76.22.27 JAGUAR X308 1998 2.G Workshop Manual

            501‐17:  Roof  Open
ing
 Panel  
                 Description  and  Operation  
                     Roof Opening  Panel  
                 General Procedures  
                     Motor Synchronization  (76.82.48)  
                     Roof Opening  Panel  Alignment  
                 Removal and  Installation  
                     Roof Opening  Panel  (76.82.05)  
                     Roof Opening  Panel  Frame  (76.82.01)  
                     Roof Opening  Panel  Module  (86.76.07)  
                     Roof Opening  Panel  Motor  (86.76.01)  
                     Roof Opening  Panel Shie
ld (76.82.06)  
                     Roof Opening  Panel  Trim  
                     Roof Opening  Panel  Weatherstrip  (76.82.15)  
 
             501‐19:  Bumpers  
                 Specification  
                 Description  and  Operation  
                     Bumpers 
                 Removal and  Installation  
                     Front Bumper  (76.22.08)  
                     Front Bumper  and  Bumper  Cover  (76.22.08)  
                     Front Bumper  Cover  (76.22.78)  
                     Front Bumper  Isolator  (76.22.31)  
                     Rear Bumper  (76.22.27)  (76.22.52)  
                     Rear Bumper  Co
ver  (76.22.74)  (76.22.77)  
                     Rear Bumper  Isolator  (76.22.70)  
 
             501‐20A : Safety  Belt  System  
                 Specification  
                 Description  and  Operation  
                     Safety Belt  System  
                 Removal and  Installation  
                     Front Safety  Belt  Retractor  (76.73.10)  
                     Rear Safety  Belt  Retractor  (76.73.18)  
                     Safety Belt  Shoulder  Height  Adjuster  (76.73.12)  
  

Bumpers - Rear Bumper Isolator
Removal and Installation
Removal
Installation

1.
Remove rear bumper assembly. Refer to 76.22.77 and
76.22.27.

2. Remove four nuts securing stru t to rear cross-member, remove strut from vehicle and discard gasket.
1. Position strut and new gasket on cross-member and fit and
tighten securing nuts on studs.
2. Fit bumper assembly to struts. Refer to 76.22.27 and
76.22.77.