MAZDA 626 1987 Workshop Manual

1 4 SLIDING SUNROOF
5 mm (0.20 in) o p Front
IP
i^ : • 1
B-B Cross section
A-A Cross section
76U14X-203
Caution:
If the stopper is moved too far forward, there
might be a malfunction or leaking. Do not
leave a gap of more than 5 mm (0.2 in) be-
tween the slide panel and roof panel.
14—90

WINDSHIELD WIPER 1 4
WINDSHIELD WIPER
STRUCTURAL VIEW
Note
The wiper arms not interchangeable.
63U14X-132
1. Wiper blade
2. Wiper arm
3. Lower molding
4. Cover
5. Wiper motor
6. Link assembly
7. Washer tank
8. Hose
9. Washer nozzle
14—91

1 4 WINDSHIELD WIPER
86U14X-168
86U14X-169
86U14X-170
REMOVAL
1. Disconnect the negative battery cable.
2. Remove the wiper arms.
3. Remove the lower molding.
4. Remove the cover.
5. Disconnect the wiper link from the motor.
Caution
Do not remove the motor arm unless neces-
sary. The motor arm position on the motor
shaft decides the automatic stop position,
(lowest position of the wiper arm)
6. Disconnect the connector.
7. Remove the wiper motor.
8. Remove the wiper link assembly mounting bolts.
9. Lift the wiper link assembly out from the left side
(driver's side) service hole.
86U14X-171
14—92

WINDSHIELD WIPER 1 4
INSTALLATION
Install in the reverse order of removal.
Note
The wiper arms are identified by marks on the
arms.
DL: driver side
PL: passenger side
76G14X-047
25 ± 5 mm
(0.98 ± 25 ± 5 mm
0.19 in) (0.98 ± 0.19 in)
ADJUSTMENT
Arm Height
Set the arm height as shown in the figure.
86U14X-173
Adjustment of washer spray
Inserting a needle or similar object into the nozzle hole
and bend to change the spray direction.
268 + 50 mm (10.6 + 1.97 in)
86U14X-174
14—93

14 REAR WINDOW WIPER
REAR WINDOW WIPER
STRUCTURAL VIEW (HATCHBACK)
76G14X-031
1. Wiper arm and blade 3. Wiper motor 5. Hose
2. Seal cap 4. Washer tank 6. Washer nozzle
14—94

REAR WINDOW WIPER 14
86U14X-176
86U14X-178
REMOVAL
1. Disconnect the negative battery cable.
2. Remove the wiper arm.
3. Open the rear hatch.
4. Remove the rear hatch trim (upper, side and lower).
5. Remove the rear hatch screen.
Note
Remove the screen carefully so that it may be
reused.
6. Disconnect the rear wiper motor connector.
7. Remove the rear wiper motor.
INSTALLATION
Install in the reverse order of removal.
86U14X-179
14—95

14 REAR WINDOW WIPER
(0.98 ±0.19 in)
ADJUSTMENT
Arm Height
Set the height as shown in the figure.
86U14X-180
o
r ^
660 mm
(25.98 in)
Adjustment of washer spray
Insert a needle or similar object into the nozzle hole
and bend to change the spray direction.
86U14X-181
14—96

HEADLIGHT WASHER 14
HEADLIGHT WASHER
REMOVAL AND INSTALLATION
1. Remove in the sequence shown in the figure.
2. Install in the reverse order of removal.
76G14X-039
1. Bracket
2. Coolant reservoir
3. Bracket
4. Washer pump
5. Washer nozzles
6. Clips
7. Hose
8. Joint
9. Washer tank
14—97

1 4 SEAT
SEAT
STRUCTURAL VIEW
76G14X-033
1. Seat side cover
2. Lifter lever
3. Reclining knuckle
4. Lumbar support lever
5. Seat adjuster
6. Front seat cushion
7. Headrest
8. Headrest pole
9. Front seat back
10. Rear seat cushion
11. Rear seat back
12. Seat side
14—98

SEAT 14
Hatchback
76G14X-038
1. Seat side cover
2. Lifter lever
3. Reclining knuckle
4. Lumber support lever
5. Seat adjuster
6. Front seat cushion
7. Headrest
8. Headrest pole
9. Front seat back
10. Rear seatbacks
(split-folding rear seat)
11. Rear seat cushion
(flat-folding rear seat)
12. Stay
14—99