FORD MUSTANG 2003 Workshop Manual

FORD MUSTANG 2003 Workshop Manual MUSTANG 2003 FORD FORD https://www.carmanualsonline.info/img/11/56942/w960_56942-0.png FORD MUSTANG 2003 Workshop Manual
Trending: oil change, tire pressure, tires, air bleeding, overheating, ESP inoperative, trailer

Page 1741 of 4378

FORD MUSTANG 2003  Workshop Manual 19. Disconnect the heater hoses. 
20. Remove the wiring support bracket. 
21. Disconnect the connectors. 
22. Raise the cover and remove the nut and cables.  Klj .  5 ba
  192003 Mustang Workshop

Page 1742 of 4378

FORD MUSTANG 2003  Workshop Manual 23. Disconnect the hose from the coolant bypass tube. 
24. Disconnect the A/C suction tube from the accumulator. 
25. Disconnect and remove the A/C suction tube. 
26. Disconnect the A/C tube. Position

Page 1743 of 4378

FORD MUSTANG 2003  Workshop Manual 27.
NOTE:  The lifting bracket bolts will be installed when the vehicle is raised. 
Position the RH lifting bracket. 
28. Install the LH lifting bracket. 
29. Disconnect the radiator vent hose from th

Page 1744 of 4378

FORD MUSTANG 2003  Workshop Manual 31. Remove the nuts and the degas bottle 
32. Remove the shifter. For additional information, refer to 
Section 307 - 01  or 
Section 308 - 03B  . 
33. Remove the dual converter H- pipe. For additiona

Page 1745 of 4378

FORD MUSTANG 2003  Workshop Manual 36. Index-
mark the driveshaft flange and the rear axle pinion flange. 
37. Remove the four bolts 
38. Index- mark the driveshaft at the six oclock position. 
39.  CAUTION: the driveshaft flange fits

Page 1746 of 4378

FORD MUSTANG 2003  Workshop Manual NOTE: 
Do not rotate the driveshaft. 
Using a suitable tool, disconnect the driveshaft flange from the rear axle flange and remove the 
driveshaft. 
40. Index- mark the transmission output shaft at th

Page 1747 of 4378

FORD MUSTANG 2003  Workshop Manual 43. Remove the three bolts and the starter. 
Automatic transmission vehicles  44. Remove the flywheel inspection cover. 
45. Remove the torque converter nuts.  All vehicles  Klj .  11 ba
  192003

Page 1748 of 4378

FORD MUSTANG 2003  Workshop Manual 46. Remove the nut and the wiring harness bracket. 
47. Remove the nuts and position the wiring harness aside. 
48. Disconnect the oil pressure sensor. 
49. Remove the nut and the engine ground cable.

Page 1749 of 4378

FORD MUSTANG 2003  Workshop Manual 51. Disconnect and remove the lower hose from the radiator. 
52.
NOTE:  Drain the power steering fluid into a suitable container. 
Disconnect the hose from the power steering reservoir. 
53. Remove th

Page 1750 of 4378

FORD MUSTANG 2003  Workshop Manual 55. Remove the ground strap bolt. 
56. Remove the degas bottle support bracket. 
57. Install the two bolts from the RH lifting bracket. 
58. Disconnect the reversing lamp switch electrical connector,
Trending: water pump, change wheel, recommended oil, service schedule, warning, auxiliary battery location, trailer