SSANGYONG KORANDO 2013 Service Manual

8710-01

AUTO hazard warning flasher control
The hazard warning lamp comes on 3 times (T3) when the AUTO hazard warning lamp switch is
pressed for less than 0.6 seconds (T1). A. Operation 1.
The hazard warning lamp comes on 10 times (T4) when the AUTO hazard warning lamp switch is
pressed for 0.6 seconds or more (T2).
The turn signal lamp switch is pressed during the AUTO hazard warning lamp operation.
The corresponding turn signal lamp is activated after this AUTO hazard warning lamp operation. B.
C.
D. Operation 2.
The AUTO hazard warning lamp can be controlled only with IGN ON.
The input from the AUTO hazard warning lamp switch is ignored during the turn signal lamp
operation by the turn signal lamp switch.
Priority of operation: (Hazard warning lamp switch > LH/RH turn signal lamp > AUTO hazard
warning lamp switch) -
-
-
Operating process

8710-01

Emergency hazard warning lamp control (coupled with ABS)
The emergency stop signal is input from the ABS/ESP module with the vehicle driven at 50 km/h or
more.
The hazard warning lamp flashes at 4 Hz (T1) and internal buzzer (chime) sounds at 1.25 Hz. A.
B. Operation 1. (emergency stop signal)
During operation 1 (emergency stop signal activated)
The vehicle speed decreased to 50 km/h or less
The hazard warning lamp flashes for 10 seconds (T2) at 1.25 Hz and then goes out. C.
D.
E.
The BCM activates emergency hazard warning lamp operation when receiving emergency braking
signal from the ESP/ABS.
Priority of operation
(Manual operation of hazard warning lamp > Emergency stop signal > Emergency AUTO hazard
warning lamp > AUTO hazard warning lamp) -
lamp)
During operation 2 (emergency AUTO hazard warning lamp)
The hazard warning lamp switch is turned OFF.
The hazard warning lamp is turned OFF because the manual operation overrides the emergency
AUTO operation. F.
G.
H.
The emergency stop signal and emergency AUTO hazard warning lamp signal are switched off
when the vehicle speed exceeds 10 km/h (if emergency stop signal is input).

8710-01

Operating process
The BCM activates emergency hazard warning lamp operation when receiving emergency braking
flasher ON signal from the ESP/ABS.
When the emergency stop signal is input through the P-CAN, the hazard warning lamp flashes with the
frequency of 4 Hz and the internal buzzer sounds at 1.25 Hz.
P-CAN signal during operation: Emergency Stop=EBL_INFO=0*0=Hazard Warning Lamp unrequested

8710-01
Rear fog lamp control (only EU)
When pressing the rear fog lamp switch with IGN2 ON (headlamp ON condition),
The rear fog lamps are turned on.
When pressing the rear fog lamp switch again during the operation,
The rear fog lamps are turned off. A.
B.
C.
D. Operation 1.
The rear fog lamps are turned off.
The rear fog lamps are not turned on automatically without operating the rear fog lamp switch. E.
F.
G. Operation 2.

Folding/unfolding control
The folding switch is turned ON.
The folding relay is activated for 16 seconds (T1). A.
B. Operation 1.
The folding switch is turned OFF.
The unfolding relay is activated for 16 seconds (T1). C.
D. Operation 2.
The folding relay is activated by the folding switch.
The folding switch is turned OFF.
The unfolding relay is activated after 0.1 seconds (T2). E.
F.
G. Operation 3.
21. OUTSIDE REAR VIEW MIRROR FOLDING/UNFOLDING
The AUTO folding/unfolding function is not available when the folding switch is ON.
The AUTO folding/unfolding function is available when the folding switch is OFF. -
-The control logic is the same for folding to unfolding operation and unfolding to folding operation. -

8710-01
Approach lamp control (for vehicles without SKM)
The lamp is illuminated for 30 seconds when the REKES key UNLOCK signal is received in theft
deterrent mode.
The lamp is illuminated when the driver door is opened after the ignition is turned OFF. A.
B. Operation 1. (Puddle lamp ON conditions)
When the door LOCK signal is received with the lamp ON (the system enters the theft deterrent
mode)
When the ignition is turned ON with the lamp ON.
Thirty seconds after the lamp ON C.
D.
E. Operation 2. (Puddle lamp OFF conditions)
22. APPROACH (PUDDLE) LAMP
Approach lamp control (for vehicles with SKM)
The lamp is illuminated for 30 seconds when UNLOCK signal by the smart key or door handle switch
is received in theft deterrent mode.
The lamp is illuminated when the driver door is opened after the ignition is turned OFF. A.
B. Operation 1. (Puddle lamp ON conditions)
When the door LOCK signal is received with the lamp ON (the system enters the theft deterrent
mode)
When the ignition is turned ON with the lamp ON.
Thirty seconds after the lamp ON C.
D.
E. Operation 2. (Puddle lamp OFF conditions)

Priority of BCM buzzer control
23. BUZZER CONTROL
External buzzer
(SKM buzzer)Internal buzzer (chime)Warning horn
Internal buzzer (chime)