Abs sensor MITSUBISHI ENDEAVOR 2004 Service Workshop Manual

MITSUBISHI ENDEAVOR 2004 Service Workshop Manual ENDEAVOR 2004 MITSUBISHI MITSUBISHI https://www.carmanualsonline.info/img/19/57105/w960_57105-0.png MITSUBISHI ENDEAVOR 2004 Service Workshop Manual

Page 265 of 3870

MITSUBISHI ENDEAVOR 2004  Service Workshop Manual Fig. 160: Identifying Front ABS Sensor/Rear ABS Sensor
 
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA. 
INSPECTION ABS SENSOR CHECK  
2004 Mitsubishi Endeavor LS 
2004 BRAKES Anti-Lock Braking System

Page 266 of 3870

MITSUBISHI ENDEAVOR 2004  Service Workshop Manual 1. Check whether any metallic foreign material has adhered to the projection at 
the speed sensor tip. Remove any foreign material. Also check whether the 
pole piece is damaged. Replace it with a new

Page 267 of 3870

MITSUBISHI ENDEAVOR 2004  Service Workshop Manual replace it with a new ABS sensor.  
4. Remove all connections from the ABS sensor. The circuit should be open 
between terminals (1) and (2) and the body of the ABS sensor. If the circuit is 
not open

Page 268 of 3870

MITSUBISHI ENDEAVOR 2004  Service Workshop Manual with a new one if a problem is found.  
TOOTHED ABS ROTOR CHECK Check whether the ABS rotor teeth are broken or deformed. Replace the BJ 
assembly of the drive shaft, or the rear hub assembly, respect

Page 269 of 3870

MITSUBISHI ENDEAVOR 2004  Service Workshop Manual Fig. 164: Removing & Installing G
-Sensor
 
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA. 
INSTALLATION SERVICE POINT >>A<< G-SENSOR INSTALLATION The arrow mark on the G-sensor must point toward the

Page 270 of 3870

MITSUBISHI ENDEAVOR 2004  Service Workshop Manual Fig. 165: Disconnecting G
-Sensor Connector And Connectin
g Special Tool 
MB991348
 
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
 
2004 Mitsubishi Endeavor LS 
2004 BRAKES Anti-Lock Braking System

Page 271 of 3870

MITSUBISHI ENDEAVOR 2004  Service Workshop Manual 2. With the ignition switch turned to the "ON" position, read the voltage between 
terminals number 2 and number 3. 
Standard Value: 2.4 - 2.6 V  
3. With special tool MB991348 connected, rota

Page 1095 of 3870

MITSUBISHI ENDEAVOR 2004  Service Workshop Manual MOTORS MOTORS LOCATION SENDING UNITS & SENSORS SENDING UNITS & SENSORS LOCATION 
4 .
Power Window Main Switch CPU
Integral to power window main switch. 
See Fig. 15
 .
SRS ECU
Under front of center co

Page 1096 of 3870

MITSUBISHI ENDEAVOR 2004  Service Workshop Manual A/C Pressure Sensor
Right front of engine 
compartment.Fig. 49
 .
Air Thermo Sensor
Above accelerator pedal.Fig. 60
 .
Ambient Temperature Sensor
Behind left side of front bumper.Fig. 
55 .
Camshaft P

Page 1097 of 3870

MITSUBISHI ENDEAVOR 2004  Service Workshop Manual SOLENOIDS & SOLENOID VALVES SOLENOIDS & SOLENOID VALVES LOCATION Photo Sensor
Top front center of dash.Fig. 58
 .
Right Bank Heated Oxygen Sensor 
(Front)
On inlet of right catalytic 
converter.Fig. 4