ignition Citroen C4 2014.5 2.G Owner's Guide
[x] Cancel search | Manufacturer: CITROEN, Model Year: 2014.5, Model line: C4, Model: Citroen C4 2014.5 2.GPages: 494, PDF Size: 21.47 MB
Page 65 of 494

63
Changing the battery
Following disconnection of the vehicle battery, replacement of the remote control battery or
i
n the event of a remote control malfunction,
y
ou can no longer unlock, lock or locate your
v
ehicle.
Remember
to refit the mat below the armrest
a
fter removing the reinitialised electronic key.
Remote control problem /
reinitialisation
F Place the back-up key (integral with the r
emote control) in the lock to unlock your
v
ehicle. F
O
pen the front armrest:
●
R
aise the mat by its tongue and
r
emove it.
●
P
lace the electronic key on the back-up
re
ader.
F S witch on the ignition by pressing the "
ST
ART/STOP"
button.
The
electronic key is fully operational again.
If
the problem persists, contact a CITROËN dealer
o
r a qualified workshop as soon as possible.
Battery
ref.:
CR2032
/
3
volts.
Battery
replacement
is
signalled
by
the
display
o
f
a
message.
F
U
nclip
the
cover
using
a
small
screwdriver
a
t
the
cutout.
F
L
ift
off
the
cover.
F
R
emove
the
flat
battery
from
its
location.
F
F
it the new battery into its location
observing
the
original
direction
of
fitment.
F
C
lip
the
cover
onto
the
casing.
3
Access
Page 66 of 494

64
Remote control
The high frequency remote control is a sensitive system; do not operate it while it is in your pocket as there is a possibility that it may unlock the vehicle, without you being aware of it.
Do
not repeatedly press the buttons of your remote control out of range and out of sight of your vehicle. You run the risk of stopping it from
w
orking and the remote control would have to be reinitialised.
The
remote control does not operate when the key is in the ignition, even when the ignition is switched off.
Locking the vehicle
Driving with the doors locked may make access to the passenger compartment by the emergency services more difficult in an emergency.
A s a safety precaution (with children on board), remove the key from the ignition or take the electronic key when you leave the vehicle, even for
a
short time.
Electrical interference
The Keyless Entry and Starting electronic key may not operate if close to certain electronic devices: telephone, laptop computer, strong magnetic fields, ...
Anti-theft protection
Do not make any modifications to the electronic engine immobiliser system; this could cause malfunctions.
D on't forget to turn the steering to engage the steering lock.
Lost keys, remote control, electronic key
Visit a CITROËN dealer with the vehicle's V5 registration document and your personal identification documents.
T he CITROËN dealer will be able to retrieve the key code and the transponder code required to order a replacement.
Do
not throw the remote control batteries away, they contain metals which are harmful to the environment.
Take
them to an approved collection point.
When purchasing a second-hand vehicle
Have the key codes memorised by a CITROËN dealer, to ensure that the keys in your possession are the only ones which can start the vehicle.
Access
Page 68 of 494

66
Activation / Deactivation
You can activate or deactivate this function permanently.
F
W
ith the ignition on, press this button
u
ntil an audible signal starts and a
c
orresponding message is displayed.
The
state of the system stays in memory when
s
witching off the ignition.
Anti-intrusion security
Operation
If one of the doors or the boot is open, the a
utomatic central locking does not take place.
This
system allows automatic simultaneous locking of the doors and boot as soon as the speed of
t
he vehicle exceeds 6 mph (10 km/h).
Pressing the central locking button unlocks the
v
ehicle.
Above
6 mph (10 km/h), this locking is
t
e m p o r a r y. This
is signalled by the sound of
t
he locks rebounding, accompanied
b
y illumination of this symbol in the
i
nstrument panel, an audible signal
a
nd the display of an alert message.
Carrying long and voluminous
objects
If
you want to drive with the boot open,
y
ou should press the central locking
b
utton to lock the the doors. Other wise,
e
very time the speed of the vehicle
e
xceeds 6 mph (10 km/h), the locks
w
ill rebound and the alerts mentioned
a
bove will appear.
Access
Page 70 of 494

68
Locking the vehicle with full
alarm system
Activation
F Switch off the ignition and get out of the v
ehicle.
F
L
ock the vehicle with the remote control.
or
F
L
ock the vehicle with the "Keyless Entry
a
nd Starting" system.
Deactivation
F Press the unlocking button on the remote c
ontrol.
or
F
U
nlock the vehicle with the "Keyless Entry
a
nd Starting" system.
The
monitoring system is deactivated: the
i
ndicator lamp in the button goes off and the
d
irection indicators flash for about 2 seconds.
If
an
opening
(door,
boot...)
is
not
closed
f
ully,
the
vehicle
is
not
locked
but
the
exterior
p
erimeter
monitoring
will
be
activated
after
a
d
elay
of
45
seconds
at
the
same
time
as
the
i
nterior
volumetric
and
anti-tilt
monitoring. When
the vehicle automatically locks
i
tself again (as happens if a door or
b
oot is not opened within 30 seconds of
u
nlocking), the monitoring system is not
r
eactivated automatically. To reactivate
t
he system, it is necessary to unlock
t
he vehicle and then lock it again using
t
he remote control or the "Keyless Entry
a
nd Starting" system.
The
monitoring
system
is
active:
the
indicator
l
amp
in
the
button
flashes
once
per
second
a
nd
the
direction
indicators
come
on
for
about
2
seconds.
Following
an
instruction
to
lock
the
vehicle,
t
he
exterior
perimeter
monitoring
is
activated
a
fter
a
delay
of
5
seconds
and
the
interior
v
olumetric
and
anti-tilt
monitoring
after
a
delay
o
f
45 seconds.
Access
Page 71 of 494

69
Locking the vehicle
with exterior perimeter
monitoring only
Deactivate the interior volumetric and anti-tilt monitoring to avoid unwanted triggering of the
a
larm in certain cases such as:
-
l
eaving a pet in the vehicle,
-
l
eaving a window partially open,
-
w
ashing your vehicle,
-
c
hanging a wheel,
-
h
aving your vehicle towed,
-
t
ransport by sea.
Deactivation of the interior
volumetric and anti-tilt monitoring
F Switch off the ignition and within t
en seconds, press the button until the
i
ndicator lamp is on continuously.
F
G
et out of the vehicle.
F
I
mmediately lock the vehicle using the
r
emote control or the Keyless Entry and
S
tarting system.
The
exterior perimeter monitoring alone is
a
ctivated: the indicator lamp in the button
f
lashes once per second.
Reactivation of the interior
volumetric and anti-tilt monitoring
F Deactivate the perimeter monitoring by u
nlocking the vehicle with the remote
c
ontrol or the Keyless Entry and Starting
s
ystem.
T
he indicator lamp in the button goes off.
F
R
eactivate all monitoring by locking the
v
ehicle with the remote control or the
K
eyless Entry and Starting system.
T
he indicator lamp in the button flashes
o
nce per second again.
To
be effective, this deactivation must
b
e carried out each time the ignition is
s
witched off.
3
Access
Page 72 of 494

70
Operating fault
When the ignition is switched on, fixed illumination of the indicator lamp in the button
i
ndicates a fault with the system.
Have
it checked by a CITROËN dealer or a
q
ualified
w
orkshop.
Failure of the remote control
To deactivate the monitoring functions:
F
u
nlock the vehicle using the key (integral to
t
he
remote
control)
in
the
driver's
door
lock,
F
o
pen the door; the alarm is triggered,
F
s
witch on the ignition; the alarm stops; the
i
ndicator lamp in the button goes off.
Locking the vehicle without
activating the alarm
F Lock or deadlock the vehicle using the key (
integral to the remote control) in the
d
river's door lock.
Triggering of the alarm
This is indicated by sounding of the siren and flashing of the direction indicators for
t
hirty seconds.
The
monitoring functions remain active until
t
he alarm has been triggered eleven times in
s
uccession.
When
the vehicle is unlocked using the remote
c
ontrol or the Keyless Entry and Starting
s
ystem, rapid flashing of the indicator lamp
i
n the button informs you that the alarm was
t
riggered during your absence. When the
i
gnition is switched on, this flashing stops
i
mmediately.
Access
Page 77 of 494

75
Electric windows
1. Driver's electric window.
2. Passenger's electric window.
3.
R
ear right electric window.
4.
R
ear left electric window.
5.
D
eactivation of the rear electric window
controls. There
are two options:
-
m
anual mode
F
P
ress or pull the control gently. The
w
indow stops when the control is
r
eleased.
-
a
utomatic mode
F P ress or pull the control firmly. The w
indow opens or closes fully when the
c
ontrol is released.
F
P
ressing the control again stops the
m
ovement of the window.
One-touch electric
windows
The electric window controls remain operational for approximately
4
5 seconds after the ignition is switched
o
ff or until the vehicle is locked after a
d
oor is opened.
If
one of the passenger windows cannot
b
e operated from the driver's door
c
ontrol panel, carry out the operation
from
the control panel of the passenger
d
oor in question.
After
approximately ten consecutive
c
omplete opening/closing movements
o
f the window, a protection function is
a
ctivated which only authorises closing
o
f the window to prevent damage to the
e
lectric window motor.
Once
the window is closed, the controls
w
ill become operational again after
a
pproximately 40 minutes.
Fitted
with
a
safety
anti-pinch
system
and
a
deactivation
system
for
the
rear
controls.
3
Access
Page 79 of 494

77
F For the safety of your children, press c
ontrol 5 to deactivate the rear electric
w
indow controls, regardless of their
p
osition.
Indicator
lamp on, the rear controls are
d
eactivated.
Indicator
lamp off, the rear controls are
a
ctivated.
Deactivation of the rear
electric window controls
If an obstacle is encountered during o peration of the electric windows, you
m
ust reverse the movement of the
w
indow. To do this, press the control
c
oncerned.
When
the driver operates the controls
f
or the passengers' electric windows,
t
hey must ensure that nothing is
p
reventing the windows closing
c
o r r e c t l y.
The
driver must ensure that the
p
assengers use the electric windows
c
o r r e c t l y.
Be
particularly aware of children when
o
perating
t
he
w
indows.
Take
care of any passengers and/or
o
ther persons present when closing the
w
indows using the remote control or the
"
Keyless Entry and Starting" system.
Always
remove the key from the ignition
w
hen leaving the vehicle, even for a
s
hort time.
3
access
Page 94 of 494

92
Driver's seat electric adjustments
Forwards-backwards
F Tilt the rear part of the control upwards or d
ownwards to obtain the required height.
F
T
ilt the front part of the control upwards or
d
ownwards to obtain the required angle.
Cushion height and angle
F Tilt the control for wards or rear wards to a
djust the angle of the seat backrest.
Seat backrest angle
F Push the control for wards or rear wards to s
lide the seat. Before
moving the seat backwards, ensure that there is nothing that might prevent the full
t
ravel of the seat, so as to avoid the risk of of jamming the seat caused by the presence of
o
bjects on the floor behind the seat or rear passengers. If the seat jams, stop the movement
i
mmediately.
The electrical functions of the driver's seat
a
re deactivated approximately one minute
a
fter the ignition is switched off.
To reactivate them, switch on the ignition.
Comfort
Page 99 of 494

97
Mirrors
Each fitted with an adjustable mirror glass permitting t he la teral r earward v ision n ecessary f
or overtaking or parking. They can also be
f
olded for parking in confined spaces.
Demisting - Defrosting Adjustment
F Move control A
to the right or to the left to s
elect the corresponding mirror.
F
M
ove control B in all four directions to
adj
ust.
F
R
eturn control A to the central position.
Folding
F From outside: lock the vehicle using the r
emote control or the key.
F
F
rom inside: with the ignition on, pull the
c
ontrol A in the central position rear wards.
If
your
vehicle
is
fitted
with
heated
m
irrors,
the
demisting-defrosting
o
perates
by
switching
on
the
h
eated
rear
screen.
Refer
to
the
"Rear
screen
demist-
defrost"
s
ection. As
a
safety
measure,
the
mirrors
should
b
e
adjusted
to
reduce
the
blind
spots.
The
objects
observed
are,
in
reality,
c
loser
than
they
appear.
Take
this
into
account
in
order
to
c
orrectly
judge
the
distance
of
vehicles
a
pproaching
from
behind. If
the mirrors are folded using control A,
they
will not unfold when the vehicle is
u
nlocked. Pull again on control A.
Door mirrors
4
Comfort