JAGUAR XFR 2010 1.G Workshop Manual
Page 931 of 3039
2. Remove the special tool.
Special Tool(s): 303-1442 www.JagDocs.com
Page 932 of 3039
4. NOTE: Tighten the bolts in the indicated sequence.
Special Tool(s): JLR-303-1622 Torque: 11 Nm
Page 933 of 3039
Torque: 11 Nm
6. Refer to: Flexplate (303-01D Engine - V8 S/C 5.0L Petrol, Removal and Installation).
Page 934 of 3039
Engine - V8 S/C 5.0L Petrol - Cylinder Head LH
Removal and Installation
Removal
NOTE: Removal steps in this procedure may contain installation details. Published: 18-May-2012
1. Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).
2. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
3. Refer to: Camshaft LH (303-01D Engine - V8 S/C 5.0L Petrol, Removal and Installation).
4. Refer to: Exhaust Manifold LH (303-01C Engine - V8 5.0L Petrol, Removal and Installation).
5.
6.
Page 935 of 3039
7.
8.
9.
10. CAUTION: Discard the seal.
NOTE: Engine shown removed for clarity.
NOTE: Clamp the hose to minimize coolant loss.
Page 936 of 3039
11.
12.
13. NOTE: Clamp the hose to minimize coolant loss.
CAUTION: Discard the seals. www.JagDocs.com
Page 937 of 3039
Page 938 of 3039
17.
18. CAUTIONS:
If a new cylinder head has been installed then new
tappets must be installed.
If the cylinder head is being removed without a new
component being installed, the tappets must be installed in
their original positions.
NOTE: Left-hand shown, right-hand similar.
Page 939 of 3039
Installation 19.
1. CAUTION: An acceptable flatness of the cylinder head is
0.1mm.
Check cylinder head face for distortion, across the center
and from corner to corner.
2. WARNING: Make sure care is taken when handling the
cylinder head gasket.
CAUTIONS:
The head gasket must be installed over the cylinder
block dowels.
Make sure that the mating faces are clean and free of
foreign material.
NOTE: Install a new cylinder head gasket.
Page 940 of 3039
3. CAUTION: Make sure that new cylinder head bolts are
installed.
NOTE: Tighten the bolts in the indicated sequence.
Torque: 20 Nm
4. NOTE: Tighten the bolts in the indicated sequence.
Torque: 35 Nm