JAGUAR XFR 2010 1.G Workshop Manual
Page 1491 of 3039
12.
13.
14.
Make sure that the alignment mark is visible through
the inspection hole on removal of the last torque
converter bolt.
NOTE: Mark the position of the driveshaft on the
transmission flange.
Page 1492 of 3039
15.
Using a suitable tie strap, secure the driveshaft.
16. WARNING: Make sure that the transmission is secured with
suitable retaining straps.
Using a suitable stand, support the transmission.
17.
18.
NOTE: The transmission is lowered for access.
Lower the rear of the transmission for access. www.JagDocs.com
Page 1493 of 3039
19.
20.
21. NOTE: The transmission is lowered for access.
Page 1494 of 3039
22.
23.
24.
CAUTION: Make sure that the torque converter
remains in the transmission.
NOTE: This step requires the aid of another
technician.
Install the torque converter retainer.
CAUTIONS:
Be prepared to collect escaping fluids.
Make sure that all openings are sealed. Use new
blanking caps.
Page 1495 of 3039
Page 1496 of 3039
Installation
1. Torque: 5 Nm
2.
3.
Clamp the hoses to minimize coolant loss.
4. CAUTIONS:
Be prepared to collect escaping fluids.
Make sure that all openings are sealed. Use new
blanking caps.
Page 1497 of 3039
5. CAUTION: Make sure the torque converter is fully
located into the oil pump drive.
6. CAUTION: Make sure that the torque converter
remains in the transmission.
NOTE: Some variation in the illustrations may occur,
but the essential information is always correct.
Raise the powertrain assembly jack and transmission
assembly. www.JagDocs.com
Page 1498 of 3039
7. NOTE: Transmission shown removed for clarity.
Torque: 48 Nm
8. Torque: 48 Nm 9. Torque: 48 Nm
Page 1499 of 3039
10. Torque: 45 Nm
11.
Remove the support.
12.
13. Torque: 110 Nm
CAUTION: Only rotate the crankshaft clockwise.
NOTE: Make sure that the alignment mark is visible
through the inspection hole as illustrated.
Torque: 63 Nm