FORD MUSTANG 2003 Workshop Manual

Page 3641 of 4378

REMOVAL AND INSTALLATION
Moulding —
Roof Side
Removal and Installation 1. Remove the weatherstrip.
2. Remove the exterior roof side moulding screws.
3. Remove the interior roof side moulding screws. 4. Remove the roof side moulding screw. SECTION 501-
08: Exterior Trim and Ornamentation 2003 Mustang Workshop Manual Klj . 1 ba
32003 Mustang Workshop Manual
18. 11. 2011file:///C:/Ford/2000 - 2004/tsocache/SHEF_5108/S3B~us~en~ ...

Page 3642 of 4378

5. Release the clips.
1. Lift up to release the two clips.
2.NOTE: Grasp the roof side moulding and lift up to release the money clip.
Remove the money clip.
6. Remove the upper quarter trim panel. For additional information, refer to Section 501 - 05 .
7. Remove the nuts and the roof side moulding. Klj . 2 ba
32003 Mustang Workshop Manual
18. 11. 2011file:///C:/Ford/2000 - 2004/tsocache/SHEF_5108/S3B~us~en~ ...

Page 3643 of 4378

8. To install, reverse the removal procedure. Klj . 3 ba
32003 Mustang Workshop Manual
18. 11. 2011file:///C:/Ford/2000 - 2004/tsocache/SHEF_5108/S3B~us~en~ ...

Page 3644 of 4378

REMOVAL AND INSTALLATION
Moulding —
Rocker Panel
Removal 1. Remove the front rocker panel moulding screw.
2. Remove the strip.
3. Remove the rear rocker panel moulding screw. 4. Remove the pin - type retainers and the rocker panel moulding. SECTION 501-
08: Exterior Trim and Ornamentation 2003 Mustang Workshop Manual Klj . 1 ba
22003 Mustang Workshop Manual
18. 11. 2011file:///C:/Ford/2000 - 2004/tsocache/SHEF_5108/S3B~us~en~ ...

Page 3645 of 4378

Installation
1. To install, reverse the removal procedure. Klj . 2 ba
22003 Mustang Workshop Manual
18. 11. 2011file:///C:/Ford/2000 - 2004/tsocache/SHEF_5108/S3B~us~en~ ...

Page 3646 of 4378

REMOVAL AND INSTALLATION
Rear Spoiler
Removal and Installation
1. Open the luggage compartment lid.
2. Disconnect the high mounted stoplamp electrical connector.
3. Remove the screws and the nuts.
4. CAUTION: Use care not damge the pin- type retainers and pin-type retainer seals
during removal.
Release the spoiler from the two pin- type retainers in an upward motion.
SECTION 501-
08: Exterior Trim and Ornamentation 2003 Mustang Workshop Manual Klj . 1 ba
22003 Mustang Workshop Manual
18. 11. 2011file:///C:/Ford/2000 - 2004/tsocache/SHEF_5108/S3B~us~en~ ...

Page 3647 of 4378

5. To install, reverse the removal procedure.
zInspect the pin- type retainer seals. Install new pin- type retainer seals if damaged. Klj . 2 ba
22003 Mustang Workshop Manual
18. 11. 2011file:///C:/Ford/2000 - 2004/tsocache/SHEF_5108/S3B~us~en~ ...

Page 3648 of 4378

SPECIFICATIONS
SECTION 501-
09: Rear View Mirrors 2003 Mustang Workshop Manual Torque Specifications
Description Nm lb-
ft lb-
in Exterior rear view mirror nuts 12 9 —
Exterior rear view mirror motor screws 7 — 62 Klj . 1 ba
12003 Mustang Workshop Manual
18. 11. 2011file:///C:/Ford/2000 - 2004/tsocache/SHEF_5108/S3B~us~en~ ...

Page 3649 of 4378

DESCRIPTION AND OPERATION
Rear View Mirrors
The rear view mirror system consists of the following components:
zexterior rear view mirror
z exterior rear view mirror control
z exterior rear view mirror glass
z exterior rear view mirror motor
z interior rear view mirror
z exterior rear view mirror (Cobra) (manual folding)
SECTION 501-
09: Rear View Mirrors 2003 Mustang Workshop Manual Klj . 1 ba
12003 Mustang Workshop Manual
18. 11. 2011file:///C:/Ford/2000 - 2004/tsocache/SHEF_5108/S3B~us~en~ ...

Page 3650 of 4378

DIAGNOSIS AND TESTING
Rear View Mirrors
Refer to Wiring Diagrams Cell
124 , Power Mirrors for schematic and connector information.
Inspection and Verification 1. Verify the customer concern by operating the system.
2. Visually inspect for obvious signs of mechanical or electrical damage.
3. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
4. If the concern is not visually evident, verify the symptom and refer to the Symptom Chart.
Symptom Chart
Refer to the Wiring Diagrams for connector numbers stated in the pinpoint tests. SECTION 501-
09: Rear View Mirrors 2003 Mustang Workshop Manual Special Tool(s)
73III Automotive Meter
105-
R0057 or equivalent Flex Probe Kit
105-
R025B or equivalent
Visual Inspection Chart Mechanical Electrical
z
Exterior rear view mirrors
z Interior rear view mirror z
Central junction box (CJB) fuse 19 (15A)
z Wiring harness
z Connections
z Exterior rear view mirror control
z Exterior rear view mirror motor
SYMPTOM CHART Condition
Possible Sources Action
z The mirrors are inoperative zExterior rear view
mirror control. z
Go To Pinpoint Test A . Klj . 1 ba
82003 Mustang Workshop Manual
18. 11. 2011file:///C:/Ford/2000 - 2004/tsocache/SHEF_5108/S3B~us~en~ ...

Page:   < prev 1-10 ... 3601-3610 3611-3620 3621-3630 3631-3640 3641-3650 3651-3660 3661-3670 3671-3680 3681-3690 ... 4380 next >