torque JAGUAR XFR 2010 1.G Workshop Manual
Page 1011 of 3039
M6 (2) 11 Nm M8 (3) 25 Nm M5 nut (4) 6 Nm
Torque:
Unions 21 Nm www.JagDocs.com
Page 1012 of 3039
31.
32.
33. NOTES:
Install the bolt and unions finger tight before final tightening.
Remove and discard the blanking caps.
Torque:
Unions 21 Nm M6 11 Nm
Torque:
Unions 21 Nm
Torque:
M10 29 Nm M6 11 Nm
Page 1013 of 3039
36.
Torque:
Unions 21 Nm M6 11 Nm
Page 1014 of 3039
37.
38.
39.
40.
Torque:
Unions 21 Nm
NOTE: The high-pressure fuel pumps are removed from the illustration
for clarity.
Page 1015 of 3039
Torque: 25 Nm
Torque: 25 Nm
Torque: 55 Nm
Page 1016 of 3039
45.
46.
47.
48. Torque: 12 Nm
CAUTION: Install all the bolts finger tight before final tightening.
Torque: 25 Nm
CAUTION: Install all the bolts finger tight before final tightening.
NOTE: Tighten the bolts in the indicated sequence.
Torque: 48 Nm www.JagDocs.com
Page 1017 of 3039
49. CAUTIONS:
Install all the bolts finger tight before final tightening.
The bolts can only be used 3 times, mark the bolts with a center punch.
If 2 punch marks are visible, discard the bolts.
Install the bolts in the noted position.
NOTES:
Make sure that the crankshaft is not rotated.
Make sure the crankshaft and flexplate mating faces are clean before
installation.
Tighten the retaining bolts working diagonally.
Torque:
Stage 1:45 Nm Stage 2:90°
50. Refer to: Engine (303-01D Engine - V8 S/C 5.0L Petrol, Installation).
51. Refer to: Crankshaft Pulley (303-01D Engine - V8 S/C 5.0L Petrol, Removal and Installation).
52. Lower the vehicle.
53. Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).
Page 1021 of 3039
2. NOTE: Lubricate and install the new O-ring seals.
Torque:
M8 25 Nm M6 12 Nm
3. NOTE: Lubricate and install the new O-ring seals.
4. Torque: 12 Nm www.JagDocs.com
Page 1023 of 3039
7. CAUTION: Make sure that the tensioner spring is
correctly located.
NOTE: Tsubaki timing drive only.
Torque: 21 Nm
8. NOTE: INA timing drive only.
Install the lower timing chain making sure the coloured
chain links align correctly with the fuel rail high-pressure
fuel pumps camshaft and crankshaft sprocket markings.
Page 1024 of 3039
9. CAUTION: Make sure that the tensioner spring is
correctly located.
NOTE: INA timing drive only.
Torque: 21 Nm
10. Refer to: Oil Pan Extension (303-01C Engine - V8 5.0L Petrol, Removal and Installation).
11. Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).