HA-69 in D22 Service
Manual, Publication No.
SM8E-0D22E0E*2: HA-71 in D22 Service
Manual, Publication No.
SM8E-0D22E0E*3: HA-57 in D22 Service
Manual, Publication No.
SM8E-0D22E0E
*4: HA-2041
RHA539H
TROUBLE DIAGNOSESAUTO
HA-2077

Self-diagnosis
TROUBLE DIAGNOSIS PROCEDURE FOR SELF-DIAGNOSIS
SYMPTOM:
lSelf-diagnosis cannot be performed.
Inspection flow
*1: HA-2046
*2: HA-2081
*3: HA-2083*4: HA-2085
*5: HA-2087
*6: HA-2055*7: HA-2041
*8: HA-2040
SHA352F
TROUBLE DIAGNOSESAUTO
HA-2078

Memory Function
TROUBLE DIAGNOSIS PROCEDURE FOR MEMORY FUNCTION
SYMPTOM:
lMemory function does not operate.
Inspection flow
*1: HA-2046 *2: HA-2041 *3: HA-2035
SHA027F
TROUBLE DIAGNOSESAUTO
HA-2079

Ambient Sensor
COMPONENT DESCRIPTION
The ambient sensor is attached in front of the driver's side con-
denser. It detects ambient temperature and converts it into a
resistance value which is then input into the auto amplifier.
AMBIENT TEMPERATURE INPUT PROCESS
The automatic amplifier includes a ªprocessing circuitº for the
ambient sensor input. However, when the temperature detected
by the ambient sensor increases quickly, the processing circuit
retards the auto amp. function. It only allows the auto amp. to
recognize an ambient temperature increase of 0.33ÉC per 100
seconds.
As an example, consider stopping for a cup of coffee after high
speed driving. Although the actual ambient temperature has not
changed, the temperature detected by the ambient sensor will
increase. This is because the heat from the engine compartment
can radiate to the front grille area, location of the ambient sen-
sor.
RHA036H
TROUBLE DIAGNOSESAUTO
HA-2080