lock FORD AEROSTAR 1997 1.G Service Manual

168
%*
[GF04000(ALL)01/96]
Steering Your Vehicle
%*
[GF04100(ALL)01/96]
Your vehicle comes with power steering. Power
steering uses energy from the engine to help
steer your vehicle.
%*
[GF04150(ALL)03/96]
If the amount of effort needed to steer your
vehicle changes at a constant vehicle speed, have
the power steering system checked. If the power
steering system breaks down (or if the engine is
turned off), you can steer the vehicle manually
but it takes more effort.
*
[GF04200(ALL)01/96]
Never hold the steering wheel to the extreme
right or left for more than five seconds if the
engine is running. This can damage the power
steering pump.
*
[GF04300(ALL)01/96]
NOTE: After any severe impact such as
striking large potholes, sliding into
curbs on icy roads, or a collision
involving the front end, observe the
steering wheel alignment. If the spokes
of the steering wheel seem to be in a
different position while going straight
down the road, have the front
suspension and steering checked for
possible damage.
[GF10000(ALL)03/96]Automatic Transmission
Operation (4R44E/5R55E)
[GF10050(ALL)06/96]
If your vehicle is equipped with an automatic
transmission, it will be either a four speed
overdrive transmission (4R44E) or a five speed
overdrive transmission (5R55E). All 3.0L engines
use the 4R44E transmission, while all 4.0L
engines use the 5R55E transmission. Both
transmission types have a lockup torque
converter. Transmission operation is controlled
by the Powertrain Control Module (PCM).
File:09cpgfa.ex
Update:Wed Jun 5 12:04:06 1996

171 [GF10920(ALL)06/96]
one third page art:0095028-A
*
[GF11000(ALL)05/96]
RWARNING
Hold the brake pedal down while you
move the gearshift lever from position to
position. If you do not hold the brake
pedal down, your vehicle may move
unexpectedly and injure someone.
*
[GF12000(ALL)05/96]
Once you place the gearshift securely into
position, gradually release the brake pedal and
use the accelerator as necessary.
%*
[GF12100(ALL)05/96]
NOTE: Your vehicle is equipped with a
brake-shift interlock feature. This
feature prevents you from shifting
from P (Park) unless you have the
brake pedal depressed. (The ignition
must be in the ON position.) If you
cannot shift from P (Park) with the
brake pedal depressed:
*
[GF12200(ALL)05/96]
1. Apply the parking brake.
*
[GF12300(ALL)05/96]
2. Remove the key.
*
[GF12400(ALL)05/96]
3. Insert the key and rotate it one position
clockwise (ignition in the OFF position).
File:09cpgfa.ex
Update:Wed Jun 5 12:04:06 1996

172
*
[GF12500(ALL)05/96]
4. Apply the brake pedal and shift to N
(Neutral). (If the vehicle is shifted back to P
[Park], you must repeat the previous steps.)
*
[GF12600(ALL)05/96]
5. Start the vehicle.
*
[GF12700(ALL)05/96]
If you need to shift out of P (Park) by using the
alternate procedure described above, it is
possible that a fuse has blown and that your
brakelamps may also not be functional. Please
refer to the chapter titledRoadside Emergenciesin
this Owner Guide for instructions on checking
and replacing fuses.
*
[GF12800(ALL)05/96]
RWARNING
DO NOT DRIVE YOUR VEHICLE UNTIL
YOU VERIFY THAT THE BRAKELAMPS
ARE WORKING.
*
[GF12820(ALL)05/96]
P (Park)
[GF12830(ALL)03/96]
Always come to a complete stop before you shift
into P (Park). This position locks the
transmission and prevents the rear wheels from
turning.
[GF12840(ALL)03/96]
To securely latch the gearshift in the P (Park)
position, pull it toward you, push it completely
counterclockwise against the stop, and then push
it toward the instrument panel.
*
[GF12850(ALL)06/96]
The gearshift is securely latched in P (Park) if
you cannot rotate it in a clockwise direction
without lifting it toward you.
*
[GF12860(ALL)05/96]
RWARNING
Always set the parking brake fully and
make sure the gearshift is latched in P
(Park). Turn off the ignition whenever you
leave your vehicle.
File:09cpgfa.ex
Update:Wed Jun 5 12:04:06 1996

181 [GF29250(ALL)01/96]
Standard length vehicles adapted for trailer tow
may require relocation of the underbody spare
tire. It is recommended that you secure the tire
under the rear-most seat using the hold-down
hardware located with the jack.
[GF29301(ALL)01/96]
one third page art:0020268-A
Spare tire stowage (standard length model)
*
[GF29350(ALL)01/96]
Do not tow a trailer until your vehicle has been
driven at least 500 miles (800 km).
%
*
[GF29401(ALL)01/96]
Vehicle Loading/Towing
Information
*
[GF29450(ALL)01/96]
Your vehicle's load capacity is designated by
weight, not volume, so you cannot necessarily
use all available space with large or heavy loads.
Maximum safe vehicle weights as well as tire,
rim sizes and inflation pressures are specified for
your vehicle at the assembly plant on the Safety
Compliance Certification Label. The Certification
Label is located on the left front door lock facing
or the door latch post pillar.
File:09cpgfa.ex
Update:Wed Jun 5 12:04:06 1996

212 [ER05400(ALL)01/96]If your vehicle is the model with a standard
length body or extended length (all models), the
temporary spare tire is stowed at the rear of the
vehicle under the body.
[ER05450(ALL)01/96]
The standard length E-4WD model spare tire is
mounted on the floor.
[ER05500(ALL)01/96]
To remove underbody temporary spare tire:
[ER05600(ALL)01/96]
1. Insert lug nut wrench into the actuator hole
and turn counterclockwise until the cable
extends to allow the spare tire to be pulled
rearward from under the vehicle.
[ER05700(ALL)04/96]
2. Slide the spare tire to the rear and remove
the retainer from the wheel.
[ER05800(ALL)01/96]
3. To stow cable/retainer with spare tire
removed, insert cable fitting into carrier rear
wall slot, place wheel retainer against the
carrier, and turn lug nut wrench clockwise
until slack is removed.
File:10cpera.ex
Update:Thu Jun 6 14:45:00 1996

213 [ER05900(ALL)01/96]
three fourths page art:0020265-A
Temporary spare tire location and assembly
[ER06000(ALL)01/96]
To stow underbody temporary spare tire:
[ER06100(ALL)01/96]
1. Insert lug nut wrench into the actuator hole
and turn counterclockwise until the
cable/retainer is extended for insertion into
the wheel.
[ER06200(ALL)04/96]
2. Install the retainer through wheel center
with valve stem facing up.
File:10cpera.ex
Update:Thu Jun 6 14:45:00 1996

214 [ER06300(ALL)01/96]3. Rotate wrench clockwise until tire is secured.
(Raising mechanism will slip.)
[ER06400(ALL)04/96]
4. Check for proper seating against underbody
supports and retighten if necessary.
[ER06500(ALL)01/96]
half page art:0020266-B
Spare tire Ð underbody carrier
[ER06600(ALL)01/96]
RWARNING
Do not stow any conventional spare tire
or flat temporary spare tire in the
underbody position. Doing so may cause
damage to the tire, rear axle, or brake
lines. (Standard length only)
[ER06800(ALL)01/96]
A flat tire can be temporarily secured to the
floor pan under the rear-most seat. To
temporarily secure a flat tire:
[ER06900(ALL)01/96]
1. Remove the spare tire ªJº bolt, plate and
wing nut from their stowed location on the
jack.
File:10cpera.ex
Update:Thu Jun 6 14:45:00 1996

216 [ER07600(ALL)01/96]
half page art:0020270-AExtended van underbody outside spare wheel/flat tire
storage
*
[ER15100(ALL)01/96]
RWARNING
Make sure the spare tire and jacking
equipment are stowed and secured in the
proper storage location.
%*
[ER15200(ALL)03/96]
Preparing to Change the Tire
*
[ER15250(ALL)01/96]
NOTE: To lift your vehicle by other than the
front or rear jacking points, be sure to
use only hoist adapters with a wide
contact surface.
*
[ER15325(ALL)03/96]
1. Make sure that your vehicle will not move
or roll. Put the gearshift in P (Park). Set the
parking brake and block the wheel that is
diagonally opposite the tire that you are
changing.
*
[ER15335(ALL)01/96]
NOTE: Make sure the ignition is in the OFF
position.
File:10cpera.ex
Update:Thu Jun 6 14:45:00 1996

217
*
[ER15420(ALL)03/96]
When one of the back wheels is off the ground,
the transmission alone will not prevent the
vehicle from moving or slipping off the jack,
even if the vehicle is in P (Park). To prevent the
vehicle from moving when you change a tire, be
sure the parking brake is set, then block the
wheel (both directions) that is diagonally
opposite (other side and end of the vehicle) to
the tire being changed.
*
[ER15430(ALL)03/96]
RWARNING
If the vehicle slips off the jack, you or
someone else could be seriously injured.
*
[ER15550(ALL)01/96]
2. Get out the spare tire and jack.
[ER15600(ALL)01/96]
The jack, jack handle and lug nut wrench are
stowed separately on the left hand wheelhouse
inner panel on standard length models. And in
the right rear storage compartment on extended
length models.
[ER15700(ALL)01/96]
one third page art:0020285-A
Jack stowage
File:10cpera.ex
Update:Thu Jun 6 14:45:00 1996

218 [ER15750(ALL)01/96]
half page art:0020269-BAerostar extended model jack pack
*
[ER16800(ALL)01/96]
3. Use the tapered end of the lug nut wrench
to unscrew wheel ornaments attached by
retaining screws. Remove any wheel trim.
Insert the tapered end of the lug nut wrench
behind wheel covers or hubcaps and twist
off.
*
[ER16900(ALL)01/96]
4. Loosen the wheel nuts by pulling up on the
handle of the lug nut wrench about one-half
turn (counterclockwise). Do not remove the
wheel lug nuts until you raise the tire off the
ground.
[ER17000(ALL)01/96]
5. Unfold the jack handle and lock into the
jack. Use the jack handle to slide the jack
under the vehicle.
File:10cpera.ex
Update:Thu Jun 6 14:45:00 1996