length INFINITI QX56 2011 Factory Workshop Manual

TM-234
< UNIT DISASSEMBLY AND ASSEMBLY >[7AT: RE7R01B]
TRANSMISSION ASSEMBLY
38. Remove control valve & TCM mounting bolts and clip (1) from
the control valve & TCM.
*: Reamer bolt
39. Remove the control valve & TCM (1) from transmission case.CAUTION:
When removing, never with the manual valve notch and
manual plate height. Remove it vertically.
40. Remove joint connector (1) from the control valve & TCM using a flat-bladed screwdriver (A).
41. Disconnect TCM connector (A). CAUTION:
Be careful not to damage connector.
42. Remove rear extension assembly (2WD) or adapter ca se assembly (4WD) according to the following pro-
cedures.
a. 2WD
: Front
Bolt symbol Length mm (in) Number of bolts A 43 (1.69) 3
B 40 (1.57) 2
C 54 (2.13) 6
D 50 (1.97) 2
E* 50 (1.97) 1
JPDIA1105ZZ
JSDIA1823ZZ
JSDIA1718ZZ
JSDIA1813ZZ
Revision: 2010 May2011 QX56

TRANSMISSION ASSEMBLYTM-265
< UNIT DISASSEMBLY AND ASSEMBLY > [7AT: RE7R01B]
C
EF
G H
I
J
K L
M A
B
TM
N
O P
 Make sure that input speed sen sor securely installs input
speed sensor holes (A).
 Hang down output speed sensor harness toward outside
so as not to disturb installa tion of the control valve &
TCM.
 Adjust A/T assembly harness connector of the control
valve & TCM to terminal ho le of transmission case.
 Assemble it so that manual valve cutout is engaged with manual plate projection.
64. Install bolts and clip (1) to the control valve & TCM. Tighten bolt (E) to the specified torque before tightening the other than bolts.
*: Reamer bolt
65. Connect output speed sensor connector (A).
66. Engage output speed sensor harness with terminal clips ( ).
JPDIA1106ZZ
SCIA5035E
: Front
Bolt symbol Length mm (in) Number of bolts A 43 (1.69) 3
B 40 (1.57) 2
C 54 (2.13) 6
D 50 (1.97) 2
E* 50 (1.97) 1
JPDIA1105ZZ
JPDIA1104ZZ
Revision: 2010 May2011 QX56

WW-78
< REMOVAL AND INSTALLATION >
REAR WASHER NOZZLE AND TUBE
3. Remove the screws fixing rear washer nozzle (2) to high-mounted stop lamp cover (3).
4. Disconnect the rear washer tube (1) from the rear washer noz-
zle.
INSTALLATION
Install in the reverse order of removal.
Inspection and AdjustmentINFOID:0000000006220427
INSPECTION
Washer Nozzle Inspection
Check that air can pass through the hose by blowing forward (toward
the nozzle), and check that air cannot pass through by sucking.
ADJUSTMENT
Washer Nozzle Spray Position adjustment
Adjust spray positions to match the positions shown in the figure.
Unit: mm (in)
JMLIA0943ZZ
JMLIA1131ZZ
1 : Black printed frame line
L : Length H : Height φ: Spray area
40.7 (1.60) 3.9 (0.15) 30 (1.18)
JMLIA1101ZZ
Revision: 2010 May2011 QX56