light Citroen C5 2007.5 (DC/DE) / 1.G User Guide
[x] Cancel search | Manufacturer: CITROEN, Model Year: 2007.5, Model line: C5, Model: Citroen C5 2007.5 (DC/DE) / 1.GPages: 231, PDF Size: 7.63 MB
Page 27 of 231
30
II
G
C
F
ADBE
I N S T R U M E N T P A N E L
A Fuel gaugeB Indicator:Coolant temperature
Cruise control/Speed limiter informationC Speed indicatorD Rev counterE Indicator:Engine oil temperature
Gear selector position and gear engaged (Auto-matic gearbox)
F Controls:Lighting rheostat
Resetting to zero of trip mileage computer and maintenance indicator
Page 28 of 231
43
II
A
2121
I N S T R U M E N T P A N E L
Engine oil temperature gauge
Under normal operating condi-tions, the bars should be within section 1.
In severe operating conditions, the bars may extend into section 2.
In this event, slow down, and if nec-essary, stop the engine and check the levels (see chapter - Mainte-nance - “Levels”).
Fuel gauge
On horizontal ground, the lighting of the fuel low warning lamp warns you that you are using the reserve tank.
A message alert is displayed on the instrument panel.
Coolant temperature indica-tor
Under normal operating condi-tions, the bars should be within section 1.
In severe operating conditions, the bars may extend into section 2, the engine coolant temperature warn-ing lamp A and the STOP warning lamp will light up, stop immedi-ately.Switch off the ignition. The cooling fan may continue to operate for a certain time. Allow the engine to cool down while tak-ing the precautions indicated in chapter - Maintenace - “Levels”.
Contact a CITROËN dealer.
If the SERVICE warning lamp lights up, check the levels (see chapter - Maintenance - “Levels”).
Page 30 of 231
32
II
STOP warning lamp
When the warn-ing lamp comes on, you must stop the vehicle and switch off the engine. Contact a CITROËN dealer.switch off the engineswitch off
Parking brake
The permanent lighting of t h i s w a r n i n g l a m p c o n fi r m s that the parking brake is applied.
I f t h i s w a r n i n g l a m p fl a s h e s , i t i n d i -cates a fault with its application or release. Consult a CITROËN cates a fault with its application application
dealer as soon as possible.
See “Brakes”.
With the engine running, and when displayed at the same time as the STOP warning lamp, it indi- c a t e s t h a t t h e b r a k e fl u i d l e v e l i s too low.
If this warning lamp comes on, stop immediately and contact a CITROËN dealer.stop immediately and immediately
See “Brakes”.
Battery charge
This warning lamp comes on temporarily when the engine is switched on. If it remains on permanently, contact a CITROËN dealer.remains on permanens on
In the event of a battery failure, the application of the electronic parking brake when the engine is switched off is not guaranteed. You must therefore apply the parking brake before switching off the engine.
I N S T R U M E N T P A N E L
W A R N I N G L A M P S
SERVICE
This warning lamp remains on perma-nently, as long as the fault displayed on the instru-ment panel screen is present (for serious faults).
Consult a CITROËN dealer as soon as possible.
This warning lamp remains on only for a short time for faults that are minor.
Contact a CITROËN dealer.
ESP/ASR
Operating
If either of the ESP or ASR systems is active, the warning l a m p fl a s h e s .
For a malfunction
With the engine running, the light-ing of this warning lamp along with a message on the instrument panel screen, the lighting of the SERV-ICE warning lamp and a sound signal, indicates a system fault.
Contact a CITROËN dealer.
Deactivation
The lighting of this warning lamp and the light on the ESP deactiva- t i o n b u t t o n c o n fi r m s t h a t t h e s y s -tem is deactivated.
See “Dynamic stability control” (ESP).
Coolant temperature
It comes on for a few sec-onds each time you switch on the ignition.
If this warning lamp comes on, engine running, it tells you that the coolant temperature is rising abnormally.
This warning lamp is linked with the STOP warning lamp.
It is essential to stop the vehi-cle.
Check the coolant level.
If the level is too low, contact a CITROËN dealer.If the level is too
Page 31 of 231
33
II
Front passenger's airbag deactivation warning lamp
See “Airbags”.
I N S T R U M E N T P A N E L
W A R N I N G L A M P S
Front passenger's air-bag activation warn-ing lamp
See “Airbags”.
Seat belt not fastened
This warning lamp is located on the roof console, in front of the front interior lamp. It informs you of the driver and passenger seat belts which are not fastened.
The lit up locations represent the seat positions which are not fas-tened.
Driver's seat belt not fastened:The warning lamp lights up from 0 to 20 km/h (12 mph).Over 20 km/h (12 mph):
t h e w a r n i n g l a m p fl a s h e s ,a beep is repeated for about 2 minutes with 3 progressive loudness levels.
Page 32 of 231
34
II
The simultaneous lighting of the SERVICE warning lamp and the display of the message “ P a r t i c l e fi l t e r ( F A P ) a d d i -tive level too low” on the instrument panel screen indicates that the additive needs to be topped up.
Contact a CITROËN dealer as soon as possible.
I N S T R U M E N T P A N E L
P A R T I C L E F I L T E R
I n a d d i t i o n t o t h e c a t a l y t i c c o n v e r t e r , t h i s fi l t e r c o n t r i b u t e s a c t i v e l y t o t h e p r e s e r v i n g o f a i r q u a l i t y , b y c o l l e c t i n g t h e polluting particles that have not been burnt off. Black exhaust fumes are thus eliminated.
C l o g g i n g o f t h e p a r t i c l e fi l t e r
C l o g g i n g i s c a u s e d b y t h e p a r t i c l e fi l t e r s t a r t i n g t o b e s a t u r a t e d ( o w i n g t o e x c e p t i o n a l l y l o n g p e r i o d s s p e n t d r i v i n g i n u r b a n c o n d i t i o n s : l o w s p e e d s , t r a f fi c j a m s , e t c . ) .
I n o r d e r t o r e g e n e r a t e t h e fi l t e r y o u a r e a d v i s e d t o d r i v e a s s o o n a s p o s s i b l e , w h e n t r a f fi c c o n d i t i o n s a l l o w , a t a s p e e d of 60 km/h (36 mph) or more for at least 5 minutes. If the problem persists, contact a CITROËN dealer. I n o r d e r t o r e g e n e r a t e t h e fi l t e r y o u a r e a d v i s e d t o d r i v e a s s o o n a s p o s s i b l e , w h e n t r a f fi c c o n d i t i o n s a l l o w , a t a s p e e d I n o r d e r t o r e g e n e r a t e t h e fi l t e r y o u a r e a d v i s e d t o d r i v e a s s o o n a s p o s s i b l e , w h e n t r a f fi c c o n d i t i o n s a l l o w , a t a s p e e d
Note: If the vehicle has been running for long periods at very low speeds or at idle, vapour emissions may be seen coming from the exhaust under acceleration. These have no consequ ences for the running of the vehicle or for the environment.
The simultaneous lighting of the SERVICE warning lamp and the display of the message “Risk of saturation of par- t i c l e fi l t e r ( F A P ) ” on the instrument panel screen indicates an increased risk of saturation.
Contact a CITROËN dealer as soon as possible.
DIESEL additive level
Page 39 of 231
41
II
A
B
I N S T R U M E N T P A N E L
M A I N M E N U
“Vehicle parameters” menu
This allows you to access the parameters relating to:The vehicle lighting.
The comfort levels in the vehicle.
See “Instrument panel - Vehicle parameters”.
Page 40 of 231
42
II
I N S T R U M E N T P A N E L
V E H I C L E P A R A M E T E R S
“Vehicle parameters” menu
This menu can be accessed from the instrument panel “Main menu”. It allows you to set the lighting and comfort set-tings for your vehicle.
“Lighting” menu
Once you have selected this menu, you can:Activate/deactivate the lighting of the day-time-running lamps.
Activate/deactivate the guide-me-home lighting and adjust its duration.Activate/deactivate the dual-function Xenon directional headlamps.
Page 44 of 231
47
II
A
3
1
2
4
1
LIGHTING CONTROL STALK1 : Off.
2 : Automatic lighting.
3 : Sidelamps.4 : Dipped beams / Main beams.
All vehicle lamps off
Rotate the ring A forwards.
They go out once the brightness has reached a satisfactory level or about 5 minutes after the wind-screen wipers have stopped.
To activate this function, turn the ring A to position 2.
Take care not to cover the bright-ness sensor, which is visible from outside the windscreen, behind the interior rear view mir-ror.
Automatic lighting of headlamps
The sidelamps and the dipped beams come on automatically w h e n t h e l i g h t i s i n s u f fi c i e n t o r i f the windscreen wipers are in con-tinuous operation.
Rotate the ring A forwards.
Sidelamps on
Dipped beams/main beams on
Pull the control stalk towards youto change between dipped beam and main beam.
Rotate the ring A forwards.
S I G N A L L I N G
Manual headlamp height adjustment
You are advised to adjust the aim of the headlamps in accordance with vehicle load.0. 1 or 2 people in the front seats.-. 3 people.1. 5 people.-. Intermediate setting.2. 5 people + maximum permitted load.-. Intermediate setting.3. Driver + maximum permitted load.
Visible alert / headlamp fl a s h
Pull the control towards you.
T h e h e a d l a m p fl a s h c a n b e m a d e even with the ignition switched off.
Page 45 of 231
48
IIAB
F o r v e h i c l e s fi t t e d w i t h r e a r foglamps:1st turn forwards: lighting of rear foglamps.1st turn rearwards: extinction of rear foglamps.
F o r v e h i c l e s fi t t e d w i t h f r o n t and rear foglamps:1st turn forwards: lighting of front foglamps.2nd turn forwards: lighting of rear foglamps.1st turn rearwards: extinction of rear foglamps.2nd turn rearwards: extinction of front foglamps.Note: the foglamps should be used only in fog or in other conditions of poor visibility.
-
-
-
-
-
-
FRONT AND REAR FOGLAMPS (RING B)
These operate in conjunction with the sidelamps, the dipped beams or the main beams.
S I G N A L L I N G
GUIDE-ME-HOME LIGHTING
With the ignition off, this function temporarily switches on your head-lamps to give you exterior lighting when leaving your vehicle.
This function is activated:Manually by pulling the lighting stalk towards you, ignition off.Automatically in the following conditions:
automatic headlamp lighting is activated,guide-me-home lighting is activated.brightness conditions are low.using button A on the remote control.
You can modify the length of time guide-me-home lighting stays on for (around 60, 30 or 15 seconds) using the “Main Menu” of the instru-ment panel screen.
See “Instrument panel screen”.
Page 46 of 231
49
II
B E N D L I G H T I N G
Without bend lightingWith bend lighting
With dipped or main beams, this function provides additional lighting for the inside of a bend.
This lighting is most useful when travelling at low and medium speed (urban driving, winding road, intersections...).
Operation
This lighting is activated past a cer-tain angle of rotation of the steer-ing wheel. It is deactivated with the vehicle stationary or at very low speed, or with reverse gear engaged.