torque JAGUAR XFR 2010 1.G Workshop Manual

Page 1099 of 3039


6. CAUTION: Install new o-ring seals

Torque: 9 Nm































7.
8.

Page 1100 of 3039



9.















10.
11.
NOTE: Remove and discard the blanking caps.















Torque: 3 Nm
























Torque: 9 Nm

Page 1101 of 3039












































Torque: 10 Nm www.JagDocs.com

Page 1102 of 3039


















Torque: 12 Nm













18.
Lower the vehicle.

Page 1127 of 3039

5. Torque: 2 Nm 6. CAUTION: Be prepared to collect escaping coolant.

NOTE: Only carry out the following step if the coolant
is to be drained from the engine.












7. NOTE: This step is only required if previously
removed.

Torque: 50 Nm












Filling

1. Refer to: Radiator Splash Shield (501-02 Front End Body Panels, Removal and Installation).

2. Lower the vehicle.

Page 1136 of 3039


























Torque: 50 Nm













12.
Carry out the procedure up to step 1 in the filling section three times,
filling the cooling system with clean water at the first two drains. At the
third refill, use a suitable measuring tool to make sure that the cooling
system maintains a 50% mix.

Filling

1.

Page 1143 of 3039

Published: 14-Apr-2014
Engine Cooling - V8 5.0L Petrol/V8 S/C 5.0L Petrol - Coolant Expansion Tank
Removal and Installation

Removal


NOTE: Removal steps in this procedure may contain installation details.

1. Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).

2. Using a syringe, remove the cooling fluid from the expansion tank.


3. CAUTION: Take extra care not to damage the
component.
Torque: 7 Nm






























4.

Page 1147 of 3039


















Torque: 7 Nm

Page 1151 of 3039


8. CAUTION: A new O-ring seal is to be installed.

Torque: 8 Nm





















9. CAUTION: A new O-ring seal is to be installed.
Torque: 8 Nm










10. Lower the vehicle.

11. Refer to: Air Cleaner Outlet Pipe LH (303-12C Intake Air Distribution and Filtering - V8 5.0L Petrol, Removal and Installation).

12. Refer to: Air Cleaner Outlet Pipe RH (303-12C Intake Air Distribution and Filtering - V8 5.0L Petrol, Removal and Installation).

13. Refer to: Air Cleaner Outlet Pipe T-Connector (303-12D Intake Air Distribution and Filtering - V8 S/C 5.0L Petrol, Removal and Installation).

14. Refer to: Air Cleaner RH (303-12C Intake Air Distribution and Filtering - V8 5.0L Petrol, Removal and Installation).

15. Refer to: Air Cleaner LH (303-12C Intake Air Distribution and Filtering - V8 5.0L Petrol, Removal and Installation).

Page 1152 of 3039


16.
















17.
18.
19. NOTE: Some variation in the illustrations may occur,
but the essential information is always correct.
Torque: 9 Nm













CAUTION: Be prepared to collect escaping coolant. www.JagDocs.com

Page:   < prev 1-10 ... 141-150 151-160 161-170 171-180 181-190 191-200 201-210 211-220 221-230 ... 470 next >