fuses BMW MOTORRAD G 650 XCHALLENGE 2007 Rider's Manual (in English)

BMW Motorrad auxiliary
stand ......................... 81
BMW Motorrad front-wheel
stand ......................... 82
Fuses........................ 84
Bulbs ......................... 86
Air filter . . . . . .................. 92
Jump starting . . .............. 95
Battery . . . . . .................. 96
Number-plate carrier . . ..... 100
9 Care . . . . . ................ 103
Care products . . ............ 104
Washing motorcycle . . . ..... 104
Cleaning easily damaged
components ................ 104
Paint care . . ................ 105
Protective wax coating ..... 106
Laying up motorcycle . ..... 106
Restoring motorcycle to
use......................... 106
10 Technical data . . . . . . . 107
Troubleshooting chart . ..... 108
Threaded fasteners . . . ..... 109
Engine . . . . . ................ 110
Fuel . ....................... 111Engine oil . . ................ 111
Clutch...................... 112
Transmission............... 112
Rear-wheel drive........... 113
Running gear............... 113
Brakes . . . . . ................ 114
Wheels and tyres........... 115
Electrics . . . . ................ 117
Frame...................... 118
Dimensions ................ 119
Weights . . . . ................ 119
Riding specifications . . ..... 120
11 Service . . . . . . . . . . . . . . . . 121
BMW Motorrad service ..... 122
BMW Motorrad service
quality...................... 122
BMW Motorrad Service
Card: on-the-spot break-
down assistance........... 122
BMW Motorrad service net-
work . ....................... 123
Maintenance work . . . . . ..... 123
Confirmation of mainten-
ance work . . ................ 124
Confirmation of service ..... 129

General view, right side1Seat lock ( 41)
2Fuel filler neck ( 52)
3Brake-fluid reservoir, front
( 69)
4Adjuster for damping char-
acteristic, front suspension
(rebound stage) ( 38)
5ABS fuses, behind the side
panel ( 85)
6Brake-fluid reservoir, rear
( 70)
213zGeneral views

with OE BMW Motorrad ABS:
Switch on the ignition.
Pre-ride check is performed.
( 47)
ABS self-diagnosis is
performed. ( 48)
Wait until the warning light for
the coolant temperature stops
flashing.
The idle actuator is posi-
tioned after you switch on
the ignition. The coolant-tem-
perature warning light flashes
if the idle actuator has not cor-
rectly positioned before the pre-
ride check completes. In order
to avoid subsequent problems,
wait for this process to complete
before proceeding.Press starter button1.
If ambient temperatures are
very low, you might find it
necessary to open the throttle
slightly when starting the engine.
At ambient temperatures below
0 °C, disengage the clutch after
switching on the ignition.
If the engine fails to start
even though the starter
turns, insufficient battery voltage
might be causing the problem.
Recharge the battery before you
start the engine, or use jump
leads and a donor battery to
start.The engine starts.
Consult the troubleshooting
chart below if the engine re-
fuses to start. ( 108)
Pre-ride checkThe instrument cluster runs a
test of the instruments and the
warning lights and telltale lights
and the display when the igni-
tion is switched on. This test is
known as the "Pre-Ride-Check".
Phase 1
All the telltale and warning lights
are switched on briefly, along
with all the segments of the mul-
tifunction display.
Phase 2
The tyre parameters stored in
the memory of the instrument
cluster appear briefly on the dis-
play.
The instrument cluster then
reverts to its normal operating
mode.
547zRiding

Maintenance
Maintenance
Notes................................ 64
Toolkit . . ............................. 64
Engine oil............................ 65
Brake system ........................ 67
Brake pads . . ........................ 68
Brake fluid........................... 69
Coolant . ............................. 71
Clutch . . ............................. 72
Tyres................................ 73
Rims................................. 73
Chain................................ 73
Wheels . ............................. 75
BMW Motorrad auxiliary stand....... 81
BMW Motorrad front-wheel
stand................................ 82Fuses . . .............................. 84
Bulbs . . .............................. 86
Air filter .............................. 92
Jump starting ........................ 95
Battery . .............................. 96
Number-plate carrier............... 100
863zMaintenance

NotesThe Maintenance chapter de-
scribes straightforward proced-
ures for checking and replacing
certain wear parts.
Special tightening torques are lis-
ted as applicable. The tightening
torques for the threaded fasten-
ers on your motorcycle are listed
in the section entitled "Technical
data".
You will find information on more
extensive maintenance and re-
pair work in the Repair Manual
on DVD/CD-ROM (RepROM) for
your motorcycle, which is avail-
able from your authorised BMW
Motorrad dealer.
Some of the work calls for spe-
cial tools and a thorough know-
ledge of motorcycles. If you
are in doubt consult a specialist
workshop, preferably your author-
ised BMW Motorrad dealer.
ToolkitStandard on-board toolkit1 Fuse puller
Replacing fuses
2 Open-ended spanner, w/f
8/10
Adjusting chain tension
3 Open-ended spanner, w/f
19
Adjusting mirror arm
4 Open-ended spanner, w/f
19
Adjusting mirror arm5 Screwdriver handle
Holder for screwdriver blade9
6 3 mm Allen key
Replacing headlight bulb
7 4 mm Allen key
Removing and installing body
panels
8 6 mm Allen key
Adjusting headlight beam throw
9 Screwdriver blade
Star-head and flat-tip blade
Adjusting rear suspension
damping
864zMaintenance

If the front of the motor-
cycle is raised too far the
auxiliary stand will lift clear of the
ground and the motorcycle could
topple to one side.
When raising the motorcycle,
make sure that the auxiliary stand
remains on the ground. If ne-
cessary, adjust the height of the
front-wheel stand or the auxiliary
stand.
Apply uniform pressure to push
the front-wheel stand down
and raise the motorcycle.
FusesRemoving fuse
Risk of fire if an attempt is
made to jumper defective
fuse.
Always replace defective fuses
with new fuses of the correct
amperage rating.
Switch off the ignition.
Remove the seat ( 41)
Push latching lever1and open
the fuse cover.
Check the fuse-assignment
diagram and pull the defectivefuse up and out of the fuse
box.
If fuse defects recur fre-
quently have the electric
circuits checked by a specialist
workshop, preferably an author-
ised BMW Motorrad dealer.
Fuse assignmentAABS (OE) (10 A)
BEngine management control
unit (15 A)
CLow-beam headlight (7.5 A)
DBrake light, horn, instru-
ment cluster, diagnosis plug
(7.5 A)
884zMaintenance

ESide light, number-plate
light, headlight flasher, high-
beam headlight (7.5 A)
FStarter relay, flashing turn
indicators, diagnosis plug
(15 A)
GSpare fuse (15 A or 10 A
for optional extra)
HSpare fuse (7.5 A)
ISpare fuse (15 A)Installing fuseRemove the defective fuse and
replace it with a fuse of the
correct amperage rating.
Close the fuse cover.
The latch engages with an
audible click.
Install the seat ( 42)Removing ABS fuse
Risk of fire if an attempt is
made to jumper defective
fuse.
Always replace defective fuseswith new fuses of the correct
amperage rating.
Switch off the ignition.
Remove the right side panel
( 99)
Check the fuse-assignment
diagram and pull the defective
fuse up and out of the fuse
box.
If fuse defects recur fre-
quently have the electric
circuits checked by a specialist
workshop, preferably an author-
ised BMW Motorrad dealer.
Fuse assignment, ABS
OE
1ABS (30 A)
2Spare fuse (30 A)
3Spare fuse (20 A)
4ABS (20 A)Installing ABS fuseRemove the defective fuse and
replace it with a fuse of the
correct amperage rating.
Install the right side panel
( 99)
885zMaintenance

ElectricsElectrical rating of on-board socket
with OE BMW Motorrad ABS or with OA
Power socket:5A
Fuses Plug-in "Minifuses" with ratings of 7.5 A and 15 A
with OE BMW Motorrad ABS: Plug-in "Minifuses" with ratings of 10 A, 20 A and
30 A
Battery
Battery, manufacturer and designation ETZ 10 S
Battery type AGM (Absorptive Glass Mat) battery
Battery rated voltage 12 V
Battery rated capacity 10 Ah
Spark plugs
Spark plugs, manufacturer and designation NGK DR8 EB
Electrode gap of spark plug 0.6...0.7 mm, When new
max 0.9 mm, Wear limit
10117zTechnical data

A
Abbreviations and symbols, 6
ABS
Engineering details, 55
Fuses, 13, 85
Self-diagnosis, 48
Switching off and on, 15, 33
Warnings, 23
Accessories
Notes, 60
Power socket, 60
Air Damping System, 34
Adjusting air pressure, 34, 35
Air pressure and
temperature, 35
Fore-and-aft tilt indicator, 11,
35
Periods of disuse, 36
Air filter, 14
Replacing, 92
Auxiliary stand, 81
B
Battery
Charging, 97
Maintenance instructions, 96Removing and installing, 98
Technical data, 117
Voltmeter, 20, 30
BMW Motorrad service, 122
BMW Motorrad Service
Card, 122
Brake fluid
Checking level, 69
Reservoir, front, 13
Reservoir, rear, 13
Brake pads
Running in, 49
Test, 68
Brakes
Notes, 50
Technical data, 114
Test, 67
Bulbs
Notes on replacement, 86
Replacing low-beam headlight
bulb, 86
Replacing number-plate light
bulbs, 91
Replacing rear light, 91
Replacing side-light bulb, 89Replacing turn indicator
bulb, 90
Technical data, 118
C
Care, 103
Chain
Adjusting tension, 74
Checking tension, 74
Checking wear, 75
Lubricating, 73
Checklist, 46
Clock, 20
Adjusting, 17, 29
Clutch
Adjusting play, 73
Checking play, 72
Technical data, 112
Confirmation of maintenance
work, 124
Coolant
Checking level, 71
Fore-and-aft tilt indicator, 11
Topping up, 72
12131zIndex

Coolant temperature
Warning, 22
D
Damping
Adjusting, 11, 13
Dimensions, 119
Display, 28
Overview, 20
Selecting readings, 17, 28
E
Electrics
Technical data, 117
Emergency off switch (kill
switch), 16, 32
Engine
Starting, 16, 46
Technical data, 110
Engine oil
Checking level, 65
Filler neck, 14
Oil dipstick, 14
Technical data, 111
Topping up, 67Engine oil pressure
Warning, 22
Equipment, 7
F
Frame
Technical data, 118
Front-wheel stand, 82
Fuel
Filler neck, 13
Refuelling, 52
Technical data, 4, 111
Warning, 22
Fuses, 14, 84
ABS, 85
G
General views
Display, 20
Headlight, 18
Instrument cluster, 17
Left handlebar fitting, 15
Left side, 11
Right handlebar fitting, 16
Right side, 13
Status indicators, 20Telltale lights, 20
Underneath the seat, 14
Warnings, 20
H
Handlebar fitting, left
Overview, 15
Handlebar fitting, right
Overview, 16
Headlight
Beam throw, 41
Driving on right/driving on
left, 41
General views, 18
Replacing low-beam headlight
bulb, 86
Replacing side-light bulb, 89
Headlight flasher, 15, 31
High-beam headlight, 18
Switch, 15
Telltale light, 20
Horn, 15
I
Idle
Telltale light, 20
12132zIndex