torque JAGUAR XFR 2010 1.G Workshop Manual

3. NOTE: Tighten the bolts in the indicated sequence.

Torque: 12 Nm





















4. NOTE: Tighten the bolts in the indicated sequence.
Torque: 12 Nm

7.
















8.
9.
10. NOTE: Tighten the bolts in the indicated sequence.

Torque: 12 Nm













Torque: 12 Nm
















Torque: 12 Nm
















Torque: 12 Nm

2. Torque: 12 Nm 3.
Install the special tool to each Camshaft.
Special Tool(s): 303-1452 Torque: 10 Nm













4.
Carefully rotate the camshafts if the position is not
as shown.

10.




































11. Make sure the tensioner piston is fully extended. Then fully
depress and lock the tensioner piston with the grenade pin
before installation, failure to do this may result in damage
to the engine.

































CAUTION: Do not release the timing chain tensioner
locking pin at this stage.
Torque: 10 Nm

15.




































16. Make sure the tensioner piston is fully extended. Then fully
depress and lock the tensioner piston with the grenade pin
before installation, failure to do this may result in damage
to the engine.

































CAUTION: Do not release the timing chain tensioner
locking pin at this stage.
Torque: 10 Nm

20.
21.
Install the special tool.
Special Tool(s): 303-1482






















CAUTIONS:


Apply the torque to the end of the special tool.


Make sure that the torque wrench is aligned with the
special tool as illustrated in the graphic.
Install the torque wrench to the special tool.
Torque: 35 Nm

22.























23. CAUTION: Make sure that the torque wrench does not
move whilst tightening the VVT bolts.


NOTE: Make sure to tighten the exhaust VVT unit
bolts first.
Torque: 32 Nm Special Tool(s): 303-1482
















Install the oil suction tube.
Torque: 10 Nm

24.
25.
Install the special tool.
Special Tool(s): 303-1482






















CAUTIONS:


Apply the torque to the end of the special tool.


Make sure that the torque wrench is aligned with the
special tool as illustrated in the graphic.
Install the torque wrench to the special tool.
Torque: 35 Nm www.JagDocs.com

26. CAUTION: Make sure that the torque wrench does not
move whilst tightening the VVT bolts.

first. NOTE: Make sure to tighten the inlet VVT unit bolts
Torque: 32 Nm












27.
28.
Remove the special tool.

























Remove the special tool.

29.
30.
31.
Remove the special tool.
Special Tool(s): 303-1447















Install the special tool.
Special Tool(s): 303-1448
















CAUTION: Install the crankshaft pulley bolt with an
M16 washer to prevent damage to the crankshaft on
installation.
Torque: 50 Nm