SSANGYONG KORANDO 1997 Service Repair Manual

LIGHTING SYSTEM 9B-27
SSANGYONG MY2002
REAR FOG LAMP
KAA9B250

SSANGYONG MY2002
9B-28 LIGHTING SYSTEM
STOP LAMP, BTSI (BRAKE TRANSMISSION SHIFT INTERLOCK) - METAL TOP
KAA9B260

LIGHTING SYSTEM 9B-29
SSANGYONG MY2002
STOP LAMP, BTSI (BRAKE TRANSMISSION SHIFT INTERLOCK) - SOFT TOP
KAA9B270

SECTION 9C
HORNS
CAUTION: Disconnect the negative battery cable before removing or installing any electrical unit or when a
tool or equipment could easily come in contact with exposed electrical terminals. Disconnecting this cable
will help prevent personal injury and damage to the vehicle. The ignition must also be in LOCK unless
otherwise noted.
TABLE OF CONTENTS
Description and Operation.................................. 9C-2
Horns ................................................................. 9C-2
Components Locator ........................................... 9C-3
Lighting System................................................. 9C-3Repair Instructions............................................... 9C-4
On-Vehice Service Unit Repair............................... 9C-4
Dual Horns......................................................... 9C-4
Schematic and Routing Diagram....................... 9C-5
Horn Wiring System............................................ 9C-5

SSANGYONG MY2002
9C-2 HORNS
DESCRIPTION AND OPERATION
HORNS
The horns are located in the front bumper. They are at
tached near the radiator at the front of the vehicle. The
horns are actuated by pressing the steering wheel pad,
which grounds the horns’ electrical circuit.

HORNS 9C-3
SSANGYONG MY2002
COMPONENTS LOCATOR
LIGHTING SYSTEM
1 HORN
KAA9C010

SSANGYONG MY2002
9C-4 HORNS
REPAIR INSTRUCTIONS
KAA9C020
ON-VEHICLE SERVICE
UNIT REPAIR
DUAL HORNS (LEFT HORN
SHOWN, RIGHT HORN SIMILAR)
Removal and Installation Procedure
1. Disconnect the negative battery cable.
2. Disconnect the electrical connector.
3. Remove the bolt and the horn.
Dissimilar metals in direct contact with each
other may corrode rapidly. Make sure to use
the correct fasteners to prevent premature
corrosion.
4. Installation should follow the removal procedure
in the reverse order.

HORNS 9C-5
SSANGYONG MY2002
SCHEMATIC AND ROUTING DIAGRAMS
HORN WIRING SYSTEM
KAA9C030

Description and Operation.................................. 9D-2
Windshield Wiper System................................... 9D-2
Windshield Washer System................................ 9D-2
Components Locator ........................................... 9D-3
Lighting System................................................. 9D-3
Repair Instructions............................................... 9D-4
On-Vehice Service Unit Repair............................... 9D-4
Windshield Wiper Arm........................................ 9D-4
Windshield Wiper Motor...................................... 9D-4
Windshield Wiper Blade..................................... 9D-5
Windshield Washer Reservoir............................. 9D-5
SECTION 9D
WIPER, WASHER SYSTEMS
CAUTION: Disconnect the negative battery cable before removing or installing any electrical unit or when a
tool or equipment could easily come in contact with exposed electrical terminals. Disconnecting this cable
will help prevent personal injury and damage to the vehicle. The ignition must also be in LOCK unless
otherwise noted.
TABLE OF CONTENTS
Windshield Washer Pump................................... 9D-6
Windshield Washer Nozzles................................ 9D-6
Windshield Washer Hoses.................................. 9D-6
Rear Wiper Arm.................................................. 9D-6
Rear Wiper Motor................................................ 9D-7
Rear Washer Reservoir....................................... 9D-7
Specifications...................................................... 9D-8
Fastener Tightening Specifications...................... 9D-8
Schematic and Routing Diagrams...................... 9D-9
Windshield Wipers System................................. 9D-9

SSANGYONG MY2002
9D-2 WIPER, WASHER SYSTEMS
DESCRIPTION AND OPERATION
WINDSHIELD WIPER SYSTEM
The windshield wiper system consists of a wiper motor,
a linkage, wiper arms and blade, and a wiper/washer
switch. The windshield wiper circuit incorporates a self
parking device which consists of a worm gear and a
camplate in order to keep the circuit engaged
temporarily when the switch is turned off. The wiper
system is driven by a permanent magnet-type motor.
The windshield wiper motor is mounted on the dash
panel and is directly con-nected to the windshield
wiper linkage.
The windshield wiper motor has two speeds, LO and
HI, and also has intermittent wiper. The wiper switch
is an integral part of the wiper/washer switch.
Windshield wiper operation is actuated through the
lever on the right side of the steering column.
WINDSHIELD WASHER SYSTEM
The windshield washer system is equipped with a
washer fluid reservoir, a washer fluid pump, hoses,
nozzles, and a wiper/washer switch. The windshield
washer reservoir is mounted above the front right apron
panel. Attached to the reservoir is a washer pump,
which pumps fluid through the hoses to the two nozzles
mounted on the hood. The washer switch is an integral
part of the wiper/washer switch. Windshield washer
operation is actuated through the lever on the right
side of the steering column.