JAGUAR XFR 2010 1.G Workshop Manual

Removal


NOTE: Removal steps in this procedure may contain installation details.

1. Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).


2. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.

3. Refer to: Cooling Fan Motor and Shroud - Vehicles With: Supercharger (303-03C Engine Cooling - V8 5.0L Petrol/V8 S/C 5.0L Petrol, Removal
and Installation).

4. Refer to: Starter Motor (303-06C Starting System - V8 5.0L Petrol/V8 S/C 5.0L Petrol, Removal and Installation).

5. www.JagDocs.com

9.

Torque: 25 Nm

12.
























13. NOTE: The graphic shows the tool position for LH
thread only, RH thread will be the opposite.
Support the special tool using a suitable vehicle stand.






















CAUTION: Discard the bolt.

NOTES:


The graphic shows the step for LH thread only, RH
thread will be the opposite.


The crankshaft pulley bolt will be very tight.


The thread is left handed.

14.
15.
16.

























Remove the special tool.

















NOTES:


If the crankshaft damper is fitted with an early RH
thread crankshaft bolt then the pulley can be removed with
a standard puller.


Discard the bolt after removal. www.JagDocs.com

Install the special tool.

Special Tool(s): 303-1439

21.
22.
23.


























CAUTION: Discard the friction washer after removing
the crankshaft pulley.


NOTE: Make sure to clean the threads in the end of
the crankshaft and that the crank nose is free of any foreign
materials.