MITSUBISHI SPYDER 1990 Service Repair Manual

MITSUBISHI SPYDER 1990 Service Repair Manual SPYDER 1990 MITSUBISHI MITSUBISHI https://www.carmanualsonline.info/img/19/57345/w960_57345-0.png MITSUBISHI SPYDER 1990 Service Repair Manual
Trending: height, ABS, oil change, reset, charging, wheel torque, fuel type

Page 241 of 2103

MITSUBISHI SPYDER 1990  Service Repair Manual E N G I N E   O V E R H A U L    Cylinder 
INSPECTION11390790119
Middle
Cut  away  view
of  valve  guide
measurement 
locations
Bottom
Tester  valve 
sprin
CYLINDER HEAD 
(1)  Check  the  cylinder  he

Page 242 of 2103

MITSUBISHI SPYDER 1990  Service Repair Manual 1 1  E N G I N E   O V E R H A U L    Head  and 
wrench at this instant. Multiply this reading by  This
will  give  the  spring  load  at  test  length.  Fractional  measure-
ments  are  indicated  on

Page 243 of 2103

MITSUBISHI SPYDER 1990  Service Repair Manual  (Overall)
Intake  111.49-111.99  mm  (4.389-4.499  in.) Exhaust
  mm   in.)
Stem  Diameter
Intake  5.934-5.952  mm   in.)
Exhaust
  mm   in.)
Valve  Margin
Intake  1.285-1.615  mm   in.)
Exhaust
  mm

Page 244 of 2103

MITSUBISHI SPYDER 1990  Service Repair Manual 11ENGINE  OVERHAUL   Cylinder  Head 
(6)  seat  is  properly  positioned,  the  width  of  intake
and  exhaust  seats  should  be  0.9  to  1.3  mm 
  to
  in.).
(7)  Check  valve  tip  to  spring  se

Page 245 of 2103

MITSUBISHI SPYDER 1990  Service Repair Manual ENGINE  OVERHAUL  Oil Pan,
Special  tool 
REMOVAL
(1)  Remove  flywheel  or  drive  plate: 
(2)  Remove  rear  plate.
  ‘Remove  oil  filter.
(4) Remove adapter.
  .  .
(5)  Drain  engine  oil  and

Page 246 of 2103

MITSUBISHI SPYDER 1990  Service Repair Manual 11E N G I N E   O V E R H A U L    Oil  Pan  and  Oil’ 
 Revision
0057
(1)  Apply  Loctite  51817  to  oil  pump  as  shown  in  the  figure.
Install oil-ring into the counter bore on the oil p ump

Page 247 of 2103

MITSUBISHI SPYDER 1990  Service Repair Manual E N G I N E   O V E R H A U L    Oil  ‘Pan  and  Oil  Pump
Locating
I
adapter
Locate  wrench 
at  base  of  filter
(7)Apply  Loctite  18716  or  equivalent  at  the  to 
bed  plate  parting  line.
(

Page 248 of 2103

MITSUBISHI SPYDER 1990  Service Repair Manual 11E N G I N E   O V E R H A U L    Oil  Pump
  Gasket
Sprin
Oil  pump  body
Outer
Oil  pump  cover
  PUMP 
D I S A S S E M B L Y
(1) To remove the relief valve,’ proceed as 
(a)  Remove  the  thread

Page 249 of 2103

MITSUBISHI SPYDER 1990  Service Repair Manual ENGINE  OVERHAUL 
INSPECTION
(1)  Wash  all  parts  in  a  suitable  solvent  and 
for  damage  or  wear.
(2)Mating  surface  of  the  oil  pump  should  be  smooth.  Replace
pump  cover  if  scratche

Page 250 of 2103

MITSUBISHI SPYDER 1990  Service Repair Manual 1E N G I N E  - ‘ O i l  
Feeler
Outer0rotor
G a s k e tI
(7)  Install  inner  rotor  into  pump  housing.  If  clear ance  between
inner  and  outer  rotors  exceeds  the  limit,  replace  b oth
ro
Trending: run flat, ESP inoperative, maintenance reset, headlight bulb, light, headlights, trunk