Mercury Mountaineer 1997 s Workshop Manual

locking the doors and liftgate. To
lock the doors:
²press 7/8 and 9/0 buttons at the
same time.
This will arm your anti-theft
system; seeArming anti-theft
system with keyless entryand
Anti-theft systemlater in this
chapter for more details.
Arming anti-theft system with
keyless entry
To arm the anti-theft system:
²press 7/8 and 9/0 buttons at the
same time.
To disarm the anti-theft system:
²enter either the factory-set code
or your personal code.
Doors, liftgate, and liftgate window
must be fully closed for the
anti-theft system to arm. See
Anti-theft systemfor more details.
Autolock
Autolock is a feature of the keyless
entry system and is enabled at the
factory. Autolock will automatically
lock all doors and liftgate when:
²all vehicle doors, liftgate, and
liftgate window are closed.
²ignition switch is in the ON
position.
²brake pedal is pressed.
²you shift through R (Reverse).
²brake pedal is released.
Controls and features
51

Relock
The autolock feature will repeat
when:
²any door is opened and closed.
²the brake pedal is released.
Deactivating autolock
Before following the activation or
deactivation procedures, make sure
that the anti-theft system is not
armed, ignition is off, and all
vehicle doors and liftgate window
are closed.
1. Enter five-digit entry code.
2. Press and hold 7/8 button.
3. Press and release 3/4 button
while holding 7/8 button.
4. Release 7/8 button.
To re-activate autolock, repeat
Steps 1-4.
Remote keyless entry system (if
equipped)
The remote entry system allows
you to lock or unlock all vehicle
doors without using a key.
The remote entry system also arms
and disarms the anti-theft system
(seeAnti-theft systemlater in this
chapter for more information).
The remote entry system only
operates with the ignition in the
OFF position.
Your vehicle is equipped with two
transmitters. The system will work
with up to four transmitters.
LOCK
PANICUN
LOCK
Controls and features
52

Additional transmitters can be
ordered from your dealer.
Unlocking the doors with the
remote entry system
Press UNLOCK button to unlock
driver door. The interior lamps will
illuminate.
Press UNLOCK a second time
within 5 seconds to unlock all
doors and liftgate.
Locking the doors with the
remote entry system
Press the LOCK button to lock all
doors and liftgate.
Press the LOCK button a second
time within 5 seconds to confirm
that all doors and liftgate are
locked.
The doors will lock again, the horn
will chirp, and the lamps will flash.
This will arm your anti-theft
system. If the horn chirps twice, a
door is still ajar and the anti-theft
system will not arm. SeeAnti-theft
systemfor more details.
Remote entry personal alarm
The remote entry personal alarm
feature allows you to activate the
alarm. When activated, the horn
will honk and the lights will flash.
LOCK
PANICUN
LOCK
PANICUN
LOCKLOCK
Controls and features
53

Press the PANIC button to activate
the alarm.
To turn off the alarm, press the
PANIC button again or turn the
ignition key to the ON or ACC
position.
This device complies with Part 15
of the FCC rules. Operation is
subject to the following two
conditions: (1)This device may not
cause harmful interference, and
(2)This device must accept any
interference received, including
interference that may cause
undesired operation.
Replacing the batteries
If you notice a decrease in
operating range, replace the
transmitter batteries. Replacement
batteries can be purchased at most
pharmacies or through your Ford
or Lincoln-Mercury dealer. The
transmitter is powered by two coin
type three-volt lithium 2016
batteries.
The operating range of the remote
entry transmitters can also be
affected by adverse weather
conditions, nearby radio/tv towers,
or large structures around the
vehicle. Typical operating range is
up to 10 meters (33 feet).
Opening the transmitter
Insert and twist a thin coin
between the two halves of the
transmitter; the transmitter will
snap apart.
LOCK
PANICUN
LOCK
Controls and features
54

When installing new batteries, be
sure to place the positive (+) side
down as marked. Snap the two
halves back together.
Replacing lost transmitters
If a transmitter is lost, take your
vehicle's transmitter to the dealer
to have the remote entry system
deprogrammed for the lost
transmitter. This will prevent
unauthorized use of the lost
transmitter.
You can purchase additional
transmitters (up to four can be
used) from your dealer. Use the
following instructions to
re-program the key fobs.
Re-programming your key
fob(s)
1. Insert key into ignition.
2. Rotate key to ON five times. DO
NOT START THE ENGINE. Keep
key in ON position the fifth time.
Locks will lock/unlock by
themselves.
3. Push UNLOCK on first key fob.
Doors will lock/unlock to indicate
key fob has been programmed.
4. Repeat Step 3 for each key fob
to be re-programmed.
5. Turn ignition key to OFF. Verify
each transmitter has been
programmed by activating any
button.
Controls and features
55

Anti-theft system (if equipped)
When set, the anti-theft system
protects against unauthorized
entry into a locked vehicle.
The ignition switch must be in the
OFF position to arm the anti-theft
system.
Arming the anti-theft system
Use one of the following methods
to arm the system:
²Press the LOCK button on the
remote entry transmitter (with
doors open or closed).
OR
²Open any door and press the
power lock button.
OR
²Press the 7/8 and 9/0 buttons on
the keyless entry keypad (see
Keyless entry systemfor more
information).
Identifying system indicators
While the system is arming, theTHEFTindicator will illuminate for
30 seconds. After 30 seconds, the
THEFTindicator will flash.
If the system is armed with the
doors open,
THEFTwill stay
illuminated until all doors are
closed. After all doors are closed,
it will illuminate for 30 seconds
and then start flashing.
When an unauthorized entry
occurs, the system activates and
will:
Controls and features
56

²flash the headlamps, park lamps
and theTHEFTindicator in the
instrument cluster.
²sound the horn.
²disable vehicle starting.
The flashing exterior lamps and
honking horn will shut off
automatically after about 3
minutes. The lights and horn will
remain off unless another
unauthorized entry is attempted.
However, the vehicle will not start
until the system is properly
disarmed.
How to disarm the system
To cancel an armed system, you
must:
²press the UNLOCK button on
the remote entry transmitter.
OR
²unlock any door with the key.
OR
²turn the ignition switch to the
ON position.
OR
²unlock the doors by entering the
unlock code into the keyless
entry keypad.
How to deactivate a triggered
system
To immediately cancel an activated
system, press the PANIC button on
the remote entry transmitter.
A triggered system can also be
deactivated by following the steps
inHow to disarm the system.
Controls and features
57

Delayed accessory
Delayed accessory provides power
to operate the power windows and
power moon roof (if equipped) for
10 minutes after the ignition
switch is turned to OFF.
If either front door is opened
during the 10 minute period the
delayed accessory feature is
disabled.
Battery saver
Battery saver is a feature that
automatically shuts off power to
these lights after 40 minutes: glove
box, engine compartment,
overhead console, mirror, courtesy
and interior lamps.
Battery saver prevents the battery
from being drained if these lights
are left on or if a door is not
completely closed. Battery power
is restored if the remote entry
transmitter is used, any door is
opened, the liftgate is opened, or
ignition key is turned to ON.
Controls and features
58

FRONT BUCKET SEATS
Adjusting manual seats
Lift to move the seat forward or
backward.
Pull up to recline the seat.
Seating and safety restraints
59

Adjusting power seats (if
equipped)
Pull up to recline the seat.
Press to tilt front and rear of seat
up or down.
Seating and safety restraints
60