Circuit ISUZU KB P190 2007 Workshop Repair Manual

ELECTRICAL-BODY AND CHASSIS 8A-131

CIRCUIT DIAGRAM 4JJ1-TC/4JK1-TC (LHD) G.EXP Sheet 4/5









RTW 78AXF026301


BACK TO CHAPTER INDEX TO MODEL INDEXISUZU KB P190 2007

8A-132 ELECTRICAL-BODY AND CHASSIS

CIRCUIT DIAGRAM 4JJ1-TC/4JK1-TC (LHD) G.EXP Sheet 5/5








RTW 78AXF026401


BACK TO CHAPTER INDEX TO MODEL INDEXISUZU KB P190 2007

ELECTRICAL-BODY AND CHASSIS 8A-133

CIRCUIT DIAGRAM 4JJ1-TC (RHD) EXCEPT SOUTH AFRICA Sheet 1/5


RTW 78AXF030301


BACK TO CHAPTER INDEX
TO MODEL INDEXISUZU KB P190 2007

8A-134 ELECTRICAL-BODY AND CHASSIS

CIRCUIT DIAGRAM 4JJ1-TC (RHD) EXCEPT SOUTH AFRICA Sheet 2/5


RTW 78AXF030401


BACK TO CHAPTER INDEX
TO MODEL INDEXISUZU KB P190 2007

ELECTRICAL-BODY AND CHASSIS 8A-135

CIRCUIT DIAGRAM 4JJ1-TC (RHD) EXCEPT SOUTH AFRICA Sheet 3/5


RTW 78AXF030501


BACK TO CHAPTER INDEX
TO MODEL INDEXISUZU KB P190 2007

8A-136 ELECTRICAL-BODY AND CHASSIS

CIRCUIT DIAGRAM 4JJ1-TC (RHD) EXCEPT SOUTH AFRICA Sheet 4/5









RTW 78AXF030601


BACK TO CHAPTER INDEX TO MODEL INDEXISUZU KB P190 2007

ELECTRICAL-BODY AND CHASSIS 8A-137

CIRCUIT DIAGRAM 4JJ1-TC (RHD) EXCEPT SOUTH AFRICA Sheet 5/5








RTW 78AXF030701


BACK TO CHAPTER INDEX TO MODEL INDEXISUZU KB P190 2007

8A-138 ELECTRICAL-BODY AND CHASSIS

CIRCUIT DIAGRAM 4JH1-TC (LHD) Sheet 1/2





RTW 78AXF004601


BACK TO CHAPTER INDEX TO MODEL INDEXISUZU KB P190 2007

ELECTRICAL-BODY AND CHASSIS 8A-139

CIRCUIT DIAGRAM 4JH1-TC (LHD) Sheet 2/2






RTW 78AXF004701


BACK TO CHAPTER INDEX TO MODEL INDEXISUZU KB P190 2007

8A-140 ELECTRICAL-BODY AND CHASSIS
REMOVAL AND INSTALLATION

ECM (ENGINE CONTROL MODULE);
C24SE

Removal
1. Lift both the ECM harness connector locking levers and
remove the two harness connectors form the ECM.
2. Remove the four socket head screws securing the ECM to the mounting bracket.
3. Remove the ECM from the engine compartment .


4. Pull out the ECM.
5. Disconnect both red and tan connectors.
Refer to the Section 6E-ENGINE of this Manual.
IMPORTANT: The replacement ECM must be programmed.
“SPS (Service Programming System) and immobilizer
programming (if equipped) is/are necessary”





Installation
Follow the removal procedure in the reverse order to install the
ECM.
Pay close attention to the important points mentioned in the
following paragraphs.



Connector
Be absolutely sure that ECM is securely connected.
This will prevent a poor contact and open circuit.



BACK TO CHAPTER INDEX TO MODEL INDEXISUZU KB P190 2007